Von Duprin 5754 Installation instructions
Advertisement
Advertisement
*941034-00*
941034-00
Removable Mullion
5754
29/32”
Note: Use lock washers on top and bottom mullion fittings except for counter sunk screws.
1.
Line up bottom mullion fitting with center of door opening and flush with closed doors (Figure 1 or 2) and install.
CL
Door opening
3/4”
17/32”
F-Flat sill fitting shown
2.
Line up top mullion fitting with center of door opening and flush with closed doors as shown in Figure 3 and install.
See Figures 6, 7, and 8 on reverse side for optional frame conditions.
2 3/8”
3/4” 1 1/8”
5/8”
CL
Door opening
3.
Cut mullion body to length as shown in Figure 4.
4.
Insert mullion in top fitting and slide bottom of mullion into place in bottom fitting (see Figure 9 on reverse side).
5.
Secure bottom set screw.
6.
Raise top mullion clamp over top mullion fitting and secure with mounting screws (see Figure 9 on reverse side).
7.
Apply stabilizer block to door as shown in Figure 5.
8.
Adjust strikes for 1/32” clearance between latchbolt and strike (see
Figure 9 on reverse side).
Figure 1
Threshold must be cut to fit around the flat sill fitting
CL
Door opening
Mullion seat
2 1/4”
3 1/2”
Figure 3
Cut off top end of mullion body so length is
1/16” less than this dimension
Figure 2
Figure 4
For cutouts on inside face of door, see directions in device carton
Device
CL
5 13/16”
Customer Service
1-877-671-7011 www.allegion.com/us
5/8”
5/16” Ref.
Figure 5
Installation Instructions
1/16”
© Allegion 2014
Printed in U.S.A.
941034-00 Rev. 01/14-b
1 1/4”
Reinforcement
7/8”
1/4-20 x 5/8”
P.P.H.M.S.
For stops wider than 3 1/2”
Figure 6
NOTE
Reinforcement for all sheet metal frames is to be supplied by frame mfg.
For narrow transoms
Reinforcement
Angle plate
1/4-20 x 5/8”
P.P.H.M.S.
Figure 8
For stops wider than 3 1/2”
Reinforcement
15/16” 15/16”
Filler block is to be supplied by frame mfg. for conditions similar to this
1/4-20 x 1 1/2” P.P.H.M.S.
Figure 7
The use of this screw is optional depending on frame conditions
2 1/2”
1 1/2”
7/8”
Adj. Angle Plate
Top clamp
Slide clamp over top end of mullion and lift mullion into top anchor
5/8”
1 1/4”
1/4”
Bottom set screw
5/16-18 anchors
Figure 9
1408 Strike
Drop bottom end into place

Public link updated
The public link to your chat has been updated.
Advertisement