Advertisement
Advertisement
*941031-00*
941031-00
Removable Mullion, for Cutouts on Inside Face of Door, See Directions in Device Carton
5654
Note: Use lock washers on top and bottom mullion fittings except for counter sunk screws.
1.
Line up bottom mullion fitting with center of door opening and flush with closed doors (Figure 1 or 2) and install.
2.
Line up top mullion fitting with center of door opening and flush with closed doors as shown in Figure 3 and install.
See Figures 6, 7, and 8 on reverse side for optional frame conditions.
3.
Cut mullion body to length as shown in Figure 4.
4.
Insert mullion in top fitting and slide bottom of mullion into place in bottom fitting (see Figure 9 on reverse side).
5.
Secure bottom set screw.
6.
Raise top mullion clamp over top mullion fitting and secure with mounting screws (see Figure 9 on reverse side).
7.
Apply stabilizer block to door as shown in Figure 5.
8.
Adjust strikes for 1/32” clearance between latchbolt and strike (see
Figure 9 on reverse side).
F-Flat sill fitting shown
Figure 1
CL
Door opening
Threshold must be cut to fit around the flat sill fitting
Figure 2
CL Door opening
Mullion seat
3/4”
2 3/8”
3/4”
1 1/8”
2 1/4”
3 1/2”
Figure 3
5/8”
CL
Door opening
Device
CL
5 13/16”
Cut off top end of mullion body so length is
1/16” less than this dimension
Figure 4
Customer Service
1-877-671-7011 www.allegion.com/us
17/32”
5/8”
5/16” Ref.
Figure 5
29/32”
Installation Instructions
1/16”
© Allegion 2014
Printed in U.S.A.
941031-00 Rev. 01/14-c
For narrow transoms
Reinforcement
1 1/4”
7/8”
1/4-20 x 5/8”
P.P.H.M.S.
For stops wider than 3 1/2”
Figure 6
NOTE
Reinforcement for all sheet metal frames is to be supplied by frame mfg.
Reinforcement
Angle plate
1/4-20 x 5/8”
P.P.H.M.S.
Figure 8
For stops wider than 3 1/2”
Reinforcement
15/16”
Filler block is to be supplied by frame mfg. for conditions similar to this
1/4-20 x 1 1/2” P.P.H.M.S.
Figure 7
The use of this screw is optional depending on frame conditions
15/16”
1 1/2”
2 1/2” 7/8”
Adj. Angle Plate
Top clamp
Slide clamp over top end of mullion and lift mullion into top anchor
5/8”
1 1/4”
1/4”
(2 required)
All standard rim devices
264 Strike
(2 required)
All standard rim devices
Drop bottom end into place
Bottom set screw
5/16-18 anchors
Figure 9

Public link updated
The public link to your chat has been updated.
Advertisement