Instructions - Lowbrow Customs

Instructions - Lowbrow Customs
V-Twin Mfg.
York Kevlar Clutch Pack Kit
Fits 41-84 BT, W/Belt/Chain Wet/Dry
VT Part No.18-0517
This is a custom application and rider safety depends on proper installation. This product should only be installed by a
knowledgeable and trained motorcycle technician. V-Twin Mfg. accepts no responsibility for improper installation.
Note: Refer to service manual for proper removal of stock clutch drum and hub. A hydraulic press may be needed for some of the
following steps.
Installation Instructions:
1. Install bearing in bearing retainer, install snap ring.
2. Install bearing retainer and bearing into clutch drum. Using blue loctlte on bearing adapter retainer screws install retainer.
3. Press hub into bearing and install snap ring. Check that hub spring move freely.
4. Using red loctite on threads of mainshaft install clutch basket/hub assembly onto the mainshaft tighten clutch hub nut.
Note: If running clutch in a system that is not dry, it is recommended that you soak friction plates in primary lubricant for 10-15
minutes.
5. Dry plates with lint free cloth. Install and alternate the plates.
6. Install pressure plate, diaphragm spring, spring retainer, lock tab and retainer ruts in order shown in diagram.
7. Tighten retainer nuts and fold locktab over nut.
8. Install adjuster screw and nut. Adjusting screw should be 3/4 to 1 turn loose from slightly seated.
Bearing
Adapter
Retainer
Bearing
Clutch
Hub
Hub Nut
Hub
Snap
Ring
VT 18-1126
VT 18-1129
Snap
Ring
Diaphragm
Spring
VT 18-3234
Adjusting
Screw &
Locknut
VT 18-1124 1941-67
VT 18-1121 1968-84
Locktabs
Spring
Retainer
Retainer
Nuts
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement