Dormakaba Mullions Installation instructions

INSTALLATION INSTRUCTIONS

KEY REMOVABLE MULLION-EL

(From power source)

Butt connectors

(supplied by installer)

Wire connector 24" in length with plugs

(4) wires

Top fitting assembly

Butt connectors

(supplied by installer)

(Wire to strike to be supplied by installer)

KR mullion tube

Cut supplied connector lead in half.

Attach on end using butt connectors or solder and tape to wires coming from strike up through mullion tube.

Insert other lead through top fitting as shown and attach to wires coming through frame using butt connectors or solder and tape.

Carefully install mullion tube over top fitting while pushing extra wire and plug connector downward into top of mullion tube.

NOTE: Deburr any area where holes were drilled in frame and mullion tube.

( 1/2” Dia. Hole to be drilled in frame for wires by installer. Deburr after drilling, install rubber grommet if available.)

Approx. 1/2”

Soffit

(Hole to be drilled for strike by installer see strike template.)

Bottom fitting and mounting hardware

Floor

1135-111 95070838 1340EL-1 6/13