Richen Industrial S5 Bluetooth Speaker User manual

Below you will find brief information for Bluetooth Speaker S5. The Bluetooth Speaker S5 is a waterproof Bluetooth speaker with a built-in microphone for hands-free calling. It has a charging time of 3 hours and can connect to your mobile phone via Bluetooth. It also has an auxiliary input jack for connecting to external devices.

PDF

Document

Waterproof Bluetooth Speaker

Model Number : S5

Charging The Bluetooth Speaker

Open the rubber seal cover on the side.

Charging time 3 hours.

Connect the Bluetooth Speaker’s Micro USB socket with the Computer’s USB port through

USB cable.

The Charging LED will turn ON in red light; the rechargeable battery is in charging.

The Charging LED red light will turn OFF when the rechargeable battery is fully charged.

Disconnect the USB cable, and close the Rubber Seal Cover when it is done.

Bluetooth Speaker Pairing / Reconnecting

Press the button for 3 seconds, Mode LED will blink alternately in blue and red; the device is turned ON and goes into searching / paring / reconnect mode for pair.

Now, turn ON the Bluetooth function on your mobile phone.

Search for “S5” and select it to pair.

The Bluetooth Speaker will be reconnecting automatically if your mobile phone has been paired. (Depend on the of mobile phone’s type and configuration, manual reconnection may require on some devices)

If pairing is successful, Mode LED light will switch to slow blink in blue (once per 3 seconds).

Press the button for 3 seconds to turn OFF the Bluetooth Speaker.

Note: If can’t search Speaker, means the last mobile phone is reconnecting automatically

successfully. Should press the button and button for 3 seconds to delete last mobile and pair new mobile.

Bluetooth Speaker Control Function

In playing music, press button to pause music, press it once again to play.

Press the button to increases the volume level.

Press the button to decreases the volume level.

Press and hold the button to play next music file.

Press and hold the button to play previous music file.

Hand Free Function & Redial For Last Call function

Press button to pick up the call and the playing music will pause automatically.

Press button for 2 seconds to reject the call.

Press button again to hand up the call when finished. The paused music will start to play automatically.

To redial for last called number by the Bluetooth Speaker, even it is in music playing mode.

Press twice the button to enter into redial function.

Tip: speak to the MIC hole direct with distance in 30 cm to get the best speakerphone performance when necessary.

AUX IN Function

In power ON mode, connect the Bluetooth Speaker’s AUX IN Jack with an external device’s “Earphone / AUX / LINE” Output through the Line-in cable.

The Bluetooth Speaker will switch to “AUX In” mode automatically from Bluetooth mode, and the Mode LED will slow blink in blue. All speaker button will be invalid under AUX-IN function.

Disconnect the Audio cable when it is done. Add one more notice: Line in the audio cable while the Bluetooth connected, if the music is stopped and no sound, please pull out both ends of the audio cable and then plug in again, if there is still no sound that audio cable needs to be replaced.

FCC Warning Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

‐‐ Reorient or relocate the receiving antenna.

‐‐ Increase the separation between the equipment and receiver.

‐‐ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

‐‐ Consult the dealer or an experienced radio/TV technician for help.

Hello! I am an AI chatbot specifically trained to assist you with the Richen Industrial S5 User manual. I have thoroughly reviewed the document and can help you locate the exact information you need or explain the content in clear and simple terms. Whether you’re looking for guidance on specific features, troubleshooting steps, or general usage, feel free to ask your questions. The more details you provide about your concerns or needs, the more accurately and effectively I can assist you!

Show related prompts

Assistant typing

Assistant is out of keyboard. Please, try again later.

Key features

waterproof
hands-free calling
Bluetooth connectivity
AUX input
built-in microphone
rechargeable battery
volume control
play/pause controls
track skipping
redail function

Frequently asked questions

To charge the speaker, open the rubber seal cover on the side, connect the speaker's Micro USB socket to a computer's USB port using a USB cable, and the speaker will charge for 3 hours. When the charging LED turns off, the battery is fully charged. Then, disconnect the USB cable and close the rubber seal cover.

To pair your phone, press the power button on the speaker for 3 seconds. The speaker will enter into searching/pairing/reconnect mode. Then, turn on Bluetooth on your phone and search for "S5". Select it to pair. Once paired, the LED will slow blink in blue.

To use the speakerphone function, press the play/pause button to answer an incoming call. To reject a call, press the play/pause button for two seconds. To hang up a call, press the play/pause button again. You can also redial the last call number by pressing the play/pause button twice.