Boca Flasher SBL-MIX Installation Manual
Boca SBL-MIX is a powerful instrument developed for large-coverage illumination. This line voltage fixture eliminates the need for secondary transformers, making installation contractor friendly. The housing is anodized aluminum with a durable finish making it weather and abrasion resistant. The SBL-MIX is UL Listed for dry, damp, or wet location (model dependent).
Some possible use cases for the Boca SBL-MIX include:
- Architectural lighting
- Landscape lighting
- Stage lighting
- Event lighting
- Commercial lighting
Advertisement
Advertisement
Installation Manual
SBL-MIX
WARNING: DO NOT LIFT FIXTURE BY CABLES.
This could result in permanent damage to both the fixture and the cables. Damage resulting from grasping cables and/ or putting undue pressure on the cable connections will not be covered under the warranty!
DO NOT ATTEMPT TO INSTALL OR USE THE SBL-MIX FIXTURE WITHOUT READING THE INSTALLATION
INSTRUCTIONS AND SAFETY LABELS COMPLETELY.
Failure to adhere to these instructions could result in serious injury or property damage.
DO NOT MODIFY, ALTER OR ATTEMPT TO SERVICE THE SBL-MIX. DOING SO WILL VOID THE WARRANTY.
Installation Instructions
SBL-MIX
High Power DMX Controlled Washer
Introduction:
The Boca SBL-MIX is a powerful instrument developed for large-coverage illumination. This line voltage* fixture eliminates the need for secondary transformers, making installation contractor friendly. The housing is anodized aluminum with a durable finish making it weather and abrasion resistant. The SBL-MIX is UL Listed for dry, damp, or wet location (model dependent).
Maintenance:
CleanIng Dry and Damp (IP65) Rated Fixtures:
Use a soft cloth, clean surface with mild soap and water.
Wet (IP68) Rated Fixtures:
To clean surface use a soft cloth with mild soap and water.
STORAGE Store in a dry, well-ventilated area when product is not in use.
Keep the electrical cord away from heated surfaces when in use or not in use.
If cord shows signs of damage do not use, return product to manufacturer.
Electrical Specifications:
Input Voltage: 90-120VAC OR 230-277VAC (See layout drawings for spec.)
1. Total linear ft per 20A breaker: 19 ft.
2. Total linear ft per 15A breaker: 14 ft.
3. Input Current: 810mA RMS per linear foot.
Fixtures must be installed by a qualified and licensed electrician in accordance with all national, state and local electrical codes and regulations.
If any part of this manual does not meet the necessary codes and regulations, contact the factory for more information before attempting to install.
IP65
DAMP LISTING
IP68
WET LISTING
Model Dependent
Max temp: 55C
Min. temp: -40C
Turn Power Off At Circuit Breaker Before Beginning Installation!
DO NOT LIFT FIXTURE BY CABLES!
INCLUDED IN ThIS PACkAGE:
1 SBl-MIX (solid color) Fixture
(In lengths shown on job specific drawings)
2
Mounting Brackets
(2 brackets per fixture)
3 Job Specific Drawings
SBL-MIX
DMX In
DMX Out
Power Feed
PAGE 2 OF 5
Installation Instructions
SBL-MIX
1. INSTALL SWIvEL BRACkET INTO SUBSTRATE
1a Use four screws (not provided by Boca Flasher) to secure the brackets to the substrate.
1b
Loosen center hinge pin and adjust angle of fixture to focus required. Tighten pin to hold the focus.
* SBL-Mix Fixtures will ship with swivel mounting brackets attached to fixture.
(Two swivels per fixture) Clips are installed opposite side of fixture cables to allow maximum swivel ability.
Screw Information:
1.
Screws not provided by Boca Flasher.
2.
Boca Flasher recommends wide washer flat head
Phil l ips #8 screw, not to exceed .418” diameter.
3.
Length of screw will vary depending on mounting surface.
4.
For outdoor installations, installer should use a screw with weatherproof coating.
5.
One foot fixtures only require one hinge bracket.
2. ARRANGE FIXTURES IN ORDER NECESSARY
2a Rotate fixture to see bottom and note each label.
▶
2b
Cross-reference with job specific drawing.
▶
▶
BF-01
◀
Labels on fixtures correspond with nomenclatures on drawings.
▶
▶ SBL-MIX
PAGE 3 OF 5
Installation Instructions
SBL-MIX
3. CONNECT FIXTURES TOGEThER
(AS SHOWn On JOb SPECIFIC DRAWInGS
3a Connect DMX IN on a fixture with DMX out separate fixture.
3b Push together until you hear a “Click”.
DMX Out
DMX Out
DMX In
DMX Out
Power Feed
click!
◀
▶
4. CONNECT FIXTURES TO POWER
SInGlE Run InStAllAtIOn
DMX In
DMX In note:
More than one connection can be made in each connection box.
* Add tape to twist locks.
Place thumb over tape at starting point and PULL around connector area until tape overlaps itself.
PAGE 4 OF 5
* ADD Tape where arrows indicate
For weather-tight applications only
See additional instructions for weather-tight tape
Installation Instructions
SBL-MIX
IMPORTANT SAFETY REMINDERS:
1.
Danger:
To reduce the risk of electric shock, always unplug the SBL-M IX from electrical outlet before cleaning. Cut breaker if outlet is not available.
2.
to reduce the risk of burns, fire, electric shock or injury to persons:
• Use the SBL-MIX only for its intended use as described in these instructions.
• Do not use attachments not recommended by Boca Flasher.
• Never operate the SBL-M IX if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water.
• If the seal appears to be damaged/broken/torn return the SBL-MIX to a service center for examination or repair.
• Keep cord away from heated surfaces.
• Never drop or insert any object into any opening.
• Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
3.
WarnIng:
Do not attempt to install or use the SBL-MIX without reading the installation instructions and safety labels. Failure to adhere to these instructions could result in serious injury or property damage.
4.
Do not modify, alter or attempt to service the SBl-MIX:
Doing so will void the warranty.
5.
Do not use sharp tools near or on the fixture lens:
Doing so will result in property damage and void the warranty. boca Flasher, Inc.
508 S. Military trail n Deerfield beach, Florida n 33442 uSA
Phone: 561-989-5338 n Fax: 561-982-8323 www.bocaflasher.com
We are constantly improving our fixtures and reserve the right to change options and specifications. Additional information & details at www.bocaflasher.com. For specific requirements, contact your Boca Flasher sales representative. Boca Flasher, Inc. 508
S. Military Trail, Deerfield Beach, Florida 33442 USA Phone: 561.989.5338 Fax: 561.982.8323 © 2017 Boca Flasher, Inc. All rights reserved. All names and trademarks are property of their respective owners. REV 07-2017
IP65
DAMP LISTING
IP68
WET LISTING

Public link updated
The public link to your chat has been updated.
Advertisement