LiveFree Emergency Response XTX-110 EzCare User Manual

Add to My manuals
2 Pages

advertisement

LiveFree Emergency Response XTX-110 EzCare User Manual | Manualzz

User

 

Manual

 

 

1.

Make   SOS   emergency   call   :  

Press   and   hold   the   red   SOS   button   on   the   base   station   or   the   button   on   the   RF   pendant   to   make   a   test   call  

 

2.

Hang   up   or   cancel  

 

Press   and   hold   the   red   SOS   button   on   the   base   station   for   3   seconds   to   hang   up   the   call   or   cancel   dialing  

 

 

3.

Fix ‐ time ‐ call   function   on/off:   switch   button   can   turn   on/off   the   Fix ‐ time ‐ call   function.

 

4.

    The   base   station   can   pair   RF   devices   to   it;   after   paired,   when   RF   device   activated,   it   activated   base   station   to   make   a   call.

 

FCC Caution:

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Customer Information

1.

This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US:

AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.

2.

A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is also compliant. See installation instructions for details.

3.

If this equipment [US: PNYAL06BXTX110] causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn't practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.

4.

The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service.

5.

If trouble is experienced with this equipment [US: PNYAL06BXTX110], for repair or warranty information, Service can be facilitated through our office at:

U.S. Agent Company name: LiveFree Emergency Response, Inc.

Address: 3780 Woodhaven Lane, Idaho Falls, Idaho, 83404 USA

Tel: 2082203817

Fax: 8014574890

If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.

6.

Please follow instructions for repairing if any (e.g. battery replacement section); otherwise do not alternate or repair any parts of device except specified.

7.

Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation commission for information.

8.

If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this

[AL] does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer.

9.

If the telephone company requests information on what equipment is connected to their lines, inform them of: a) The ringer equivalence number [0.6B] b) The USOC jack required [RJ11C] c) Facility Interface Codes (“FIC”) [02LS2] d) Service Order Codes (“SOC”) [9.0Y] e) The FCC Registration Number [US: PNYAL06BXTX110]

10.

The REN is used to determine the number of devices that may be connected to a telephone line. Excessive

RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. The

REN for this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point. For this product the FCC Registration number is

 

[US: PNYAL06BXTX110] indicates the REN would be 0.6B.

11.

If this product is equipped with a corded or cordless handset, it is hearing aid compatible.

advertisement

Related manuals

advertisement