9) CHECK DOGGING OPERATION (PANIC APPLICATION ONLY)
A) DEPRESS CROSSBAR, INSERT AND TURN DOGGING KEY IN BOTH THE ACTIVE AND INACTIVE
HEADS.
B) REMOVE DOGGING KEY, CROSSBAR SHOULD REMAIN DEPRESSED.
C) REINSERT DOGGING KEY AND TURN IN OPPOSITE DIRECTION. CROSSBAR WILL “POP OUT”.
D) FOR CYLINDER DOGGING, REFER TO D-4085.
10) CHECK FOR SMOOTH OPERATION AND SECURE LATCH BOLT ENGAGEMENT.
*D-1010*
D-1010
Exit Devices
XX-M Series
Mortise
Installation Instructions
Customer Service
1-877-671-7011 www.allegion.com/us
© Allegion 2014
Printed in U.S.A.
D-1010 Rev. 06/14-d
THE CENTER OF THIS BOOK.
3) CHOOSE CORRECT DRILLING TEMPLATE FROM THE CENTER OF THIS BOOK. FOR SEXBOLT INSTALLATIONS,
DRILL 3/8” DIAMETER HOLES ON TRIM SIDE OF DOOR ONLY. (SEE DIAGRAM BELOW)
6)
NOTE:
THIS PRODUCT IS FACTORY HANDED. IF YOU HAVE RECEIVED
THE WRONG HANDING, A REPLACEMENT MUST BE ORDERED.
