5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
FL-2335
Rev. 0 (2/07)
Models:
H137SRR SERIES for use with Convotherm C2020 Roll-In Rack (not included).
Cabinet model number:
Cabinet serial number:
Authorized Service Agency:
Ph: Fax:
Keep this manual for future reference.
FL-2335
Rev. 0 (2/07)
5925 Heisley Road • Mentor, OH 44060-1833
TABLE OF CONTENTS
SUBJECT PAGE
INSTALLATION INSTRUCTIONS ............................................................................................1
Illustration (Leg Adjustment), Figure 1 ..............................................................................1
OPERATING INSTRUCTIONS ..................................................................................................2
Illustration (Control Panel), Figure 2 .................................................................................2
MAINTENANCE INSTRUCTIONS
How to Clean the Unit ........................................................................................................3
Replacement Parts (Cabinet) ..............................................................................................4
Illustration (Cabinet Parts) ..................................................................................................5
Replacement Parts (Power Unit) ........................................................................................6
Trouble Shooting Guide .....................................................................................................7
Wiring Diagram ..................................................................................................................8
How to Reverse the Door Opening .....................................................................................9
NOTES .........................................................................................................................................10
SERVICE POLICY and AGENCY LIST ......................................................................... FL-1400
Companion
Holding Cabinet
Rev. 0 (2/07)
FL-2335
Page 1 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
IDENTIFYING YOUR CABINET:
Look for this label on the back of your cabinet. This information is needed when calling for questions or service.
ELECTRICAL SPECIFICATIONS:
Model No.
Volts
H137SRRC2020C 120
H137SRRC2020C208 208
Watts
1920
2000
Amps
16.0
10.0
Hertz
60
60
Phase
1
1
NEMA
5-20P
6-15P
H137SRRC2020C240 240 2000 8.6
60 1 6-15P
Note: The above model numbers are basic models. They may be followed by letters: L, M, 2M, D, or ending with S.
HOW TO INSTALL UNIT:
1.
Remove all paper and packing material from inside of cabinet.
2.
Remove protective paper and vinyl material from outside surfaces of cabinet.
3.
Place the cabinet in a well-ventilated area.
4.
Place cabinet on level fl oor. (For cabinets with legs, adjust the legs of the cabinet to ensure proper fi t of rack into cabinet. See Fig. 1)
5.
Plug cord end into proper wall outlet.
FIGURE 1
Leg Adjustment
Companion
Holding Cabinet
Rev. 0 (2/07)
FL-2335
Page 2 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
Yellow Light “On-Off” Switch
“Air” Thermostat
Thermometer
Figure 2
INITIAL OPERATION:
( For fi rst-time operation only )
A new oven needs to “burn off” manufacturing oils and excess adhesive before its fi rst use.
Do NOT load food into oven until this has been done!
1.
Turn the POWER switch on. The yellow light will turn on.
2.
Turn the thermostat to #10.
3.
Let the unit operate for one hour.
4.
Turn unit off and let cool
5.
Wipe inside clean with detergent and hot water.
HOW TO START UNIT:
1.
Turn the POWER switch on. The yellow light will turn on.
2.
Turn the thermostat to #6-1/2.
3.
Preheat cabinet for one (1) hour.
4.
Put food into cabinet
5.
Turn thermostat to desired setting and close door.
No. 8 setting = approx. 185°F / 85°C
No. 6 setting = approx. 160°F / 71°C
No. 4 setting = approx. 130°F / 54°C
Proper food holding temperature is 140°F / 60°C or higher.
NOTE: The optional digital thermometer display fl ashes when temperature in center of cabinet is below
140°F (60°C) or above 250°F (121°C). Call the factory if you need different settings.
Air is VERY HOT when door is opened.
TO TURN OFF UNIT:
Turn the POWER switch off. The yellow light will go out.
Companion
Holding Cabinet
Rev. 0 (2/07)
FL-2335
Page 3 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
BEFORE cleaning the cabinet: Unplug cord from wall.
Do NOT hose cabinet with water.
Do NOT get water on controls.
Do NOT use abrasives or harsh chemicals.
Cleaning hints:
1.
Wipe up spills as soon as possible.
2.
Clean cabinet regularly to avoid heavy dirt build-up.
3.
Make a test spot with cleaner.
4.
Follow manufacturer’s directions on cleaner.
5.
Do not mix cleaners.
6.
Avoid drips and splashes
HOW TO CLEAN THE UNIT:
Soil
CABINET
Inside and
Outside
(Stainless Steel)
ROUTINE CLEANING
STUBBORN SPOTS AND
STAINS
BURNT-ON FOODS OR
GREASE
Cleaner
Soap, Ammonia, or mild
*detergent and water.
Mild abrasive made for stainless steel.
Method
1. Sponge on with cloth.
2. Rinse with water.
3. Wipe dry.
1. Apply with damp sponge or cloth.
2. Rub lightly.
Chemical oven cleaner for stainless steel.
Follow oven cleaner manufacturer’s directions.
HARD WATER SPOTS and SCALE
Vinegar
1. Swab or wipe with cloth.
2. Rinse and dry.
*Mild detergents include soaps and non-abrasive cleaners.
Companion
Holding Cabinet
Rev. 0 (2/07)
FL-2335
Page 4 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
CABINET REPLACEMENT PARTS:
ITEM DESCRIPTION
1 Heater Kit, Air
2 High Limit
3 Power Cord
4 Power Unit (See Page 7)
5 Door - full, solid
-full, w/window
-half, solid, top LH, bottom, RH
-half, solid, bottom LH, top, RH
-half, window, top LH, bottom, RH
-half, window, bottom LH, top, RH
6 Gasket Kit, Body
7 Gasket Kit, Door
8 Hinge Kit
9 Latch Kit
10 Tunnel
11 Leg, Adjustable
Handle, Pull (Black)
120V
0811-074
0848-060
0810-065-10
0675-067
1221-557-K
1221-558-K
1221-560-K
1221-559-K
1221-561-K
1221-562-K
0861-175
0861-265
0519-074-K
1006-122-01-K
0546-141
1206-070
0911-102
208V
0811-074-02
0848-060
0810-039-02
0675-068
240V
0811-074-01
0848-060
0810-039-02
0675-068
Companion
Holding Cabinet
Rev. 0 (2/07)
FL-2335
Page 5 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
CABINET REPLACEMENT PARTS:
6
4
1
2
10
3
8
5
9
7
11
Companion
Holding Cabinet
Rev. 0 (2/07)
FL-2335
Page 6 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
REPLACEMENT PARTS FOR THE POWER UNIT:
20
17
16
18
14
12
13
15
REPLACEMENT PARTS:
ITEM DESCRIPTION
Power Unit
12 Power Light
13 Power Switch
14 Thermostat
15 Knob
16 Terminal Block
17 Blower Kit
18 Vent Fan
19
20
Thermometer (Analog)
Thermometer (Digital)
Transformer (used with digital thermometer)
19
120V
0675-067
0766-094
0808-116
0848-062-K
0595-061
0852-093
0769-180-01-SSK
0769-165
5238-030-K
5238-034-K
0769-159
208V
0675-068
0766-095
0808-116
0848-062-K
0595-061
0852-093
0769-182-01-SSK
0769-174
5238-030-K
5238-034-K
0769-159
240V
0675-068
0766-095
0808-116
0848-062-K
0595-061
0852-093
0769-182-01-SSK
0769-174
5238-030-K
5238-034-K
0769-159
Companion
Holding Cabinet
Rev. 0 (2/07)
FL-2335
Page 7 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
TROUBLE-SHOOTING CHART:
FAILURE POSSIBLE CAUSE
1.
Yellow light at switch
does NOT light.
1a. Switch is “OFF”.
1b. Cord unplugged from wall outlet.
1c. Circuit breaker/fuse to wall outlet blown.
2. Unit does not heat.
3. Unit gets too hot or
won’t shut off.
4. Blower does not work
or makes noise.
2a. Thermostat set too low.
2b. Switch is “OFF”.
4a. Defective electrical parts. UNPLUG UNIT FROM WALL OUTLET.
5a. Defective blower.
5. GFCI device trips.
6a. The insulation inside the heating elements may have absorbed some moisture. This may have occurred if the cabinet has not been used for a long period of time or during shipping and storage of the cabinet. Drain the water pan if needed. Plug the cabinet into a non-GFCI outlet and set the thermostat to No. 10. Let the cabinet run for about 1 hour to dry out the heating elements from any moisture may have been absorbed. If the circuit breaker trips, turn off cabinet, remove cord from power source, and call the Factory Authorized Service Agent. After drying the heating elements, plug cabinet into the GFCI receptacle; the cabinet should run properly. If the GFCI trips, call the factory Authorized service agent.
GFCI (ground-fault circuit interrupter): A GFCI receptacle is a device that de-energizes a circuit when it detects an unsafe fl ow of current to ground. The intention of a GFCI device is to minimize the potential for an electrical shock
If cause is none of the above, refer to our list of Authorized Service Agencies.
Companion
Holding Cabinet
Rev. 0 (2/07)
FL-2335
Page 8 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
WIRING DIAGRAM t°
SENSOR
FOR 208V/240V
TRANSFORMER
110V/220V
5 8
4 3 2 1
OPTIONAL t°
SENSOR
TRANSFORMER
110V/220V
5 8
4 3 2 1
6-15P PLUG
240V, 15A
208V, 15A
W B
G
W
G
5-20P
120V; 20A
POWER
SWITCH
2
1
THERMOSTAT
4 5
HIGH LIMIT
7
HIGH LIMIT
6
TERMINAL BLOCK
4
2
1
3
BM
A
FAN
BM
HEATER AIR
3
Companion
Holding Cabinet
Rev. 0 (2/07)
FL-2335
Page 9 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
HOW TO REVERSE THE DOOR OPENING (Left hinged door shown):
The doors are shipped with the hinges on the right side of the cabinet as standard. The doors on the cabinet are large and may require additional help when changing the hinge direction. Allow the cabinet to cool if the cabinet has been in use.
1.
Remove handle bracket and strike plates from cabinet and set aside.
2.
3.
4.
5.
6.
Remove hinge covers and set aside.
Remove hex screws from door gasket bracket assembly and door cover and set aside.
Remove door(s) from cabinet, rotate door(s) 180° and install onto other side of cabinet. For dutch doors, install the bottom door onto the top position and install the top door onto the bottom position on the other side of the cabinet.
Remove screws on bottom of (lower) door and install onto top of (upper) door.
Install door gasket assembly and door cover onto bottom of (lower) door.
7.
For single door, remove latch and rotate 180° and install onto holes on upper half of door. For dutch doors, it is not necessary to change latches.
8.
9.
Install handle bracket and strike plates onto other side of cabinet.
Adjust hinges, latch(es) and door gasket bracket assembly for proper door seal.
10.
Install hinge covers.
Companion
Holding Cabinet
Rev. 0 (2/07)
FL-2335
Page 10 of 10
NOTES:
5925 Heisley Road • Mentor, OH 44060-1833
