Sharp APYHRO00194 CellularPhone User Manual

Sharp APYHRO00194 CellularPhone User Manual | Manualzz
50 ページ
General Notes
in Europe
Do not disassemble or modify handset.
Electromagnetic Safety
For body-worn operation, this mobile phone
has been tested and meets RF exposure
guidelines when used with an accessory
containing no metal and positioning the
handset a minimum 15 mm from the body. Use
of other accessories may not ensure compliance
with RF exposure guidelines.
CE Declaration of Conformity
Hereby, Sharp Telecommunications of Europe Ltd, declares
that 206SH is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
A copy of the original declaration of conformity for each
model can be found at the following Internet address:
■Battery Cautions
Use specified Charger only.
Non-specified equipment use may cause
Internal Battery to leak, overheat, burst or
ignite, and may cause Charger to overheat,
ignite, malfunction, etc.
Battery is built into handset. Do not dispose of
handset with ordinary refuse; take it to a
SoftBank Shop for appropriate disposal.
Charge handset in ambient temperature 5ºC 35ºC; Internal Battery may leak/overheat and
performance may deteriorate outside this range.
■Mobile Light
Do not shine Mobile Light in eyes.
May temporarily affect eyesight or startle,
leading to accidents.
■European RF Exposure Information
Your mobile device is a radio transmitter and
receiver. It is designed not to exceed the limits
for exposure to radio waves recommended by
international guidelines. These guidelines were
developed by the independent scientific
organization ICNIRP and include safety margins
designed to assure the protection of all persons,
regardless of age and health.
The guidelines use a unit of measurement known
as the Specific Absorption Rate, or SAR. The SAR
limit for mobile devices is 2.0 W/kg and the
highest SAR value for this device when tested at
the ear was 0.536 W/kg*. As mobile devices offer
a range of functions, they can be used in other
positions, such as on the body as described in this
User Guide**. In this case, the highest tested SAR
value is 0.402 W/kg***. As SAR is measured
utilizing the device's highest transmitting power
the actual SAR of this device while operating is
typically below that indicated above. This is due to
automatic changes to the power level of the
device to ensure it only uses the minimum level
required to reach the network.
Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Download PDF