CLEANING
Water contains lime which remains on the surface after the water has evaporated. These lime deposits can be prevented from forming by wiping immediately after use.
To clean the chrome-plated surface use a soft cloth, soap and warm water. Never use cleaning agents that contain a corrosive acid or a scouring additive.
Do not use any sharp objects to clean nozzles
RERE EXPOSURE RAIL SHOWER
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min:150kPa
Max: 500kPa
Optimum: 150kPa - 500kPa
Operating Temperature:
Hot: Max 80°C
Cold: Min 5°C
* Regional specific regulations apply.
Please refer to your warranty statement at www.methven.com
Methven warrants this product against manufacturing defects and that it is suitable for use under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com/au or call Customer Service
Australia
1300 638 483
97-9301 DEC2012
1.
Showerhead
Curved Rail Section
Inlet Adapter
2.
WATER INLET: RECOMMENDED MINIMUM HEIGHT OF
1800mm FROM FLOOR LEVEL
Min 10mm
3.
Inlet Adapter
4.
Inlet Adapter
Handset
Diverter Body
Slider/Handset
Holder
Soap Dish
Wall Bracket
Wall Plug
Max
○ 25mm
Wall Bracket
Hose
5.
Bottom Bracket
Fixing Boss
Stainless Steel
Screw
Install a ½" male threaded connection at the recommended height on wall, ensuring that a minimum of 10mm of thread protrudes past the finished wall.
6.
Apply thread tape (or similar) to the ½" connection, then screw the top rail connector to the connection.
Screw the bottom rail connector to a wall stud or use wall plug making sure it is vertically in line with the top rail connector.
7.
8.
Curved rail section
Tip: This is also the best opportunity to change the handset holder side if required.
Loosen the slider off the rail and replace in on the alternate side.
Slider/Handset
Holder
Diverter Body
If the soap dish (supplied) is required then simply remove the bottom bracket fixing boss by undoing the brass screw on the back and sliding it off the rail. Slide soap dish on to rail.
Replace the bottom bracket fixing boss and retighten the brass screw in the back.
Bottom Bracket
Fixing Boss
Check the grub screws are wound out. Push the rail brackets onto the top and bottom rail connectors until they are against wall. Secure with grub screws.
Top end main rail
Now take the curved section of the rail and slide this on to the brass fitting on the top end of the main rail section. Position square and central and lock into place using the hex key provided in the grub screw on the back of the main rail section.
Take the showerhead ensuring that the rubber washer is in place in the inlet and screw this on to the end of the curved rail.
Make sure a washer is in both ends of the hose.
Screw hose onto lower outlet on wet rail, attach handset and place firmly in holder. Tilt and rotate head to the desired position.