PERRIN WRX 22mm Rear Sway bar sway bar Installation instructions

Below you will find brief information for WRX 22mm Rear Sway bar. The WRX 22mm Rear Sway bar offers an upgrade to the OEM sway bar for your vehicle. This will drastically change the handling characteristics of your car, so be sure to drive cautiously until you become accustomed to the new handling of your WRX. Be sure to use the correct set of bushings as the document provides two sets for 02-05 and 06-07 WRX.

PDF Download
Document
WRX 22mm Rear Sway bar Installation Instructions | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • 22mm diameter
  • Improves vehicle handling
  • Three mounting holes for different stiffness settings
  • Use the stout mount upgrade when using the 22mm sway bar
  • Includes grease packet for lubrication
  • Requires greasing the bushing if squeaking is noted after installing
  • May cause oversteer or understeer depending on the setting used

Frequently asked questions

The document includes two sets of bushings, one for 02-05 and one for 06-07 WRX. Make sure to use the correct set for your vehicle.

The sway bar has three mounting holes. The hole closest to the front of the car is the softest setting, the hole closest to the rear is the stiffest setting. The middle hole is a medium stiffness setting.

The document recommends using the Stout Mount Upgrade when installing the 22mm sway bar. This upgrade will improve the overall performance of the sway bar and help prevent damage to the sway bar mounting points.
Preparing document for printing…
0%