RTX America ELIRTX3080 RTX3080 User Manual

Add to My manuals
4 Pages

advertisement

RTX America ELIRTX3080 RTX3080 User Manual | Manualzz

F C C A N D O T H E R I N F O R M AT I O N

This equipment complies with Parts 68 of the FCC rules and the requirements adopted by the Administrative Council for Terminal Attachments (ACTA).

A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is also compliant. See installation instructions for details.

An RJ11 jack should normally be used for connecting to a single line and an RJ14 jack for two lines.

See Installation Instructions in the user’s manual. This equipment may not be used with Coin Telephone

Lines or with Party Lines. If you have specially wired alarm dialing equipment connected to your telephone line, ensure the connection of this equipment does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualifi ed installer.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this phone.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet or on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC RF EXPOSURE WARNING

To insure the safety of users, the FCC has established criteria for the amount of radio frequency energy various products may produce depending on their intended usage. This product has been tested and found to comply with the FCC’s exposure criteria. For body worn operation, the FCC RF exposure guidelines were also met when used with the accessories supplied or designed for this product. Use of other accessories may not ensure compliance with FCC RF exposure guidelines and should be avoided.

Caution: To maintain compliance with the FCC’s RF exposure guidelines, the internal antennas used for this mobile transmitter (Base unit) must provide a separation distance of at least 20 cm from all persons.

Base and Handset must not be co-located or operating in conjunction with any other antenna or transmitter.

Caution: Any changes or modifi cations not expressly approved by the party responsible for compliance could void the user’s authority to operate this device.

33

U S E R M A N U A L

RIGHTS OF THE TELEPHONE COMPANY

Should your equipment cause trouble on your line which may harm the telephone network, the telephone company shall, where practicable, notify you that temporary discontinuance of service may be required. Where prior notice is not practical and the circumstances warrant such action, the telephone company may temporarily disconnect service immediately. In case of such temporary discontinuance, the telephone company must:

1. Promptly notify you of such temporary discontinuance;

2. Afford you the opportunity to correct the situation;

3. Inform you of your right to bring a complaint to the Commission pursuant to procedures set forth in

Subpart E of Part 68, FCC Rules and Regulations.

The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of the equipment. If this happens, the telephone company will provide advance notice in order for you to make necessary modifi cations to maintain uninterrupted service.

PRODUCT IDENTIFIER AND REN INFORMATION

The label on the back or bottom of this equipment contains, among other things, an identifi er indicating product approval and the Ringer Equivalence Number (REN). This information must be provided to your local telephone company upon request. For equipment approved prior to July 23, 2001, the product identifi er is preceded by the phrase “FCC Reg No.” and the REN is listed separately. For equipment approved after that date, the product identifi er is preceded by “US” and a colon (:), and the REN is encoded in the product identifi er without a decimal point as the sixth and seventh characters following the colon. For example, the product identifi er US:AAAEQ03T123XYZ would indicate an REN of 0.3.

The REN is used to determine how many devices you may connect to your telephone line and still have them ring when you are called. In most, but not all areas, the sum of all RENs should be fi ve (5.0) or less.

OTHER NOTES:

• This equipment may not be used on coin service provided by the telephone company.

• Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation commission for information.

• If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this cordless phone does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualifi ed installer.

• Notice must be given to the telephone company upon permanent disconnection of your telephone from your line.

HEARING AID COMPATIBILITY

This equipment is hearing aid compatible as defi ned by the FCC in 47 CFR Section 68.316.

HEALTH AND SAFETY INFORMATION FCC

Exposure to Radio Frequency (RF) Signals

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications

Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on the safety standards previously set by both U.S. and international standards bodies:

34

U S E R M A N U A L

This EUT has been shown to be capable of compliance for localized specifi c absorption rate (SAR) for uncontrolled environment/general population exposure limits specifi ed in ANSI/IEEE Std. C95.1-1992 and had been tested in accordance with the measurement procedures specifi ed in FCC/OET Bulletin 65

Supplement C (2001) and IEEE Std. 1528-2003 December 2003).

The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specifi c Absorption Rate, or SAR. The SAR limit set by the FCC and Canada is 1.6W/kg

*.(W/kg) averaged over one gram of tissue. The standard incorporates a substantial margin of safety to give additional protection for the public and to account for any variations in.

RF EXPOSURE FCC

Tests for SAR are conducted using standard operating positions specifi ed by the FCC with the phone transmitting at its highest certifi ed power level in all tested frequency bands. Although the SAR is determined at the highest certifi ed power level, the actual SAR level of the phone while operation can be well below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output.

Before a phone model is available for sale to the public, it must be tested and certifi ed to the FCC that it does not exceed the limit established by the government-adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the

FCC for each model. (Body-worn measurements may differ among phone models, depending upon available accessories and FCC requirements). The highest SAR value for this phone when tested for use at the ear is 0.0

85 W/kg, and when worn on the body is 0.0

2 1 W/kg for 1.5cm distance. (Body worn measurements differ among phones depending upon available accessories and the FCC requirements.)

While there may be differences between the SAR levels of various phones and at various positions, they all meet the government requirement for safe exposure.

For body worn operation, to maintain compliance with FCC RF exposure guidelines, use only accessories that contain no metallic components and provide a separation distance of 15mm (0.6 inches) to the body. Use of other accessories may violate FCC RF exposure guidelines and should be avoided.

CORDLESS TELEPHONE PRIVACY

Cordless telephones are radio devices. Communications between the handset and base of your cordless telephone are accomplished by means of radio waves which are broadcast over the open airways. Because of the inherent physical properties of radio waves, your communications can be received by radio receiving devices other than your own cordless telephone unit. Consequently, any communications using your cordless telephone may not be private.

PROGRAMMING AND TESTING OF EMERGENCY NUMBERS

If this product has memory dialing locations, you may choose to store police, fi re department and emergency medical service telephone numbers in these locations. If you do, please keep three things in mind:

1. It is recommend that you also write the telephone number on the directory card, so that you can still dial the emergency number manually if the memory dialing feature doesn’t work.

2. This feature is provided only as a convenience, and the manufacturer assumes no responsibility for customer reliance upon the memory feature.

3. Testing the emergency telephone numbers you have stored is not recommended. However, if you do make a call to an emergency number:

35

U S E R M A N U A L

• You must remain on the line and briefl y explain the reason for the call before hanging up.

• Programming/testing of emergency numbers should be performed during off-peak hours, such as in the early morning or late evening, when the emergency services tend to be less busy.

36

U S E R M A N U A L

advertisement

Related manuals

advertisement