VC3000

Smart Robotic Vacuum Cleaner

EASY START GUIDE

PACKAGE CONTENTS

VC3000 Docking Station Power Adapter Virtual Wall

Remote Control Trailing Bar Cleaning Brush (2) Side Brush

HEPA Filter (2) Mops Suction Inlet

REMINDERS FOR FIRST USE

1.

2.

3.

4.

5.

6.

7.

Before using, check if the power voltage of your Aztech VC3000 corresponds correctly to your home’s power supply.

Position the Aztech VC3000 on a smooth, heat resistant, and stable ground.

Ensure to correctly insert the required batteries of the Aztech VC3000, its virtual wall (2 AA) and remote control (2 AAA), while observing the correct polarity of the batteries to be inserted.

In using the remote control, ensure that you are at least 4 meters away from the vacuum cleaner and that the remote control is properly aimed at the vacuum cleaner’s sensor.

Ensure that there are no obstacles and/or uneven surfaces 2 meters in front and 0.5 meters on both sides of the Docking Station.

The Virtual Wall will allow you to limit the cleaning areas of your Aztech

VC3000. Always ensure that its front and sides are free from any kind of blockage and/or obstructions that may hinder its functionality.

Should damages be found in the appliance, do not use the appliance and immediately bring it to the Aztech Service Center.

Please retain this easY start GUiDe for fUtUre Use.

4 - STEP AUTOMATIC CLEANING

STEP 1

Position the docking station on a smooth and stable ground and connect the Docking

Station’s power adapter to its DC jack and plug it to a power outlet.

NOTE : Ensure to keep both of the docking station’s front (2 meters) and sides (0.5meters) free from obstacles and/or blockages.

STEP 2

Switch ON the Aztech VC3000 and lodge it into the Docking Station to begin charging the Aztech VC3000.

NOTE: For first use/reuse (after a long period of rest), charge the Aztech VC3000’s battery for at least 16 hours.

STEP 3

Correctly insert the needed batteries of the remote control (2 x AAA) and the Virtual

Wall (2 x AA) and position the Virtual Wall on the preferred location where you want to limit the Aztech VC3000’s movement.

**OBSERVE BATTERY POLARITY

CONTROL

PANEL

REMOTE

CONTROL

STEP 4

On the Aztech VC3000’s control panel or on its remote control, press the AUTO button to begin automatic cleaning. The Aztech

VC3000 would automatically return to its docking station to charge itself once it runs out of batteries.

Please retain this easY start GUiDe for fUtUre Use.