advertisement
▼
Scroll to page 2
of 4
*44487312* M400 Series TJ Locks 44487312 Electromagnetic Locks for Inswinging Doors M420TJ, M422TJ, M450TJ, M452TJ, M490TJ, M492TJ Installation Instructions LL These instructions cover only the mounting of the lock(s) using TJ brackets. Before proceeding with installation, see main electromagnetic lock instructions for the following information: • Electrical Specifications • Reorienting the Magnet • ATS and MBS Indicator Installation • Connecting Wiring to Board 1 Place template and prepare holes. Single a. Place template on top corner, opposite of hinges. b. Mark holes and prepare them per template. Shown from Interior Template Double a. Place template on top centerline of doors. b. Mark holes and prepare them per template. Shown from Interior Template 2 Reorient the magnet(s) • SINGLE LOCKS: The magnet may need to be reoriented before installation, depending on the handing of your door. • DOUBLE LOCKS: The magnet in one of the locks must be reoriented before installation. • See the instructions that came with your lock(s) for information about magnet orientation. 3 Attach frame L-Bracket. Single Double Inside Inside Actual Size Reinforced Metal 4 Attach mounting bracket(s). a. Place template on gate and post surfaces as marked on template. b. Mark holes and prepare them per template. Single Double Actual Size 2 Sheet Metal 5 Double lock ONLY: Install join block. 5a Remove wiring covers and end blocks. 6 5b Install join block. Install magnet(s). 6a SINGLE AND DOUBLE LOCKS: Slide magnet onto bracket. 6b DOUBLE LOCK ONLY: Slide second magnet onto bracket. Join block slides into first magnet housing. Inside 7 Secure magnet(s). 7a Single lock. 7b Double lock Actual Size 3 8 Assemble armature 8a Attach armature to top L-Bracket. 8c Attach bottom L-Bracket to door. Top L-Bracket WARNING The included sex nut is for 1C\v” (45 mm) doors ONLY. For other door thicknesses, please contact customer service, 1-877-671-7011. Using the incorrect sex nut for your door thickness will lead to improper function and possible injury. Actual Size Armature Holder Armature bolt must be tightened to at least 120 in.-lbs. for all doors except composite wood doors. For composite wood doors, tighten only to tight and flush. 120 in.-lbs. may damage composite wood doors. DO NOT back off bolt after tightening! Backing off the bolt after tightening will loosen the thread-locking patch, which may allow the bolt to loosen over time. 8b Attach armature plate to armature holder. LL Use bolt that came with lock. WARNING Actual Size Use bolt from TJ kit. M490 armature must be disassembled to replace armature bolt. Flat Washer Star Locking Washer Cone Washer Actual Size Armature Bolt Actual Size Armature Plate Top L-Bracket Inside 9 Actual Size Attach and adjust armature. 9a Attach armature assembly to bottom L-Bracket Actual Size Actual Size 9b Adjust armature a. b. c. d. Close door. Press armature to fully engage with magnet. Fully tighten two screws and set screw to lock position. If double, repeat adjustment process on second door. Press armature to magnet Inside Two (2) screws Customer Service 1-877-671-7011 www.allegion.com/us © Allegion 2015 Printed in U.S.A. 44487312 Rev. 11/15-d
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project