Lionel WR Case Cut O-Gauge Set - 1997 Owner's Manual
Lionel WR Case Cut O-Gauge Set - 1997 is a toy electric train set designed for children eight years of age and older. It includes a 4-6-2 Pacific engine & tender, diecast depressed flatcar, woodside caboose, Case Cutlery knife w/ case, controller, 40-watt power pack, lockon, straight track, curved track, smoke fluid, and a service center list. The train set is ready-to-run out of the box, and the track can be assembled in a variety of layouts to create different play scenarios.
Advertisement
Advertisement
72-1781-250
IN
ST
RU
CTION S
H
EE
T
W. R. CASE CUTready-to-run O-Gauge set
CAUTION—ELECTRIC TOY
NOT RECOMMENDED FOR CHILDREN UNDER EIGHT YEARS
OF AGE. AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS
SHOULD BE OBSERVED DURING HANDLING AND USE TO
REDUCE THE RISK OF ELECTRIC SHOCK.
TRANSFORMER RATINGS —INPUT:120 VAC;60 HZ ONLY.
AC OUTPUT:20 V;54 VA
Congratulations!
ou’re now the proud owner of the Y
W. R. Case Cutlery ready-to-run
“O”-Gauge train set. Everything you need to get started is included. You’re already off to a great start by reading this instruction manual. It has important information on train setup and operation.This booklet also covers proper maintenance procedures to help your
Lionel trains live long, healthy lives.
If you have any questions after reading this booklet, contact your nearest Lionel Authorized Service
Center using the list included in a separate flier in this set or call Lionel
Service at 810-949-4100. And have fun!
Table of contents
Track layout
Getting started
Suggested track layouts
Joining the track sections
Attaching the lockon to the track
Controller operations
Stripping the wire
Attaching the controller wires to the lockon
Controller functions
Controller and short circuits
Installing the Lionel No. 610-5606-001 sound activation button 7
5
6
4
4
3
3
2
2
Train operation
Reverse unit procedure
(See Instruction Sheet Packed Separately with Engine & Tender)
Coupling
Installing the knife and case on your depressed flatcar
8
8
Maintaining and servicing your set
See Instruction Sheet Packed Separately with Engine & Tender
Limited Warranty/Lionel Service 9
Track layout
Getting started
efore you do anything else, we B recommend you check the contents of your set box to ensure all of the parts of your set have been included and that the quantities are correct.
• 4-6-2 Pacific engine & tender 1
• Diecast depressed flatcar 1
• Woodside caboose
• Case Cutlery knife w/ case
1
1
• Controller
• 40-watt power pack
1
1
The parts list below will tell you what’s included and the correct quantities. If you find any discrepancies, contact the dealer you purchased your set from for more information or
• Lockon
• Straight track
• Curved track 8
• Smoke fluid(packed w/ engine) 1
• Service Center list
1
8
1
Now comes the fun part—deciding what kind of layout you want.
The only rule—let your imagination be your guide.
Suggested track layouts
Here are some examples of layouts you can build with track included with your train set.
Remember—the more track you own, the more variations you can create in your train layout. And that means more action and more fun!
Track layout
Joining the track sections
J oin the track sections together by inserting the pins of one track section into the rail openings of another. For good electrical contact, pins must be carefully inserted and track joints tightly fitted.
If the track is difficult to connect, try this installation tip. You can “break in” “O”-
Gauge track sections by inserting and withdrawing a track pin into one rail at a time before joining the entire track section.
If the openings become too open
(causing the track to fit loosely), pinch
Attaching the lockon to the track
the rail together around a track pin with a pair of pliers. If any pins fall out of the track and are missing, replace them with extras available from your Lionel dealer.
Maintenance tip: The rails should be kept clean, dry, and free from oil and grease.
Clean rust and dirt spots with a track eraser. Wipe the track using a cloth dampened with track cleaner from the Lionel maintenance kit
(no. 6-62927), available from your nearest Lionel Authorized Value
Added Dealer or Lionel Service. he lockon connects power from T your controller to the track.
Attaching the lockon to the track is quick and easy.
LIO
CTC
LOCKO
NEL
First, place the lockon on onto the edge of an outside rail. Press the lockon upward so that the spring contact snaps onto the center rail. The lockon should face outward when under any straight section of track.
Fit the center lip of the lock-
1
2
N setting up your track and make sure it is firmly connected. Use the illustrations below as a step-by-step guide.
1
Hook lip to the outside of the rail
2
Snap spring contact to the middle rail
Once the lockon is securely attached to the track, it’s time to insert the wires from the controller into the two spring clips on the lockon. See page 5 for easy-to-follow steps.
Controller operations
Stripping the wire
nce your track is assembled is
O and the lockon securely attached, you can connect the wires from the controller to the lockon.
First you‘ll want to check the ends of the wires to make sure that the insulation is stripped back about 1 ⁄
4
" to
3 ⁄
8
". To strip the wires, use a pair of wire strippers or a sharp knife.
Caution: Only an adult should perform this task! Always use
Attaching the controller wires to the lockon
ow you’ll need to insert a controller N wire into each of the two spring clips on the lockon.
It’s easy! Depress the spring clip with your finger and insert the bare end of the wire into the exposed opening.
Release the spring clip. Give the wire a little tug to make sure it’s secure. Repeat these steps with the other spring clip.
Next, insert the small plug end of the power pack into the back of your controller, and plug the other end into a standard outlet.
Note!
If the whistle fails to operate when you press the whistle button on your controller (see page 6), remove the wires from the lockon and reinsert each one into the opposite clip to reverse polarity. For both whistle & bell operation you will need to install the Lionel no. 610-
5906-001 sound activation button (available seperately). See page 8 for installation instructions.
Plug power pack into standard wall outlet
Make sure that the bare end of each wire is securely attached to the spring clip.
R
OF
F
FULL
SPEED
Plug this end into back of controller.
Controller operations
Controller functions
s you turn the throttle control knob A to the right, power to the track is increased. When the indicator reaches the green band, there should be sufficient power to operate the locomotive.
The further into the green area the knob is turned, the faster your train will go.
Remember that the greater the load on the engine (adding more cars for the engine to pull, for example), the farther into the green the knob must be turned before it will operate the locomotive.
The yellow band indicates the average power range that the train will be operating in. The red band represents maximum power output.
Press this button to produce a realistic whistle sound.
Press this button to go forward or reverse, or to place the locomotive in
“neutral” (no movement, headlight is on).
Turn the throttle control knob to the right for more power.
R
The LED indicator shows when your controller is O N .
Green band
Yellow band
Red band
OFF FULL
SPEED
Controller operations
Controller and short circuits
our Lionel power pack is listed by Y
Underwriters Laboratories Inc. and has been carefully designed and tested to ensure peak performance. The controller is equipped with a built-in electronic circuit breaker that alternately cuts off and restores the flow of power to the track whenever a short circuit exists—for example, when the train derails. The circuit breaker’s action continues until the cause of the short circuit is eliminated. This circuit breaker is incorporated into the controller to protect it from possible damage. It will not protect the locomotive or electrically operated accessories, so it’s important to eliminate short circuits as soon as possible.
Note!
The power pack must be unplugged from the wall socket when a short circuit is noticed, and the short circuit must be corrected.
A short circuit is caused by a direct connection between the center rail and one of the outside rails or by a direct connection between bare wires. The axles of a derailed car or locomotive are the most frequent cause of short circuits, so make sure that all wheels are properly set on the rails. Some other causes of short circuits might be staples, nails, paper clips, or other metallic objects lying across the rails, or two bare wires touching each other.
If too many cars or accessories are used, your controller will exceed its power limit and begin to cycle on and off. To correct this problem, cars or accessories must be removed before normal operation can resume. For more power, see the line of Lionel high-output transformers at your Authorized
Lionel Value Added Dealer.
The same condition can occur if the power is turned up too quickly. This also could cause your train to move too fast and derail.
After your power pack has been operating for a while, you will find it warm to the touch. It is the nature of all electrical power equipment to become warm when in use. If your controller is loaded to capacity, it is a good idea to let it cool down after an hour or two of continuous use. Unplug the power pack from the wall when the controller is not in use.
Train operation
Installing the Lionel No. 610-590-6001 sound activation button
o operate both the whistle and T bell sounds when operating your steam locomotive with your controller, you will need to install the
Lionel No.
610-5906-001 sound activation button (available separately). Connect the button as shown below.
No. 610-5906-001
Sound Activation Button
No. 1
Red
Black
White striped wire
No. 2
LED Power Indicator
Train operation
Coupling
fter you have assembled the track, A place the locomotive and rolling stock on the track. Before coupling the cars, make sure the wheels are properly set on the rails.
When coupling your cars, at least one of the mating couplers must be open as shown below at the left. Now simply push the cars toward each other until they lock together.
Now you’re ready to pull out of the station. All aboard!
Push down the lock release to open the coupler.
Keep in mind that it’s easier to couple cars on a straight stretch of track.
Installing the knife & case on your depressed flatcar
imply place the knife case in the center of you flatcar and away you go.
S
Your depressed flatcar with knife & case installed will not go under a girder bridge. Check all your tunnels and overhangs to make sure there is enough clearance.
Limited Warranty/Lionel Service
his Lionel product including all mechaniT cal and electrical components, moving parts, motors and structural components, except for light bulbs, is warranted to the original consumer-purchaser, for 1 year against original defects in materials or workmanship when purchased through an authorized Lionel merchant.
This warranty does NOT cover normal wear and tear, light bulbs, defects appearing in the course of commercial use, or damage resulting from abuse or misuse of the product by the purchaser. Transfer of this product by the original consumer-purchaser to another person voids this warranty. Modification of this product voids this warranty.
Any warranted product which is defective in original materials or workmanship and is delivered by the original consumer-purchaser to
Lionel L.L.C. or an authorized Lionel L.L.C.
service center, together with proof of original purchase, will at the option of Lionel L.L.C. be repaired or replaced, without charge for parts or labor. In the event the defective product cannot be repaired, and a replacement is not available, a refund of the original purchase price will be granted. Any products on which warranty service is sought must be sent freight or postage prepaid, as transportation and shipping charges are not covered by the warranty.
IN NO EVENT SHALL LIONEL L.L.C. BE
LIABLE FOR INCIDENTAL OR CONSEQUEN-
TIAL DAMAGES.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion may not apply to you.
This limited warranty gives you specific legal rights, and you may have other rights which vary from state to state.
INSTRUCTIONS FOR OBTAINING SERVICE
If service for this Lionel L.L.C. product is required, bring the item, along with your dated sales receipt and completed warranty information to the nearest Authorized Lionel Service
Center. Your nearest Lionel Service Center can be found by calling 1-800-4-Lionel, or by contacting our Website @ www.Lionel.com
If you prefer to send it back to Lionel L.L.C.
for factory repair, you must first call 810-949-
4100 or FAX 810-949-5429 or write to Customer
Service, P.O. Box 748 New Baltimore, MI 48047-
0748 stating what the item is, when it was purchased and what seems to be the problem. You will be sent a return authorization letter and label to assure your merchandise will be properly handled upon receipt.
Once you have received your return authorization and label, make sure that the item is packed to prevent damage during shipping and handling. We suggest that you use the products original packaging. This shipment must be prepaid and we recommend that it be insured.
Please make sure you have followed all of the above instructions carefully before returning any merchandise for service.
You may choose to have your product repaired by one of our Authorized Lionel Service Centers after its warranty has expired. A reasonable service fee will be charged.
WARRANTY INFORMATION
Please complete the information below and keep it, along with your dated sales receipt. You must present this and your dated sales receipt when requesting warranty service.
NAME___________________________________
ADDRESS________________________________
PLACE OF PURCHASE____________________
DATE OF PURCHASE _____________________
PRODUCT NUMBER _____________________
PRODUCT DESCRIPTION
_________________________________________
© 1997 L
IONEL
LLC, C
HESTERFIELD
MI 48051-2493
U
NITED
S
TATES OF
A
MERICA

Public link updated
The public link to your chat has been updated.
Advertisement