Reminder
User Manual
(This product will turn off when combined ; turn on when
separated) |
eWhen separated, the receiver will sound one long beep and Combine status (Turn off)
follows one long & one short beeps, the LED on both receiver |
side and transmitter side will flash synchronously, then you . ‘Buzzer
can begin to use them.(When they cannot flash
synchronously, it means this turn on procedure is fail, please
repeat this operation 1. Again! ). _ | .
«Under normal operation, when the effective distance (about 5
to 10 meters ) between the receiver and the transmitter is
exceeded, the receiver's alarm will alert continuously per
second »
eWhen the distance between the receiver and the transmitter 7
is shorten to the effective distance, the alarm will stop alerting
immediately +
eSetting tracer function: under effective distance, hold the
transmitter key, the receiver's alarm will alert continuously per
second until the transmitter key is released.
LED Transmitter key LED
importantinformation
e When turn on the product, the distance between the receiver
and the transmitter must exceed 30cm to proceed the
- linking-code procedure.
e To extend battery life, be sure to turn off the product
_ (combine status) when it is not in use.
e The effective distance may be diminished by environmental
conditions such as walls, metal objects, relative humidity and
other radio signals.(we use 315MHZ).
e Keep this product away from water and avoid been crashed.
Separate status (Tum on)
Trouble shooting
ct
e Change the battery as soon as possible when LED goes N
on.(Lithium battery CR2032) « NS
DS
e Check for any nearby source of interference. Try to get rid of
it or move away from the source +
e If none of the above works, return unit to factory as per
warranty. Do not attempt to repair it by yourself.
Receiver Transmitter
Notice : The changes or modifications not expressly approved by the party responsible
for compliance could void the user”s authority to operate the equipment.
THIS DEVICE COMPLIES WITH PART 15 OF THE
FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE
RECEIVED, INCLUDING INTERFERENCE THAT MAY _ ,
CAUSE UNDESIRED OPERATION.
">
