Item No.8801
Radio Control Full Function
Battery Operated
Scale 1:64
Before operating your toy, please read this manual carefully, and keep this instruction manual for future reference as it contains important information.
FEATURES:
Have fun racing your City Racer for up to 6 minutes on just a 2 minute charge.
Reaches speeds of 200 feet a minute with a transmitter control range of 20 feet.
Controls Overview
Antenna
Signal Indicator
Transmitter
Forward
Reverse
Charging Indicator
Left turn
Right turn
Preparation
Slide the transmitter's battery compartment cover towards the direction shown to open it.
Insert 2 x "AA" batteries with the correct polarity, then replace the battery compartment cover.
MADE IN CHINA
Directional guide
ON/OFF
Insert and tighten the antenna on the transmitter as illustrated.
Charger The City Racer
Signal Indicator
Charging Indicator
Open the charger cove as illustrated and take out the charging plug.
Charging Plug
Insert the charging plug to the charging jack on the bottom of the Racer.
Make sure the car's ON/OFF switch is set to OFF, otherwise the car will not charge !
The charging indicator lights up to indicate charging is in progress.
Charge for about 2 minutes. The Racer is fully charged when the charging indicator goes out. Play time is about 6 minutes.
Operation
1. Extend the transmitter's antenna for better signal reception.
Move the ON/OFF switch on the Racer to ON,
and place it on the ground.
ON/OFF SWITCH
2. The transmitter is full- function:
(1) The signal indicator lights up when any button on the
transmitter is pressed.
(2) The Racer runs forward and lights up its headlights
when the transmitter's forward button is pressed. The
Racer reverses when the transmitter's reverse button is
pressed.
(3) Pressing the left/right button on the transmitter while the
Racer is running forward or in reverse, the Racer will
make a left/right turn.
Signal Indicator
Forward
Reverse
Left turn
Right turn
3.
If the Racer veers too much to the left (L) or right (R),
adjust the Directional Control toward the opposite direction.
This will help the wheels align and your Racer to run more straight.
Directional Control
BATTERY WARNING
• Do not mix battery types.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel cadmium) batteries.
• Do not mix old & new batteries.
• The supply terminals are not to be short-circuited.
• Batteries are to be inserted with the correct polarity.
• Non-rechargeable batteries are not to be recharged.
• Remove batteries when not in use.
• Recycle or dispose of exhausted batteries according to federal, state or local Iaws.
SAFETY PRECAUTIONS
• Adult supervision is recommended at all times.
• Do not operate during thunderstorms or rain.
• Avoid water, sand and snow when operating your vehicle.
• Do not submerge vehicle or transmitter in water.
• Never operate your vehicle on the street or highway.
• Do not use your vehicle near transmitter with the same frequency.
• Avoid high-impact collisions with people and objects.
• Keep this Instruction Manual for future reference as it contains important information.
FCC INFORMATION
Warning: Changes or modifications to this unit not expressly approved b
could void the user’s authority to operate the equipment.
y the party responsible for compliance
NOTE: This equipment has been tested and found to comply with the lim its for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cau se harmful interferenceto radio communications.
However, there is no guarantee that interference will not occur in a par ticular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for he
REMARK : Receiver FCC ID lp.
FCC ID: W89-SMARTKID-49R
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,including interference that may cause undesired operation.