Hyco JET11W Instruction Manual

Add to My manuals
8 Pages

advertisement

Hyco JET11W Instruction Manual | Manualzz

Jetstream ABS Hand Dryer _Layout 1 08/01/2015 12:59 Page 1

Hand Dryer

Model JET11W

Instruction Manual

Version 1.0 Jan 2015

Jetstream ABS Hand Dryer _Layout 1 08/01/2015 12:59 Page 2

PLEASE READ THESE INSTRUCTIONS BEFORE

COMMENCING INSTALLATION. UPON COMPLETION

OF INSTALLATION ENSURE THE INSTRUCTIONS ARE

LEFT WITH THE USER/MAINTAINER OF THE PRODUCT.

Jetstream ABS Hand Dryer

1. INTRODUCTION

Thank you for purchasing a Hyco Jetstream ABS high speed automatic hand dryer.

Recent research and developments in hand dryer technology have given greater emphasis on air flow, minimising hand drying times and lowering energy consumption.

The Jetstream ABS features a durable yet stylish design and offers ultra fast hand drying performance.

2. IMPORTANT SAFETY POINTS

ELECTRICAL INSTALLATION MUST BE CARRIED OUT BY A

QUALIFIED ELECTRICIAN IN ACCORDANCE WITH THE LATEST

ELECTRICAL REGULATIONS.

ISOLATE ELECTRICAL SUPPLY BEFORE INSTALLATION.

ELECTRICAL CONNECTION MUST BE MADE TO THE FIXED WIRING

OF THE PROPERTY HAVING A CONTACT SEPARATION IN ALL POLES

THAT PROVIDE FULL DISCONNECTION FROM THE SUPPLY MAINS.

ONLY CONNECT THE HAND DRYER TO A SINGLE PHASE SUPPLY

WITH A MAINS VOLTAGE AS SPECIFIED ON THE RATING PLATE.

THE HAND DRYER MUST BE INSTALLED OUT OF REACH OF PERSONS

USING A BATH OR SHOWER.

DO NOT COVER THE AIR INLET OR OUTLET.

DURING USER MAINTENANCE PLEASE ENSURE THAT THE MAINS

SUPPLY IS SWITCHED OFF.

2

Jetstream ABS Hand Dryer _Layout 1 08/01/2015 12:59 Page 3

THIS APPLIANCE CAN BE USED BY CHILDREN AGED 8 YEARS AND

ABOVE AND PERSONS WITH REDUCED PHYSICAL, SENSORY OR

MENTAL CAPABILITIES OR LACK OF EXPERIENCE AND KNOWLEDGE

IF THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION

CONCERNING USE OF THE APPLIANCE IN A SAFE WAY AND

UNDERSTAND THE HAZARDS INVOLVED.

CHILDREN SHALL NOT PLAY WITH THE APPLIANCE.

THE APPLIANCE IS INTENDED FOR VERTICAL MOUNTING AND MUST

BE INSTALLED THE CORRECT WAY UP (HOT OUTLET AT THE BOTTOM).

THE APPLIANCE IS INTENDED FOR DRYING HANDS ONLY.

3. INSTALLATION

ENSURE THAT THE SURFACE SELECTED FOR MOUNTING THE HAND

DRYER IS SUITABLE FOR THE WEIGHT OF THE PRODUCT.

ENSURE NOTHING IS WITHIN A MINIMUM OF 400MM BELOW THE

AIR OUTLET.

DO NOT LOCATE ABOVE ANY SHINY OR REFLECTIVE SURFACE.

1. To remove the cover first remove the two screws, located at the bottom of the unit, using a pozi-head screwdriver. Gently prise the cover off by pulling the bottom of the cover towards you.

3

Jetstream ABS Hand Dryer _Layout 1 08/01/2015 12:59 Page 4

2. Mark and drill four holes, following the diagram below. Insert the wall plugs provided.

155mm

1300mm

212mm

FLOOR

3. Position the hand dryer back plate over the four holes and feed the mains cable through the hole in the back plate, located above the terminal block.

4. Place the four screws into the holes and drive them in firmly, ensuring the unit is fixed to the wall with no movement.

5. Make the electrical connection by connecting Live and Neutral wires to the terminal block connections marked L and N.

6. Refit the front cover by lining up the bottom of the cover with the back plate and then clip on the top of the cover by gently pushing into place. Replace the 2 retaining screws.

4

Jetstream ABS Hand Dryer _Layout 1 08/01/2015 12:59 Page 5

4. USER OPERATION

1. Ensure on/off power switch is set to ON position.

2. Shake off excess water from wet hands.

3. Hold wet hands directly below the air outlet, approximately 12cm away; this will start the unit automatically. Rub hands together until dry.

4. Remove hands when dry; this will automatically stop the unit.

Note - this unit has a heating element on/off switch. In the OFF position the hand dryer will deliver cold air only.

THE HAND DRYER WILL AUTOMATICALL STOP AFTER 50 SECONDS

OF CONTINUOUS UASGE; TO RESTART, REMOVE AND REPLACE

HANDS.

DO NOT COVER THE OUTLET.

5

Jetstream ABS Hand Dryer _Layout 1 08/01/2015 12:59 Page 6

5. CARE AND MAINTAINANCE

DURING USER MAINTENANCE PLEASE ENSURE THAT THE MAINS

SUPPLY IS SWITCHED OFF.

NEVER USE ABRASIVE CHEMICALS OR MATERIAL TO CLEAN THE

HAND DRYER

1. Clean the exterior of the hand dryer using a soft damp cloth.

2. Ensure the outlet is kept free from debris and any other potential blockages.

3. Check filter and shake off dust if necessary (see diagram right).

DO NOT WASH THE FILTER WITH WATER.

4. Replace filter and return to original position (see diagram below).

6

5. In the unlikely event of a hand dryer malfunction, discontinue use and isolate the power. Contact the technical helpline on 01924 225200.

6. If the power cord shows signs of damage discontinue usage and arrange for a professional electrician to inspect/replace it.

7. If the air volume reduces it could be a sign that the filter is blocked and requires cleaning or replacing.

Jetstream ABS Hand Dryer _Layout 1 08/01/2015 12:59 Page 7

6.TECHNICAL SPECIFICATION

Voltage / Frequency

Cureent

Total Power

Heating Element

Motor

Dimensions

Sound Level

Air Speed

Weight

IP Rating

230V~50Hz

5A

1100W

450W

650W

260 x 250 x 180mm

72dB

90m/s

3.16Kg

IPX1

7. GUARANTEE AND SERVICE POLICY

This product is guaranteed against faulty materials and manufacture for a period of one year from the date of purchase. Hyco will in its sole discretion replace, repair or refund any faulty unit. Incorrect installation, frost damage, and the consequences of limescale deposits are excluded. Consequential costs such as labour charges or damage to fittings and surroundings are expressly excluded.

7

Jetstream ABS Hand Dryer _Layout 1 08/01/2015 12:59 Page 8

INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN

ACCORDANCE WITH THE EUROPEAN DIRECTIVE 2002/96/E.

At the end of its working life this equipment must not be disposed of as household waste. It must be taken to a local authority waste collection centre or to a dealer providing this service. Disposing of electrical and electronic equipment separately enables its components to be recovered and recycled to obtain significant savings in energy and resources. In order to underline the duty to dispose of this equipment separately, the product is marked with a crossed out dustbin.

WATER HEATING

Hyco Manufacturing Ltd

Normandy Court, Express Way

Castleford, WF10 5NR

Sales: 01924 225 200

Fax: 01924 225 210

Switchboard: 01924 225 215

Email: [email protected]

www.hyco.co.uk

SPACE HEATING HAND DRYERS

advertisement

Related manuals

Download PDF

advertisement