Mocka Porta Assembly Instructions Manual

Add to my manuals
8 Pages

advertisement

Mocka Porta Assembly Instructions Manual | Manualzz

Mocka Porta Cot

Assembly Instructions

Thank you for your purchase.

Please follow the instructions below for correct assembly.

Safety Warnings

WARNING: Be aware of the risk of open fire and other sources of strong heat such as electric bar fires, gas fires, etc. in the near vicinity of the cot.

WARNING: Do not use the cot if any part is broken, torn or missing and use only parts approved by the manufacturer.

WARNING: Do not leave anything in the cot or place the cot close to another product, which could provide a foothold or present a danger of suffocation or strangulation, e.g. strings, blinds/curtain cords, etc.

WARNING: Do not use more than one mattress in the cot.

WARNING: Keep medication and small items that a child could choke on, away from the cot.

WARNING: Folding cots with padded rims should not be used if the coverings have been damaged or bitten through.

The cot is ready for use only when the locking mechanisms are engaged.

Check that the locking mechanisms are fully engaged before cot is used.

To prevent injury from falling, discontinue using the Porta Cot if your child is able to climb out.

Never leave your child unattended in the Porta Cot, especially when they are not sleeping.

The Porta Cot is suitable for children from birth (maximum weight 15kg).

The thickness of the mattress chosen should be such that the internal height

(surface of the mattress to the upper edge of the cot frame) is at least 500mm in the lowest position of the cot base and at least 200mm in the highest position of the cot base.

Please note the marking inside the cot for mattress information.

The mattress should be no more than 30mm shorter or narrower that the internal length or width of the cot. mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558

IMPORTANT

BEFORE ASSEMBLING THIS COT READ AND UNDERSTAND THE

INSTRUCTIONS.

Instructions for checking that the assembly of the folding cot is correct and safe.

Instruction for the safe operation of the folding cot and accessories with any precautions required to prevent injury.

Do not use mattress other than the one supplied by the manufacturer.

Incorrect mattress can cause death.

Use only accessories as recommended by the manufacturers.

Ensure the top rails and base are fully locked.

Ensure all fastening devices are secured, tightened and maintained.

Stop using this cot if any part of the cot is broken, torn or missing.

Keep children away when assembling/disassembling the cot.

Keep the folding cot clear of trailing cables and hanging cords.

KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE

REFERENCE.

WARNING

•USE ONLY THE MATTRESS SUPPLIED BY THE MANUFACTURER, INCORRECT

MATTRESSES CAN CAUSE DEATH.

•USE ONLY ACCESSORIES AS RECOMMENDED BY THE SUPPLIER.

•ENSURE THE TOP RAILS AND BASE ARE FULLY LOCKED.

•DO NOT USE THIS COT IF ANY PART OF THE COT IS BROKEN, TORN OR MISSING.

1

Mocka Porta Cot

Assembly Instructions

Parts

1x Carry Bag

1x Porta Cot

1x Sleeping Mat (wrapped around) mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558

2

Parts

1x Carry Bag

1x Porta Cot

1x Sleeping Mat (wrapped around)

Mocka Porta Cot

Assembly Instructions

1 2

Unzip the Carry Bag and remove the frame and Sleeping Mat.

Place the cot in a vertical position and open the Velcro fasteners to remove the Sleeping Mat.

mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558

With the feet on the floor, pull the feet apart so they are approximately

60cm / 24” apart.

Lift the short sides of the cot upwards until they lock into position.

Keep the centre of the base raised when locking or unlocking the sides.

3

Mocka Porta Cot

Assembly Instructions

3 4

Lift the long sides of the cot upwards until they lock into position.

Check that all four sides have engaged correctly by pressing down at their centres.

If you have difficulty locking sides, lift the centre of the base a little higher and try again.

mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558

Push the centre of the bed base downwards until it audibly locks into place.

4

3 4 5

Lift the long sides of the cot upwards until they lock into position.

Check that all four sides have engaged correctly by pressing down at their centres.

If you have difficulty locking sides, lift the centre of the base a little higher and try again.

Push the centre of the bed base downwards until it audibly locks into place.

Now place the Sleeping Mat in the travel cot with the padded side up.

Align the Velcro pads on the Sleeping Mat and the base and press down to ensure they are fixed.

Maintenance

To avoid risk of injury, please check and maintain the

Porta Cot periodically and regularly check that the cot does not have any missing or broken parts.

The Porta Cot, fabric parts can be wiped clean using warm water 10°C - 40°C.

The Carry Bag can be wiped clean using warm water

10°C - 40°C.

Do not bleach.

5

5

Mocka Porta Cot

Folding Away

6 7

To pack away, first remove the Sleeping Mat, then pull the lifting handle in the centre of the base and pull up the base.

The base must remain lifted in order to release the top rails.

mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558

The top rails must now be disengaged.

6

6 7

To pack away, first remove the Sleeping Mat, then pull the lifting handle in the centre of the base and pull up the base.

The base must remain lifted in order to release the top rails.

The top rails must now be disengaged.

Mocka Porta Cot

Folding Away

8

A

B

9

To do this, find the fasteners in the centre of the long sides and squeeze together as shown in fig 8A and 8B.

Repeat with the short sides.

Check that all sides have disengaged properly and pull up the centre of the base.

If you have difficulty unlocking the sides, lift the centre of the base a little higher and try again.

7 mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558

Mocka Porta Cot

Assembly Instructions

10 11

With the upper parts now in position, push the four feet of the Porta Cot together.

Wrap the Sleeping Mat around the Porta Cot tightly and fasten the

Velcro through the tabs and secure.

Pull the Carry Bag over the Porta Cot and close with the zip fastener.

8 mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement