WET-DRY-BLOW VACUUMING SYSTEM

USER

GUIDE

YLW6222

2

Thank you for purchasing a Bennett Read

Tough 15 wet & dry vacuum cleaner.

While this product is compact and light for ease of use, it is packed with the power and technology to provide fast and efficient cleaning. It is manufactured to the highest standards of quality and is fully backed up by a ONE YEAR guarantee by TEVO.

Should you need any support from us, please visit: www.tevo.co.za or call 0861 77 88 88.

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS

BEFORE USING YOUR VACUUM.

When using your Tough 15 basic safety precautions should be observed, including the following:

!

WARNING

TO REDUCE THE RISK OF FIRE,

ELECTRIC SHOCK, OR INJURY:

» Use the system only for its intended use.

» To protect against a risk of electric

shock, do not immerse any part of

the system in water or other liquids.

» Do not allow cord to touch hot

surfaces.

» Do not run appliance over cord.

» Do not operate the system with a

damaged cord or plug, or if the

appliance or any other part of the

system has been dropped or

damaged. To avoid the risk of

electric shock, do not disassemble or

attempt to repair the Tough 15.

Return the unit for examination and

repair. Incorrect reassembly or

repair can cause a risk of electrical

shock or injury and will not be

covered by the guarantee.

» Keep hair, loose clothing, fingers and

all parts of body away from openings

and moving parts.

» Do not use to pick up flammable or

combustible liquids such as gasoline or

use in areas where they may be present.

» Do not pick up anything that is

burning or smoking such as

cigarettes, matches or hot ashes.

» Use extra care when cleaning on stairs.

» Do not use the Tough 15 without

the micro-particle filter in place, ,

except when vacuuming up liquids

(Refer to page 3 for operating

instructions)

When using as a Wet Vacuum take

caution not to over-fill the tank

with liquid to avoid risk of electrical

shock and damage to your Tough

10. Refer to page 3 of this manual

for tank capacity and instructions

» This appliance is intended for

household use only. Follow all user

instructions in this manual.

» Do not leave the Tough 15

plugged in when unattended.

» Unplug the electrical cord when

not in use and before servicing.

» Not intended for use by persons

(including children) with reduced

physical, sensory or mental

capabilities, or lack of experience

and knowledge.

» Do not allow to be used as a toy.

» Close attention is necessary when

used near children, pets or plants.

» Children should be supervised to

ensure that they do not play with the

appliance.

» Use only as described in this

manual. Use only manufacturer’s

recommended accessories.

» Do not pull cord, use cord as a handle,

close a door on cord, or pull cord

around sharp edges or corners.

» Turn off all controls as applicable before

unplugging from electrical outlet.

» Do not unplug by pulling on cord.

To unplug, grasp the plug, not the cord.

» Do not handle plug or vacuum with

wet hands or operate without shoes.

» Do not put any objects into openings.

» Do not use with any opening blocked.

» Keep free of dust, lint, hair and

anything else that may reduce airflow.

» Store your Tough 15 indoors in a

cool, dry area.

» Keep your work area well lit.

» Keep end of hose, wands and other

openings away from your face and body.

» Using improper voltage may result

in damage to the motor and

possible injury to the user. Correct

voltage is listed on rating label. For

operation on a 220-240V, 50/60Hz

power supply only.

» Use only identical replacement

parts.

» See instructions for Servicing of

Double-Insulated Appliances.

WARNING:

» To reduce the risk of injury from

moving parts – Unplug before

servicing.

» To reduce the risk of electric shock

– Unplug before cleaning or servicing

– Do not use outdoors

SAVE THESE INSTRUCTIONS

FOR FUTURE USE.

Not For Commercial Use.

For Household Use Only.

3

4

Product View

1. On/Off switch

2. Blower function hose port (removable cap)

3. Motor unit

4. Cord storage hook

5. Washable and reusable

micro-particle filter

6. Dirt/water tank

1

13

7. Caster wheels

8. Vacuum function hose port

9. Locking clips

10. Integrated attachment holders

11. Detachable side storage box

2

14

3

ACCESSORIES:

12. Ultra-durable flexi hose

13. Hose handle with variable

airflow control

14. Three piece extension wands

15. Combination carpet

and hard floor

vacuum head

- dry use only!

16. Wet pick-up vacuum nozzle

17. Combination crevice/upholstery tool

6

15

17

4

9

12

5

16

10

7

11

8

Assembly instructions:

Your Bennett Read Tough 15 comes almost fully assembled and requires very little set up:

1. Remove unit from packaging

2. Remove attachments from their packaging

3. Some of the packaging poses a choking risk to small children.

Dispose of the packaging responsibly. Recycle if possible

4. Before using for the first time check that all attachments listed

are included. If the unit is incomplete, return to the retailer

immediately. Take entire unit, packaging and proof of purchase

to the store where your purchase was made

5. Insert the caster wheels (7) at the bottom of the Dirt Tank (6) into the holes provided. Ensure the wheels go in all the way

6. Attach the side storage box (11) with the 4 screws provided

Operations

Only operate your Bennett Read Tough 15 in accordance with the instruction manual. Failure to follow these instructions will result in decreased cleaning performance and may invalidate your guarantee.

Dry vacuuming:

Your Bennett Read Tough 15 Vacuum is perfect for vacuuming carpets, tiles, mattresses, upholstery, curtains and car upholstery.

Setting up your Bennett Read Tough 15 for dry vacuuming:

1. Remove the motor unit (3) from the dirt tank (6) by lifting the locking clips (9) upward

2. Ensure that the micro-particle filter (5) is securely installed in place

3. Replace motor unit (3) and clip locks in place (9)

4. Insert small end (opposite end to handle) of the flexi hose (12) into vacuum function hose port (8)

5. Attach the 3 piece extension wand (14) to free end of flexi hose handle

6. Attach choice of cleaning head (15), (17) to free end of extension wand

7. Plug power cable into wall socket

8. Switch on unit using the power switch (1)

9. Vacuum in different directions across your surfaces to give you best results

After each cleaning session it is advisable that:

• The dirt tank be emptied and thoroughly rinsed and dried before storing

• The micro-particle filter is checked and cleaned if needed

This will ensure that the unit continues to deliver outstanding performance time & again

Wet Vacuuming:

Your Bennett Read Tough 15 can also suck up liquids* in and around your home…

Please note that the Bennett Read Tough 15 is NOT a carpet deep cleaner. Carpet deep cleaning should be done with specialised deep cleaners.

Setting up your Bennett Read Tough 15 for wet vacuuming:

1. Remove the motor unit (3) from the water tank (6) by lifting the locking clips (9) upward

2. Remove the micro-particle filter (5) (as explained below in the Maintenance and

Care section on the following page)

3. Replace motor unit (3) and clip locks in place (9)

4. Insert the large end of the flexi hose (12) into vacuum function hose port (8)

5. Attach 3 piece extension wand (14) to free end of the flexi hose

6. Attach wet pick-up vacuum nozzle (16) to free end of extension wand

7. Plug power cable into wall socket

8. Switch on unit using the power switch (1)

9. Vacuum wet spill / liquid from surface

10. When you are done, follow the cleaning instructions as outlined above

* Do not use to pick up boiling hot, flammable or combustible liquids

* Your Bennett Read Tough 15 is equipped with a float valve located at the bottom of the motor unit which will partially shut off the suction as soon as the tank reaches capacity. Immediately switch off the machine and empty the tank before continuing.

5

6

Blower Function:

Your Bennett Read Tough 15 has an additional function that allows you to blow away leaves and grass that collect on your covered patio areas. Simply plug in and blow the dirt away.

Setting up your Bennett Read Tough 15 to use the blower function:

1. Remove the motor unit (3) from the dirt tank (6) by lifting the locking clips (9)

upward

2. Ensure that the micro-particle filter (5) is securely installed in place

3. Replace motor unit (3) and lock clips in place (9)

4. Twist anticlockwise and pull to remove blower port cap (2)

5. Insert large end of the flexi hose (12) into Blower function hose port (removable cap) (2)

6. Attach the 3 piece extension wand (14) to free end of flexi hose (optional)

8. Plug power cable into wall socket

9. Switch on unit using the power switch (1)

Maintenance and care

Emptying the Dirt Tank:

1. Disconnect flexi hose (11) from the Motor unit by grasping and twisting the end

of the hose by the Hose Port (8) and then pulling the hose outward

2. Take unit to disposal area

3. Lift locking clips (9) to unlock dirt tank

4. Lift motor unit (3) from dirt tank and place on ground

5. Lift dirt tank and empty contents into disposal area

6. Rinse Dirt tank under running water and dry

Cleaning the Filter:

It is necessary to wash the micro-particle filter (5) weekly

• To remove the micro-particle filter, turn the motor unit (3) upside down

• Grasp the locking mechanism at the bottom of the micro-particle filter (5), twist

anticlockwise and remove

• Wash the filter in warm water. You may use a mild detergent

• Allow to dry completely before replacing the filter

• Replacement micro-particle filters are available from major retail outlets

• Reassemble and store, ready to use!

Troubleshooting

Problem

Machine not switching on

Possible causes

1. Power cord not firmly plugged in

or not switched on at wall socket

Remedies

1. Check electrical plug

Weak suction power

1. Micro-particle filter dirty or

clogged

2. Obstruction in flex hose, vacuum nozzle or extension pipes

1. Remove and clean micro-particle filter as explained on page

6. It is important to check and clean filter regularly

2. Remove flex hose, nozzle and extension pipes as explained on page 5.

Clean and check for any obstructions

Visible dust escaping from the machine while vacuuming

1. Micro-particle filter not installed

2. Micro-particle filter dirty

1. Check micro-particle filter, situated underneath the motor unit

1. Clean micro-particle filter as explained on page 6

Other maintenance or service not included in the manual should be performed by an authorized Tevo service representative.

For any questions or concerns, contact customer care listed on page 8.

Technical Specifications:

Nominal voltage: 220-240 V AC

Nominal frequency: 50/60 Hz

Power Output : 1200 - 1400W

Dirt Tank Capacity : 15 Litres

7

8

Consumer Guarantee

The Bennett Read Tough 15 has a one year product guarantee from

Tevo (Pty) Ltd. In the event of the unit malfunctioning, Tevo will replace or repair, at Tevo’s option, any faulty component, free of charge from the date of purchase by the original purchaser for one year, any defective or malfunctioning part due to manufacturing defect. This guarantee applies to product used for personal or domestic use only, and specifically excludes any malfunction or defect arising from commercial use. This guarantee does not apply to routine maintenance components such as filters and brushes.

Damage or malfunction caused by negligence, abuse, unauthorized repair, or use not in accordance with the User Guide is not covered.

Tevo is not liable for incidental or consequential damages of any nature associated with the use of this product. Tevo’s liability will not exceed the purchase price of this product.

Guarantee and Service enquiries can be made by contacting:

Tevo (Pty) Ltd

Gauteng 086 111 8386

Durban (031) 570 5900

Cape Town (021) 380 0038/9

Customer Service Help Line 0861 77 88 88 www.tevo.co.za