P R O D U C T I N S T A L L S H E E T
OSX Outdoor Siren
Doc. - Ref. 216-OSX
Version : March 2014
Product Presentation
The OSX Outdoor Siren is designed for use with a
Videofied™ wireless alarm system.
Its main features are :
• Completely wireless and powered with alcaline batteries : 4 years battery life.
• Dual tamper function provides detection for both wall and cover tamper.
• Transmits check-in/status signals every 8 minutes
• Flash LED light
• 100 dBA output level at 1 m
• 3 to 15 minutes output and flashlights duration (according to local legislation).
Mounting holes
Installation guidelines
For easier installation, programming and RF testing should be done to check for good communication between the control panel and all system devices before mounting system devices. Install the siren and other system devices in the order of the following steps :
> Mounting - mount siren at the tested location.
> Programming/RF Testing - program the siren and all other devices into the control panel and test RF communication from each intended device location to the control panel.
Mounting
> Use proper tools and hardware for mounting the unit.
> Mount outdoors under eves to help prevent direct contact from elements.
> Mount on front of structure where strobe light is clearly visible to responding authorities.
1 Press both side buttons together to open the siren box.
2 Hold up the siren base against the mounting surface and mark the four mounting holes.
3 Drill pilot holes and install anchors where needed.
4 Place unit on mouning surface so mounting holes line up with pilot holes/anchors and secure unit with appropriate screws.
5 Install 3 LR 1.5V batteries, observing correct polarity.
6 Attach front cover and lock with the screws.
www.videofied.com
OSX Outdoor Siren P R O D U C T I N S T A L L S H E E T
Programming/RF Testing
The following provides summarized steps for device programming and testing. For complete details, refer to the control panel installation manual.
1 With the programming keypad, browse to the ADD A NEW
DEVICE menu (Level 4).
2 Press OK/YES. The keypad displays PRESS PROGRAM
BUTTON OF DEVICE.
3 Press and release program button on siren using a paper clip end.
The siren LED flashes.Wait for keypad display to show SIREN
(1 - 25) RECORDED.
4 Press OK/YES. The display shows RADIO RANGE TEST?
Press OK/YES again to run the test. The keypad display shows
TEST IN PROGRESS.
5 Make sure the siren is flashing indicating good communication with the control panel. The test result must stabilize at 8/9 minimum.
6 Press OK/YES to end the radio range test then ESC NO.
7 When finished, exit from configuration mode by a long press on ESC NO.
Opening
Button
INIT
Button
Locking
Screw www.videofied.com
2
OSX Outdoor Siren P R O D U C T I N S T A L L S H E E T
Use only the flashlights or only the output
By default, the output and the flashlights are enabled when the OSX is active. You can enable one or the other.
Lvl. 4
CONFIGURATION
OK or YES
AREAS AND DEVICES
OK or YES
DEVICES
OK or YES
ADD A DEVICE
DEVICE
CONFIGURATION
OK or YES
Device list
To select the siren
OK or YES
ALARM
FLASH + SIREN
Press OK or YES and use the arrows to select FLASH + SIREN , FLASH or SIREN
Enable delay beeps
By default, delay beeps are disabled on the OSX outdoor siren. You can enable those delay beeps.
Lvl. 4
CONFIGURATION
OK or YES
AREAS AND DEVICES
OK or YES
DEVICES
OUT SIREN DELAY
DISABLED/ENABLED
Those functions are only available for panel firmware versions 04.03.XX.XXX and later
In order to check the firmware version, enter the following code in the standby menu when the panel is DISARMED : 000000+YES
www.videofied.com
3
OSX Outdoor Siren P R O D U C T I N S T A L L S H E E T
Security notes / (FR) Notes de sécurité / (DE) Hinweise zur Sicherheit
English
• Remove battery before any maintenance !
• WARNING, there is a risk of explosion if a battery is replaced by an incorrect type!
• Observe polarity when setting up the batteries!
• Do not throw used batteries! Bring them to your installer or a collection point.
Français
•
Retirez les piles avant toute opération de maintenance !
•
Attention ! Il y a un risque d'explosion si l'une des piles utilisées est remplacée par une pile de type incorrect !
•
Respectez la polarité lors de la mise en place des piles !
•
Ne jetez pas les piles usagées !
Ramenez-les à votre installateur ou à un point de collecte spécialisé.
Deutsch
• Batterien vor jeglichen Wartungsarbeiten entfernen!
• Vorsicht, es besteht Explosionsgefahr, wenn eine Batterie durch eine Batterie falschen Typs ersetzt wird!
• Achten Sie beim Einsetzen der Batterien auf die Polung!
• Entsorgen Sie Batterien nicht im normalen Haushaltsmüll! Bringen Sie
Ihre verbrauchten Batterien zu den
öffentlichen Sammelstellen.
FCC Regulatory Information for USA and CANADA
FCC Part 15.21 Changes or modifications made to this equipment not expressly approved by RSI Video Technologies may void the FCC authorization to operate this equipment.
FCC Part 15.105 Class B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
> Reorient or relocate the receiving antenna.
> Increase the separation between the equipment and receiver.
> Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
> Consult the dealer or an experienced radio/TV technician for help.
Radio frequency radiation exposure information according 2.1091 / 2.1093 / OET bulletin 65
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including interference that may cause undesired operation.
Cet appareil est conforme à la Partie 15 des règlementations de la FCC et avec la norme RSS-210 de l’Industrie Canadienne.
Son fonctionnement est soumis aux deux conditions suivantes :
1 Cet appareil ne doit pas causer d’interférences nuisibles et
2 Cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant entraîner un fonctionnement indésirable.
www.videofied.com
4
OSX Outdoor Siren P R O D U C T I N S T A L L S H E E T
Electrical Data
Panel Compatibility
Power requirements
Battery life
XL, XLL XT, XV, VISIO
4.5V DC with 3 LR20, 1.5V, D size Alkaline batteries
4 years
Current consumption
Standby 141uA (OSX200 & OSX210)
200uA (OSX601 & OSX712)
Alarm 2A
RF Technology
Radio type
S2View®
Spread spectrum bidirectionnal
Operating frequency
868MHz - OSX200 & OSX210 (Europe, South Africa, Asia)
915MHz - FHSS - OSX601 (USA, Canada, South America)
920MHz - FHSS - OSX712 (Australia, South America)
Transmission security
Supervision
AES encryption algorithm
Polled signal every 8 minutes
Antenna Integrated
Tamper detection Wall and cover tampered
Output level
Output and flashlights duration
100 dBA at 1m
3 min by default (15 min max according to local legislation)
Flashlight type LED
Flashlight color Orange - OSX200 & OSX601
Blue - OSX210 & OSX712
Flashlight frequency
Operating temperature
Maximum relative humidity
1 flash per second
-25°/+70°C (-13°/158°F)
75%, non-condensing
Physical Data
Material
Dimensions
Weight
Protection Marking
Installation/Mounting
Cover
Siren/Wall
Two side scews for cover locking
Four screws secure siren base to mounting surface
Standards & Certifications
ABS - ULV0
349 mm x 232 mm x 54mm
1200g (without batteries)
1400g (with batteries)
IP44/IK08
868MHz (OSX200 & OSX210)
Standards :
NF EN50131-4 : 2009 Grade 2 - Type W
NF EN50130-4 : 2011
NF EN50130-5 : 2011 Class IV
915MHz (OSX601)
920MHz (OSX712)
USA FCC Part 15C (FCC47 CFR part15)
Canada IC (RSS-210 Issue 8)
Australie C-Tick (AS-NZS4268)
EMEA SALES
23, avenue du Général Leclerc
92340 BOURG-LA-REINE
FRANCE
E-Mail : [email protected]
North American Headquarters
1375 Willow Lake Blvd, Suite 103
Vadnais Heights, MN 55110
USA
E-Mail : [email protected]
www.videofied.com
5
