Fleck 5600SXT Upflow water softener Service manual

Below you will find brief information for water softener 5600SXT Upflow. The Fleck 5600SXT Upflow is a water softener that uses a metered-based system to determine when to regenerate. The system uses a bypass valve to allow for the unit to be taken out of service for maintenance or repairs. The 5600SXT Upflow offers a variety of features to customize your water softening needs.

PDF Download
Document
Fleck 5600SXT Upflow Service Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Metered-based regeneration
  • Bypass valve
  • Day-of-week control
  • Time-clock control
  • Master Programming Mode
  • User Programming Mode
  • Diagnostic Programming Mode

Frequently asked questions

A minimum of 20 pounds (1.4 bar) of water pressure is required for the regeneration valve to operate effectively.

Do not use granulated or rock salt. Use salt specifically designed for water softeners.

Press and hold the Extra Cycle button for 5 seconds. The timer will advance to Regeneration Cycle Step #1 (rapid rinse), and begin programmed time count down. Follow the instructions in the manual regeneration section to complete the cycle.
Preparing document for printing…
0%