CLEANING
Water contains lime which remains on the surface after the water has evaporated. These lime deposits can be prevented from forming by wiping immediately after use.
To clean the chrome-plated surface use a soft cloth, soap and warm water. Never use cleaning agents that contain a corrosive acid or a scouring additive.
Do not use any sharp objects to clean nozzles
Important Installation Considerations
1. NOTE: Some showers may not provide an effective shower when used with gravity fed heated water systems or where pressures are less than 150kPa at the outlet. Additionally showers with flow rates of less than 9L/min may not allow the following to function correctly:
_ some instantaneous water heaters
_ some tempering valves
_ some thermostatic mixing valves
2. Some shower heads only operate correctly when hot and cold water supplies are both mains pressure and may not be suitable for some instantaneous hot water services.
3. When water pressure is in excess of 500kPa a pressure limiting device is required in accordance with AS/NZS 3500 1.12 recommendation.
4.
Domestic and Commercial warranty terms and conditions vary.
For full warranty terms and conditions refer to www.methven.com
Methven warrants this product against manufacturing defects and that it is suitable for use under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com/au or call Customer Service 1300 METHVEN
Australia
1300 638 483
436670 Issue B
SATINJET ESCAPE MKII RAILSHOWER/
HANDSET
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min 150kPa, Max 500kPa.
Recommended installation of a pressure limiting valve if supply exceeds 500kPa
Operating Temperature:
Recommended hot water supply 50°C, maximum 70°C. AS 3500 requires all hot water supplies to any sanitary fitting to be tempered to 50°C.
Inlet connections: All 1/2” BSP
Notes:
● After installation all connections must be checked for leaks.
● All installations must be carried out in compliance with relevant water regulations.
9
1.
Escape MKII
Handset
Slider
Shelf
Hose
Elbow
5.
2.
grub screw topside
Wall Boss Housing
Internal Mounting Bracket
Rail
Screw
Grub Screw
NOTE: ENSURE
PROTECTION
PADS ARE USED
BETWEEN WALL
BOSSES AND TILES.
grub screw underside
6.
Secure the wall boss housings in desired position with 4 screws using wall plugs if required.
Check the mounts are vertical.
Ensure the grub screws are located as shown.
Floor
Match the mountings up to the wall bosses and push into place.
Slide the rail up and down if required to centralise the rail on the brackets.
Once satisfied that the rail is centralised remove the rail and tighten the tensioning screws until they lock.
Relocate the rail onto wall bosses and tighten grub screws top and bottom.
NOTE: GRUB SCREW HOLES
ARE NOT FULLY ALIGNED
PRIOR TO GRUB SCREW
BEING FITTED, THEREFORE
SCREW MAY BE STIFF TO
TIGHTEN.
3.
7.
Attach the shelf to the rail from the end with the endcap already fitted.
Fitted endcap
Fit end cap to top of rail. Ensure drainage hole is at back.
4.
Fit the internal mounting brackets by locating in slot and rotating 90 ° as shown.
Once located tighten the screws finger-tight.
8.
NOTE: TO LOOSEN SLIDERS
GRIP ON RAIL ROTATE SIDE
PIECE ANTI-CLOCKWISE.
ROTATE CLOCKWISE TO
TIGHTEN.
Flat Washer
Swivelling
Cone
Filter Washer
Non-Swivelling Cone
