www.collegehillshonda.com

Accessory Application

INSTALLATION

INSTRUCTIONS

XM ® SATELLITE RADIO

SYSTEM

2008 ODYSSEY

PARTS LIST

XM Radio Attachment (sold separately):

P/N 08B15-SHJ-100A

2 Tuner brackets

XM Antenna (sold separately):

P/N: 08A15-0J1-100

Antenna

Publications No.

All 38163

Issue Date

OCT 2007

Bus cable

14 Wire ties

Unit kit (sold separately):

P/N 08A15-3J1-000

XM Tuner

4 Washer-screws, 5 x 8 mm

4 Washer-bolts, 6 x 12 mm

3 EPT seals

TOOL AND SUPPLIES REQUIRED

#2 Phillips screwdriver

Flat-tip screwdriver

Tape measure

Shop towel

Ratchet

8 mm, 10 mm Socket

Isopropyl alcohol

© 2007 American Honda Motor Co., Inc. - All Rights Reserved.

AII 38163 (0710) 08B15-SHJ-1A00-91

1 of 8

ANTENNA

CABLE www.collegehillshonda.com

Illustration of the XM Satellite Radio System

Installed on the Vehicle

ANTENNA

INSTALLATION

Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”

1. Make sure you have the anti-theft code for the radio, then write down the radio station presets.

2. Disconnect the negative cable from the battery.

3.

Open the sunglass holder, and remove the two 5 mm bolts. Insert a flat-tip screwdriver between the lens and roof console housing, and gently pry out the map light lens covers. Remove the two ground bolts. Pull out the roof console from the headliner.

HEADLINER

BUS CABLE

XM

TUNER

6402020B

VEHICLE

CONNECTOR

VEHICLE 14-PIN

CONNECTOR

ANTENNA

CABLE

ANTENNA

SUNGLASS

HOLDER

ROOF

CONSOLE

BUS CABLE

XM TUNER

6402010B

4

RETAINING

TABS

4 RETAINING

TABS

LEFT MAP

LIGHT LENS

COVER

2 BOLTS,

5 x 8 mm

RIGHT MAP

LIGHT LENS

2 GROUND

BOLTS

COVER

4713010B

4. Disconnect the two vehicle connectors and remove the roof console.

2 of 8

AII 38163 (0710) © 2007 American Honda Motor Co., Inc. - All Rights Reserved.

www.collegehillshonda.com

5.

Remove the cover from the left sunvisor.

10. Remove the driver’s instrument side panel (six clips and three retaining tabs).

SUNVISOR

HOLDER

6 CLIPS

VEHICLE

CONNECTOR

COVER

RETAINING

TABS

LEFT SUNVISOR

4301191B PHILLIPS SCREW

6.

Remove the two Phillips screws, pull out the left sunvisor, disconnect the vehicle connector, and remove the left sunvisor.

7. Repeat steps 5 and 6 to remove the right sunvisor.

8. Remove the right and left sunvisor holders. Turn the holders 90°, then pull it out.

9. Remove the door opening trim from around the left front “A” pillar trim. Remove the left front “A” pillar (two clips).

INSTRUMENT

SIDE PANEL

INSTRUMENT

SIDE PANEL

SHOP TOWEL

FLAT-TIP

SCREWDRIVER

4301202B

11. Remove the left front door sill trim (three clips).

LEFT FRONT

DOOR SILL TRIM

3 CLIPS

CLIP

DOOR

OPENING

TRIM

CLIP

© 2007 American Honda Motor Co., Inc. - All Rights Reserved.

LEFT FRONT

A PILLAR

TRIM

4310013B

AII 38163 (0710)

4301210B

3 of 8

www.collegehillshonda.com

12. Pull out the door opening trim at the left kick panel. Remove the left kick panel (three clips).

Installing the Antenna

14. Using scissors, cut three EPT sealers in half.

Attach the six pieces of cut EPT sealers around the antenna cable at the locations shown.

3 CLIPS

DOOR OPENING

TRIM

EPT SEALER

(Cut in half.)

LEFT KICK

PANEL

4301221B

13. Remove the driver’s seat rear rail cover (four clips).

DRIVER’S SEAT

80 mm

80 mm

80 mm

80 mm

80 mm

80 mm

ANTENNA

CABLE

ANTENNA

4310021B

15. Using isopropyl alcohol, clean the areas where the antenna will attach. Remove the adhesive backing from the antenna and attach the antenna to the front window at the locations shown. Install the antenna by applying sufficient pressure.

CLIP

DRIVER’S

SEAT REAR

RAIL COVER

5 mm

FRONT WINDOW

30 mm

6619170Y

CLIP

ADHESIVE

BACKING

CLIP

ANTENNA

RIGHT FRONT

PILLAR TRIM

4520011B

4 of 8

AII 38163 (0710) © 2007 American Honda Motor Co., Inc. - All Rights Reserved.

www.collegehillshonda.com

16. Route the antenna cable so that it routes inside the headliner.

18. Route the antenna cable along the left front “A” pillar. Secure the antenna cable to the vehicle harness with four wire ties.

ANTENNA CABLE

ANTENNA

CABLE

HEADLINER VEHICLE

BRACKET

LEFT FRONT

“A” PILLAR

VEHICLE

HARNESS

ANTENNA

CABLE

ANTENNA

WIRE TIE

4520021B

17. Route the antenna cable along the headliner and secure it with wire ties to the vehicle harness.

HEADLINER

4310062B

19. Route the antenna cable along the vehicle harness towards the driver’s under-dash fuse box. Secure the antenna cable with one wire tie in the area shown.

WIRE TIE

VEHICLE

HARNESS

ANTENNA

CABLE

WIRE TIE

ANTENNA

CABLE

VEHICLE

HARNESS

ANTENNA

CABLE

VEHICLE

BRACKET

4310052B

© 2007 American Honda Motor Co., Inc. - All Rights Reserved.

FUSE BOX

BOLT

4310072B

20. Remove the bottom bolt from the driver’s underdash fuse box.

AII 38163 (0710)

5 of 8

www.collegehillshonda.com

21. Pull up the carpet. Route the antenna cable under the carpet and next to the vehicle harness.

VEHICLE

HARNESS

(Pull up the carpet.)

Routing the Bus Cable

23. Under the dash, locate the vehicle 14-pin connector blue-taped to the vehicle harness.

Remove the blue-tape to free the connector.

VEHICLE 14-PIN

CONNECTOR

BLUE TAPE

ANTENNA

CABLE

ANTENNA

CABLE

22. Pull up the carpet and continue routing the antenna cable underneath the driver's seat.

DRIVER’S

SEAT

(Pull up the carpet.)

4310081B

ANTENNA

CABLE

BUS

CABLE

14-PIN

CONNECTOR

BUS

CABLE

6402041B

24. Plug one end of the bus cable into the 14-pin connector to the vehicle 14-pin connector you just freed, and route the bus cable along the antenna cable.

25. Route the bus cable along the antenna cable underneath the driver seat. Secure the antenna cable and bus cable to the vehicle harness at the carpet opening with one wire tie.

(Turn up the floor carpet.)

DRIVER’S

SEAT

Turn up the floor carpet.

4311011B

6 of 8

WIRE TIE

AII 38163 (0710)

VEHICLE

HARNESS

ANTENNA

CABLE

BUS

CABLE

6402030B

© 2007 American Honda Motor Co., Inc. - All Rights Reserved.

www.collegehillshonda.com

26. Secure the bus cable and the antenna cable to the vehicle harness with three wire ties in the area shown.

Installing the XM Tuner

29. Attach the tuner brackets to the XM tuner with four 5 x 8 mm washer-screws.

FLOOR CARPET

(Turn it up. )

VEHICLE

HARNESS

DRIVER’S

SEAT

TUNER

BRACKET

5 x 8 mm

WASHER-

SCREW

ANTENNA

WIRE TIE

BUS CABLE

6402060B

14-PIN

CONNECTOR

LOCATION XM

TUNER

ANTENNA CONNECTOR

LOCATION

5 x 8 mm

WASHER-

SCREW

6402071B

27. Bundle up the excess length of antenna cable, and secure the cable to bus cable with two wire ties.

30. Install the XM tuner assembly to the bottom of the driver’s seat with four 6 x 12 mm washer-bolts.

VEHICLE

BRACKET

DRIVER’S SEAT

VEHICLE

HARNESS WIRE

TIE

WIRE

TIE

ANTENNA

CABLE

BUS

CABLE

VEHICLE

HARNESS

WIRE TIE

6402051B

28. Secure the antenna cable and the bus cable to the vehicle harness with two wire ties, and reinstall the driver’s under-dash fuse box bolt.

6 x 12 mm

WASHER-BOLT

6 x 12 mm

WASHER-BOLT 6402081B

7 of 8

© 2007 American Honda Motor Co., Inc. - All Rights Reserved.

AII 38163 (0710)

www.collegehillshonda.com

31. Plug the bus cable 14-pin connector and antenna cable 1-pin connector into the XM tuner.

ANTENNA

CABLE 1-PIN

CONNECTOR

XM TUNER

BUS CABLE 14-PIN

CONNECTOR

WIRE

TIE

BUS

CABLE

ANTENNA

CABLE

VEHICLE

PIPE

6402091B

32. Secure the bus cable and antenna cable to the vehicle pipe with a wire tie.

33. Check that all wire harnesses are routed properly and all connectors are plugged in.

34. Reconnect the negative cable to the battery.

35. Enter the customer’s radio anti-theft code, and reset the radio stations.

36. Reset the clock.

37. Reinstall all removed parts.

NOTE: Whenever the battery is disconnected, the driver’s AUTO function is disabled.

38. Start the engine. Push down on the driver’s window switch until the window is fully open.

39. Pull up on the driver’s window switch to close the window completely, then hold the switch for 2 second or more.

40. Test the AUTO window function.

8 of 8

AII 38163 (0710) © 2007 American Honda Motor Co., Inc. - All Rights Reserved.