Heavy Duty Workbench
Model: CWB1530
Part No: 7637820
ASSEMBLY INSTRUCTIONS
GC10/12
INTRODUCTION
Thank you for purchasing this CLARKE product. Before assembling the workbench, be sure to read these instructions thoroughly. In doing so you will ensure the safety of yourself and of others around you, and you can look forward to the product giving you long and satisfactory service.
CONTENTS
Long Beam E
Shelf Support
Beam F
Post A
Upper End
Beam G
Centre Support D
Plastic Foot B
Lower End
Beam H
Plastic Feet B
Plastic Post Caps C
Centre Support D
Long Beams (with holes) E
Shelf Support Beam F
Upper End Beams (without holes) G
Lower End Beams (with holes) H
MDF Board I
Safe Working Load
CWB1530 (with T-bar)
2
1
4
1
4
4
2
2
1
300kg (top shelf)
2
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
ASSEMBLY
The tabs of the beams will often enter the slots fully using just firm hand pressure but if they are too tight, you may require a rubber mallet or hammer to assist. If so, always use a cloth to protect the product paint finish.
FIG 1
Slots
1. Decide how high you want the tbar to be, relative to the floor.
2. Fit the upper end beams between two posts as shown in Fig 1.
• Only use the mallet to tap gently, ensuring the tabs of the beams are in line with the slots in the posts.
• When using a hammer or mallet, always strike the edge closest to the post and protect the paint with a cloth.
3. Repeat this again for the other end of the assembly, making sure that the corresponding end is at the same height.
Upper End
Beam G
FIG 2
Long Beam
E
4. Now fit the long beams to match the upper end beams as shown in Fig 2.
G
Centre Support D
5. Fit the centre support between the lower end beams to provide a t-bar only as shown in Fig 3.
Note that the edge with the wider flange should be installed uppermost. (The face with open edges should face the rear of the unit).
FIG 3
FIG 4
6. Slot the shelf support beam between the front/rear long beams shown in Fig 4.
F
Lower
Beam
End
H
Shelf Support
Beam F
3
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
top shelf.
8. Fit the plastic post caps to top
of each post as shown in Fig 5.
9. Fix the plastic foot to end of
each post as in Fig 6.
SAFETY ADVICE
• Always distribute your loads evenly where possible.
GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt as proof of purchase. This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for its intended purpose.
Plastic
Post cap
C
FIG 5
FIG 6
Post A
Plastic
Foot B
Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission.
This guarantee does not effect your statutory rights.
Parts & Service: 0208 988 7400
E-mail: [email protected] or [email protected]
Clarke International Hemnall Street, Epping, Essex CM16 4LG
