Onn ONA11HO087 Product Manual

Add to My manuals
2 Pages


Onn ONA11HO087 Product Manual | Manualzz


Wireless Keyboard and Mouse with Nano Receiver

Model: ONAllH0087



CAUTION: To use this product properly, please read the user's guide before installation

Federal Communication Commission

Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCCRules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radiolTV technician for help.

This device complies with Part 15 of the FCCRules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCCCaution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority-to operate this equipment.

Wal-Mart Stores,lnc.,

Bentonville, AR 72716

Hotline: 1-800-925-6278



Keyboard Button



2. Connect Button

3. Battery Cover






AAA Batteries l e~

• •






Mouse Button


Left button

2. Right button

3. Scrolling Wheel

4. Backward

5. Forward

6. LED Indicator

7. Nano Receiver

8. Battery Cover

9. Connect Button

10. OFF/ON Switch


Press this button to view the next page of the Internet browser.


Press this button to view the previous page of the Internet browser.

Installing the batteries

Step 1: Take the battery cover off.

Step 2: Insert the batteries as shown inside the battery compartment.

Step 3: Replace the cover.

Step 4: Turn on power switch.


"Please insert the batteries with the correct position according to the instruction labeled in the Keyboard / Mouse.

'The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.

Battery warning statement:

Do not mix old and new batteries

Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad,

OJ ni-mh, etc) batteries.

Setup the Connection between the ~."

¢:l ~

Receiver and the Mouse, Keyboard

1. Plug the Nano receiver into the USB port of your comput~


2. Insert the batteries into the mouse and keyboard, then your mouse and keyboard will connect automatically.

3. If your wireless mouse and keyboard has not been connected to your computer after completing the previous steps, then put them into pairing mode.

4. Pairing: Press the connect button on the bottom of the mouse and keyboard,

If the mouse or keyboard does not work after 10 seconds, Re-pair again. Keep the mouse and keyboard closer to the receiver while in pairing mode.

5. When the keyboard battery is low, the low power indicator will start to blink.

During pairing

LED Indicator Red LED is on for 10 Sec. ~

\ Power On


Red LED Blinking for 10 Se..w_

\ Low Battery Warning "")I-

Red LED Blinking

Pairing (LED OFF when paired or failed after 10 sec.)

Red LED is on for 10 Sec. ~

\ Power On ~-

Red LEO Blinking for 10 Se..w_

\ Low Battery Warning }I-

Red LED Blinking

Pairing (LED OFF when paired or failed after 10 sec.)




Related manuals

Download PDF