YFM250BT Supplementary Service Manual

YFM250BT Supplementary Service Manual
FRONT BRAKE
FRONT BRAKE
1 Brake master cylinder reservoir cap
2 Brake master cylinder reservoir diaphragm holder
3 Brake master cylinder reservoir diaphragm
4 Brake master cylinder
5 Brake master cylinder kit
6 Copper washer
7 Union bolt
8 Brake hose
9 Brake pipe
A
BRAKE FLUID TYPE:
DOT 4
B
BRAKE PAD WEAR LIMIT:
1.0 mm (0.04 in)
C
BRAKE DISC WEAR LIMIT:
3.0 mm (0.12 in)
0 Brake disc
A Caliper bleed screw
B Retaining bolt
C Brake caliper
D Pad shim
E Brake pad
F Piston
G Piston seal
H Brake disc guard
WDD
FW
F
– 23 –
CHAS
FRONT BRAKE
CHAS
CAUTION:
Disc brake components rarely require disassembly. DO NOT:
● Disassemble components unless absolutely necessary.
● Use solvents on internal brake components.
● Use contaminated brake fluid for cleaning. Use only clean brake fluid.
● Allow brake fluid to come in contact with
the eyes, otherwise eye injury may occur.
● Allow brake fluid to contact painted surfaces or plastic parts otherwise damage
may occur.
● Disconnect any hydraulic connection otherwise the entire system must be disassembled, drained, cleaned, and then
properly filled and bled after reassembly.
BRAKE PAD REPLACEMENT
NOTE:
It is not necessary to disassemble the brake
caliper and brake hose to replace the brake
pads.
1.Remove:
● Front wheel
2.Loosen:
● Retaining bolts 1
3.Remove:
● Front brake caliper 2
1
2
4.Remove:
● Retaining bolts 1
– 24 –
FRONT BRAKE
3
2
CHAS
5.Remove:
● Brake pads 1
(with pad shim 2)
● Pad spring 3
1
NOTE:
● When pad replacement is required, also
replace the pad spring and shim.
● Replace the pads as a set if either is found to
be worn to the wear limit a.
Wear limit a:
1.0 mm (0.04 in)
6.Install:
● Pad shim
(onto inside brake pad)
● Pad spring
● Brake pads
*********************************************
Installation steps:
● Connect a suitable hose 1 tightly to the caliper bleed screw 2. Then, place the other
end of this hose into an open container.
● Loosen the caliper bleed screw and push the
pistons into the caliper with the finger.
● Tighten the caliper bleed screw 2.
T.
Caliper bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
R.
● Install
the pad shim 3 (new) onto the brake
pad (new).
NOTE:
The arrow mark a on the pad shim must point
in the direction of the disc rotation.
● Install
the pad spring (new) and brake pads
(new).
*********************************************
– 25 –
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement