600-1
ONE-BUTTON TRANSMITTER
The 600-1 transmitter is a replacement RF transmitter. The transmitter comes with |
push-button switch,
*Press push-button switch on control receiver (Your alarm system).
TRANSMITTER BATTERY REPLACEMENT
If the range of your transmitter deteriorate, it is possible that you need to replace the
battery.
1). Release the screw from the back of transmitter and move upper transmitter case.
2).Remove old battery from transmitter
3).Install a new battery (12volt) noting the (+) and (-) marks in the battery area of the
transmitter.
4).Replace upper transmitter case with area, don't damage the inside components.
5). Tighten the screw on the back of transmitter.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference receiver, including interference that may
cause undesired operation.
CAUTION: Changes or modifications not expressly dés by the manufacturer
responsible for compliance could void the user's authority to operate the equipment
">
