Owner’s Manual & Safety Instructions
Save This Manual
Keep this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number).
Keep this manual and the receipt in a safe and dry place for future reference. 21b
Visit our website at: http://www.harborfreight.com
Email our technical support at: [email protected]
When unpacking, make sure that the product is intact and undamaged. If any parts are missing or broken, please call 1-888-866-5797 as soon as possible.
Copyright © 2020 by Harbor Freight Tools ® . All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein.
Tools required for assembly and service may not be included.
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
table of contents
Safety ......................................................... 2
Specifications ............................................. 4
Setup .......................................................... 4
Operation .................................................... 4
Maintenance ............................................... 5
Parts List and Diagram ............................... 6
Warranty ..................................................... 7
WarninG SyMBOLS anD DEFinitiOnS
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
Addresses practices not related to personal injury.
instructions pertaining to a risk of Fire, Electric Shock, or injury to persons
iMpOrtant SaFEty inStructiOnS
When using an electrical appliance, basic precautions should always be followed, including the following: rEaD aLL inStructiOnS BEFOrE uSinG appLiancE to reduce the risk of fire, electric shock, or injury:
1. Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing.
2. Do not expose to rain. Store indoors.
3. Do not allow to be used as a toy. Close attention is necessary when used by or near children.
4. Use only as described in the manual. Use only manufacturer’s recommended attachments.
5. Do not use with damaged cord or plug.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center.
6. Do not pull or carry appliance by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
7. Do not unplug appliance by pulling on cord.
To unplug, grasp the plug, not the cord.
Page 2
8. Do not handle plug or appliance with wet hands.
9. Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.
10. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
11. Turn off all controls before unplugging.
12. Use extra care when cleaning on stairs.
13. Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.
14. Connect appliance to a properly grounded outlet only.
15. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
For technical questions, please call 1-888-866-5797.
Item 57194
16. To reduce the risk of health hazards from vapors or dusts, do not vacuum toxic materials unless a HEPA filter is used. Do not use or store near hazardous materials. Wood dust mixtures are highly flammable and can be explosive.
17. Do not introduce sparks or sources of ignition into the product.
18. Do not leave wood dust in a building or vehicle.
Keep fire extinguishers handy at all times.
19. Can be used for collecting non-flammable liquids.
Dispose of waste in a FIRE SAFE AREA.
20. Stay alert, watch what you are doing and use common sense when operating an appliance.
Do not use an appliance while you are tired or under the influence of drugs, alcohol or medication.
A moment of inattention while operating appliances may result in serious personal injury.
21. Maintain labels and nameplates on the appliance. These carry important safety information. If unreadable or missing, contact
Harbor Freight Tools for a replacement.
22. People with pacemakers should consult their physician(s) before use. Electromagnetic fields in close proximity to heart pacemaker could cause pacemaker interference or pacemaker failure.
23. The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur.
It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
SaVE tHESE inStructiOnS
Item 57194 For technical questions, please call 1-888-866-5797.
Page 3
Specifications
Hose Size
Setup - Before use:
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn: turn the power Switch of the appliance off and unplug the appliance from its electrical outlet before performing any procedure in this section.
note: For additional information regarding the parts listed in the following pages, refer to the Parts List near the end of this manual.
1. Carefully inspect the condition of the Dust
Separator parts before use. Check for damaged parts. Do not use and replace any damaged part.
2. Use only identical replacement parts. Use of any other part will void warranty.
3. Use the right part for the job. Do not modify the Dust Separator or use its parts for a purpose for which they were not intended.
4. Do not place the Hose in walkways or in any trafficked location. Set up the Dust
Separator in a location where people or vehicles will not trip or run over the hose.
5. Keep hose away from sharp objects and excessive heat.
Operation
installation
1. Use Screws and Washers to attach
Separator Base to Bucket Lid.
2. Turn Bucket Lid over and use Nuts to secure Base to Lid.
Operating instructions
1. Attach the Collection Hose to the side port and use Hose Clamp to tighten.
2. Attach vacuum hose (sold separately) to the top first, then attach vacuum hose to Reducer.
3. Ensure Bucket Lid is completely sealed onto bucket. Any air leaks will affect performance.
3. If the hose and Reducer are too tight to connect, use boiling water or a hair dryer to heat and reconnect.
4. Power the vacuum on.
Page 4 For technical questions, please call 1-888-866-5797.
Item 57194
user-Maintenance and Storage
procedures not specifically explained in this manual must be performed only by a qualified technician.
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn: turn the power Switch of the appliance off and unplug the appliance from its electrical outlet before performing any procedure in this section.
tO prEVEnt SEriOuS inJury FrOM appLiancE FaiLurE:
Do not use damaged equipment. if abnormal noise or vibration occurs, have the problem corrected before further use.
cautiOn!
after installation, check the condition of accessory parts during use. if any damage is seen, stop immediately and replace part before continuing use.
cleaning, Maintenance, and Lubrication
1. BEFOrE EacH uSE, inspect the general condition of the appliance. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may affect its safe operation.
2. aFtEr uSE, wipe external surfaces of the appliance with clean cloth. Store in an indoor dry area out of reach of children.
3. DaiLy: With a soft brush, cloth, or vacuum, remove debris from the Dust Collector. If necessary, a mild detergent may be used.
pLEaSE rEaD tHE FOLLOWinG carEFuLLy
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS
QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Item 57194 For technical questions, please call 1-888-866-5797.
Page 5
parts List and Diagram part
1 Hose Clamp
Description
2 Collection Hose
3 5-Gallon Bucket Lid
4 Flat Washer (not shown)
Qty
2
1
1
4
part
5 Reducer
Description
6 Cyclone Dust Separator
7 Screw (not shown)
8 Nut (not shown)
Qty
1
1
4
4
2
6
1
3
5
Page 6 For technical questions, please call 1-888-866-5797.
Item 57194
Limited 90 Day Warranty
Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase. This warranty does not apply to damage due directly or indirectly, to misuse, abuse, negligence or accidents, repairs or alterations outside our facilities, criminal activity, improper installation, normal wear and tear, or to lack of maintenance. We shall in no event be liable for death, injuries to persons or property, or for incidental, contingent, special or consequential damages arising from the use of our product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation of exclusion may not apply to you. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER
WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS.
To take advantage of this warranty, the product or part must be returned to us with transportation charges prepaid. Proof of purchase date and an explanation of the complaint must accompany the merchandise.
If our inspection verifies the defect, we will either repair or replace the product at our election or we may elect to refund the purchase price if we cannot readily and quickly provide you with a replacement. We will return repaired products at our expense, but if we determine there is no defect, or that the defect resulted from causes not within the scope of our warranty, then you must bear the cost of returning the product.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
record product’s Serial number Here: note: If product has no serial number, record month and year of purchase instead.
note: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. Specify UPC 792363571944 when ordering parts.
Item 57194 For technical questions, please call 1-888-866-5797.
Page 7
26541 agoura road • calabasas, ca 91302 • 1-888-866-5797
