PERRIN PSP-ENG-521 Upper Radiator Bracket for WRX & STI Instructions
Perrin PSP-ENG-521 is a radiator stay kit designed for 2012-2016 Subaru WRX vehicles. It includes two radiator stays and two M8 flat head bolts. The kit is made from high-quality materials and is designed to provide additional support to the radiator, preventing it from moving or vibrating excessively. This can help to improve cooling performance and extend the life of the radiator.
The installation process is relatively simple and can be completed in a few steps. First, the hood is raised and the two upper radiator stays are located. The 12mm bolts securing them to the radiator support beam are removed, and the rubber bushings are removed from each OEM radiator stay. The rubber bushings are then installed into the Perrin radiator stays, and the stays are installed using the supplied M8 hardware. The screws are tightened to 12-15 ft-lbs, and some adjustment may be necessary to align the brackets to the car.
Advertisement
Advertisement
08+ WRX Upper Radiator Stay Kit
2012-‐06-‐26
Thank you for purchasing this PERRIN product for your car! Installation of this product should only be performed by persons experienced with installation of aftermarket performance parts and proper operation of high performance vehicles. If vehicle needs to be raised off the ground for installation, the installer must use proper jacks, jack-‐stands and/or a professional vehicle hoist for safety of the installer and to protect property. If the vehicle is lifted improperly, serious injury or death may occur! Please read through all instructions before performing any portion of installation. If you have any questions, please contact our tech department prior to starting installation. We can be reached in any of the following methods:
Email [email protected]
Instant Chat off the main page of www.PERRINperformance.com
Or simply call our tech team at 503-‐693-‐1702
Parts Included with the PERRIN Radiator Stay Kit:
•
(2) PERRIN Radiator Stay
•
(2) M8 Flat Head Bolts
INSTALLATION
1) Raise hood and locate (2) upper radiator stays located above radiator.
2) Remove 12mm bolts securing them to radiator support beam/core support.
3) Remove rubber bushing from each OEM radiator stay. NOTE: A small amount of lube will help remove these.
4) Install rubber bushings into PERRIN Radiator stays making sure to put thicker part on bottom (away from logo).
5) Using supplied M8 hardware, install screws through PERRIN Radiator Stays and tighten to 12-‐15ft-‐lbs. (some adjustment may be necessary to align brackets to car.
Questions, Comments and Suggestions Contact: [email protected]
Visit Our Website for Instant Chat Options at www.PERRINperformance.com
Call Our Tech Team at 503-‐693-‐1702

Public link updated
The public link to your chat has been updated.
Advertisement