Lionel Santa Fe Shell Tank Car 0-27 Train Set - 3/01 Owner's Manual
Lionel Santa Fe Shell Tank Car 0-27 Train Set - 3/01 provides hours of entertainment with realistic features that make playing with your toy trains like operating real ones. With an easy-to-use controller, you can control the train's speed and direction, as well as activate the train's whistle or bell sounds. The set includes 4-6-4 locomotive, tender with air whistle, 3 single dome shell tank cars, square window caboose, 40-watt power pack, lockon, and curved and straight track sections for creating your own unique track layout.
Advertisement
Advertisement
73-1909-250
3/01
Santa Fe Shell Tank Car
Ready-To-Run O-27 Set
Owner’s Manual
CAUTION—ELECTRIC TOY
NOT RECOMMENDED FOR CHILDREN UNDER EIGHT YEARS OF AGE. AS WITH
ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING
HANDLING AND USE TO REDUCE THE RISK OF ELECTRIC SHOCK.
TRANSFORMER RATINGS —INPUT: 120 VAC; 60 HZ ONLY.
AC OUTPUT: 20 V; 54 VA
Congratulations!
Y ou’re now the proud owner of the
Pennsylvania Coal Mine ready-to-run
O-27 train set. Everything you need to get started is included. You’re already off to a great start by reading this instruction manual. It has important information on train setup and operation. This booklet also covers proper maintenance procedures to help your Lionel trains live long, healthy lives.
If you have any questions after reading this booklet, contact your nearest Lionel
Authorized Service Center using the list included in a separate flier in this set or call
Lionel Service at 810-949-4100. And have fun!
Table of contents
Track layout
Getting started
Joining the track sections
Suggested track layouts
Attaching the lockon to the track
Controller operations
Stripping the wire
Attaching the controller wires to the lockon
Controller functions
Controller and short circuits
Installing the Lionel Sound Activation Switch
Train operation, maintenance and service:
(See Instruction Sheet 72-1951-250 provided with engine)
Lionel Service
4
4
3
3
6
7
5
5
8
8
2
Track layout
Getting started
B efore you do anything else, we recommend you check the contents of your set box to ensure all of the parts of your set have been included and that the quantities
(when applicable) are correct.
The parts list below will tell you what’s
• 4-6-4 Locomotive
• Tender w/Air Whistle
• Controller
• Single Dome Shell Tank Car
• 40-watt power pack
• Lockon
• Square Window Caboose
1
1
1
1
3
1
1 included and the correct quantities. If you find any discrepancies, contact the dealer you purchased your set from for more information or call 1-800-4-LIONEL for a service center near you.
• Smoke Fluid
• Straight track
• Curved track
• Service Center list
• Railroader Club application
• Warranty Card
8
1
1
8
1
1
Now comes the fun part—deciding what kind of layout you want. The only rule— let your imagination be your guide.
Joining the track sections
J oin the track sections together by inserting the pins of one track section into the rail openings of another.
For good electrical contact, pins must be carefully inserted and track joints tightly fitted.
If the track is difficult to connect, try this installation tip. You can “break in” O-27 track sections by inserting and withdrawing a track pin into one rail at a time before joining the entire track section.
If the openings become too open (causing the track to fit loosely), pinch the rail together around a track pin with a pair of pliers. If any pins fall out of the track and are missing, replace them with extras available from your
Lionel dealer.
Maintenance tip: The rails should be kept clean, dry, and free from oil and grease. Clean rust and dirt spots with a track eraser. Wipe the track using a cloth dampened with track cleaner from the Lionel maintenance kit
(no. 6-62927), available from your nearest
Lionel Authorized Value Added Dealer or
Lionel Service.
3
Track layout
Suggested track layouts
Here are some examples of layouts you can build with 8 straight and 8 curved sections of track.
Remember—the more track you own, the more variations you can create in your train layout.
And that means more action and more fun!
Note!
We recommend that you do not set-up your track layout on carpeted surfaces.
Carpet fibers may collect on your engine’s wheels and drive gears, and prevent your engine from operating properly. For best results, place track on a hard surface.
Attaching the lockon to the track
T he lockon connects power from your controller to the track. Attaching the lockon to the track is quick and easy.
First, place the lockon under any straight section of track. Fit the center lip of the lockon onto the edge of an outside rail. Press the
1
2
LIONEL
CTC
LOCKON lockon upward so that the spring contact snaps onto the center rail. The lockon should face outward when setting up your track and make sure it is firmly connected.
Use the illustrations below as a step-bystep guide.
Once the lockon is securely attached to the track, it’s time to insert the wires from the controller into the two spring clips on the lockon. See page 5 for easyto-follow steps.
2
Snap spring contact to the middle rail
1
Hook lip to the outside of the rail
4
Controller operations
Stripping the wire
O nce your track is assembled and the lockon is securely attached, you can connect the wires from the controller to the lockon.
First you’ll want to check the ends of the wires to make sure that the insulation is stripped back about 1⁄4˝ to 3⁄8˝. To strip the wires, use a pair of wire strippers or a sharp knife.
Caution: Only an adult should perform this task! Always use care when stripping wires.
Attaching the controller wires to the lockon
N ow you’ll need to insert a controller wire into each of the two spring clips on the lockon.
It’s easy! Depress the spring clip with your finger and insert the bare end of the wire into the exposed opening. Release the spring clip. Give the wire a little tug to make sure it’s secure. Repeat these steps with the other spring clip. Next, insert the small plug end of the power pack into the back of your controller, and plug the other end into a standard outlet.
Note!
If the whistle fails to operate when you press the whistle button on your controller (see page 6), remove the wires from the lockon and reinsert each one into the opposite clip to reverse polarity.
Plug power pack into standard wall outlet
Make sure that the bare end of each wire is securely attached to the spring clip.
5
R
OFF
FULL
SPEED
Plug this end into back of controller.
Controller operations
Controller functions
A s you turn the throttle control knob to the right, power to the track is increased. When the indicator reaches the green band, there should be sufficient power to operate the locomotive. The further into the green area the knob is turned, the faster your train will go. Remember that the greater the load on the engine (adding more cars for the engine to pull, for example), the farther into the green the knob must be turned before it will operate the locomotive.
The yellow band indicates the average power range that the train will be operating in. The red band represents maximum power output.
Press this button to produce a realistic whistle or bell sound. To stop the bell ringing, simply press the button again.
(See page 8.)
OFF
Press this button to go forward or reverse, or to
FULL
SPEED
“neutral” (no movement, headlight is on).
FULL
SPEED
Turn the throttle control knob to the right for more power.
R
The LED indicator shows when your controller is ON.
OFF
Green band
FULL
SPEED
Yellow band
OFF
Red band
6
FULL
SPEED
Controller operations
Controller and short circuits
Y our Lionel power pack is listed by
Underwriters Laboratories Inc. and has been carefully designed and tested to ensure peak performance. The controller is equipped with a built-in electronic circuit breaker that alternately cuts off and restores the flow of power to the track whenever a short circuit exists—for example, when the train derails. The circuit breaker’s action continues until the cause of the short circuit is eliminated. This circuit breaker is incorporated into the controller to protect it from possible damage. It will not protect the locomotive or electrically operated accessories, so it’s important to eliminate short circuits as soon as possible.
Note!
The power pack must be unplugged from the wall socket when a short circuit is noticed, and the short circuit must be corrected.
A short circuit is caused by a direct connection between the center rail and one of the outside rails or by a direct connection between bare wires. The axles of a derailed car or locomotive are the most frequent cause of short circuits, so make sure that all wheels are properly set on the rails. Some other causes of short circuits might be staples, nails, paper clips, or other metallic objects lying across the rails, or two bare wires touching each other.
If too many cars or accessories are used, your controller will exceed its power limit and begin to cycle on and off. To correct this problem, cars or accessories must be removed before normal operation can resume. For more power, see the line of
Lionel high-output transformers at your
Authorized Lionel Value Added Dealer.
The same condition can occur if the power is turned up too quickly. This also could cause your train to move too fast and derail.
After your power pack has been operating for a while, you will find it warm to the touch. It is the nature of all electrical power equipment to become warm when in use. If your controller is loaded to capacity, it is a good idea to let it cool down after an hour or two of continuous use. Unplug the power pack from the wall when the controller is not in use.
7
Limited Warranty/Lionel Service
T his Lionel product, including all mechanical and electrical components, moving parts, motors and structural components, except for light bulbs, is warranted to the original consumer-purchaser, for one year against original defects in materials or workmanship when purchased through an authorized Lionel dealer.
This warranty does NOT cover normal wear and tear, light bulbs, defects appearing in the course of commercial use, or damage resulting from abuse or misuse of the product by the purchaser. Transfer of this product by the original consumer-purchaser to another person voids this warranty. Modification of this product voids this warranty.
Any warranted product which is defective in original materials or workmanship and is delivered by the original consumer-purchaser to
Lionel L.L.C. or an authorized Lionel L.L.C. Service
Station, together with proof of original purchase will, at the option of Lionel L.L.C., be repaired or replaced, without charge for parts or labor. In the event the defective product cannot be repaired, and a replacement is not available, a refund of the original purchase price will be granted. Any products on which warranty service is sought must be sent freight or postage prepaid, as transportation and shipping charges are not covered by the warranty.
In no event shall Lionel L.L.C. be liable for incidental or consequential damages.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion may not apply to you.
This limited warranty gives you specific legal rights, and you may have other rights which vary from state to state.
Instructions for Obtaining Service
If service for this Lionel L.L.C. product is required, bring the item, along with your dated sales receipt and completed warranty information to the nearest Authorized Lionel Service Station.
Your nearest Lionel Service Station can be found by calling 1-800-4-Lionel, or by accessing our
Website at www.lionel.com.
If you prefer to send your product back to
Lionel L.L.C. for factory repair, you must first call
810-949-4100 or FAX 810-949-5429, or write to
Customer Service, P.O. Box 748, New Baltimore,
MI 48047-0748, stating what the item is, when it was purchased and what seems to be the problem.
You will be sent a return authorization letter and label to ensure your merchandise will be properly handled upon receipt.
Once you have received your return authorization and label, make sure that the item is packed to prevent damage during shipping and handling. We suggest that you use the product’s original packaging. This shipment must be prepaid and we recommend that it be insured.
Please make sure you have followed all of the above instructions carefully before returning any merchandise for service.
Warranty Information
Please complete the information below and keep it, along with your dated sales receipt. You must present this and your dated sales receipt when requesting warranty service.
Name ____________________________
Address ____________________________
Place of Purchase ____________________
Date of Purchase ____________________
Product Number ______________________
Product Description____________________
_________________________________
©2001 L
IONEL
LLC, C
HESTERFIELD
, MI 48051-1956
U
NITED
S
TATES OF
A
MERICA

Public link updated
The public link to your chat has been updated.
Advertisement