User Guide

DANCING WATER SPEAKER
User Guide
SBT626
In the box Pairing the speaker
DANCING WATER SPEAKER
User Guide
SBT626
Dancing Water User Guide
Speaker
EZ he
| ЧЕ Р-Р
£2m2z—— Aa 11m
3.5mm Micro USB
Auxiliary Cable Charging Cable
CHARGING THE SPEAKER
1. Connect the small end of the Micro USB Charging Cable
to the Micro USB DC 5V charging port on the back of
the speaker.
2. Connect the other end of the Micro USB Charging Cable
to the USB port on your computer or other device
made for USB charging.
3.The LED light is RED when charging. It will shut off when
the speaker is fully charged.
Micro USB
Charging Port
HE |
q a
Micro USB
Charging Cable
Computer
Speaker
Location of Controls
(\ Dcsv AUXIN ONOFF /
CO) O o
1. Micro USB DC 5V charging port
2. AUX IN jack
3. ON/OFF switch
1. Slide the power switch on the back of the
speaker to the ON position.
2. A tone will be heard, indicating that the
speaker is in pairing mode.
3. Keep the speaker and Bluetooth enabled
device within 3 feet of each other during the
pairing process.
4. Set your Bluetooth enabled device to search
for Bluetooth devices.
On an iPhone
* Go to SETTINGS > BLUETOOTH
(Make sure Bluetooth is turned ON)
Bluetooth
(= \ TI EN
Devices
SBT626 Paired
N
Pairing the speaker
On a Blackberry
* Go to SETTINGS/OPTIONS > BLUETOOTH
* Enable BLUETOOTH
Bluetooth =3G
/ — \ Bluetooth:
Discoverable: Yes -
— | (Add New Device | New Device
COL
0000000
0000000
0000000
О
On an Android Phone
* Go to SETTINGS > BLUETOOTH> MENU
Search for devices (Make sure Bluetooth is
turned ON)
e EE
VE xx Bluetooth
Device name
SBT626
Visible
Search for devices
Bluetooth devices
On other Cell Phones/Devices
- Review the instruction manual that came
with your phone/device.
—
Bluetooth: Enabled
Paired Devices:
*Empty
Searching for devices
bund —
5. When the Bluetooth enabled device finds the
speaker, select “SBT626” from the list of
found devices.
6. If required, enter the password 0000. Select
OK or Yes to pair the two units.
7. After a successful registration, a beep will be
heard.
NOTE: If you would like to connect the speaker
to another device, you must unpair the speaker
from the currently paired device first. On your
device's Bluetooth settings, select “SBT626”,
then select “unpair”. When the speaker has
been unpaired, it automatically goes into
pairing mode again.
Using the Speaker
Powering ON/OFF
e Slide the power switch on the back of the
speaker to the ON or OFF position.
e Check that your Bluetooth features are turned
ON. If you have already paired the speaker with a
Bluetooth enabled device, it will automatically
connect.
* |f you are using the speaker for the first time, go
to the "PAIRING THE SPEAKER" section of this
User Manual, and pair the speaker to your
desired Bluetooth device.
Playing Music
To enjoy wireless music on your Bluetooth
Speaker, make sure you are connected to a
Bluetooth enabled device. Once connected
press PLAY on your Bluetooth device. When
playback has begun, control the music with
your connected device (that has the AVRCP
Bluetooth profile).
NOTE: To enable the dancing water feature, you
must turn up the volume of your connected
device.
Using as a Wired Speaker
1. Turn ON the speaker.
2. Connect one end of the included 3.5mm
auxiliary cable to the AUX IN jack on the
speaker and the other end to an external
device's headphone jack (smartphone, tablet,
or MP3 player).
3. Open a media player on your device and click
on PLAY to start playing your music.
4. Use the controls on your connected device to
control music playback and volume.
Troubleshooting Tips
Troubleshooting Tips
1. Make sure your Bluetooth device supports
A2DP profile.
2. Turn up the volume on your Bluetooth device.
3. You may have to unpair the speaker, then
re-pair to your device.
1. Make sure the Bluetooth Speaker is turned ON
before beginning the pairing process.
2. Keep your Bluetooth Speaker and Bluetooth
enabled device within 3 feet of each other during
the pairing process.
3. The speaker will emit a tone to indicate that it is in
pairing mode.
4. Check that YOUR device's Bluetooth feature is
turned ON.
5. Try repeating the pairing process, see “Pairing the
speaker.”
1. Make sure the Bluetooth Speaker is turned ON
before beginning the pairing process.
2. The speaker will emit a tone indicating that itis in
pairing mode.
Legal information
Caution: Any changes or modifications not expressly
approved could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
« Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and
receiver.
* Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician
for help.
Limited Warranty
90 Days Limited Warranty
In the unlikely event that this product is defective, or does
not perform properly, you may within ninety (90) days from
your original date of purchase return it to the authorized
service center for repair or exchange.
TO OBTAIN WARRANTY SERVICE:
e Call the Customer Support number located below, or go
to our website portal to receive an SRO number.
e Provide proof of the date of purchase within the package
(Dated bill of sale).
e Prepay all shipping costs to the authorized service center,
and remember to insure your return.
e Include a return shipping address (no P.O. Boxes), a
telephone contact number, and the defective unit within
the package.
e Describe the defect or reason you are returning the
product.
Your product will be repaired or replaced, at our option, for
the same or similar model of equal value if examination by
the service center determines this product is defective.
Products received damaged as a result of shipping will
require you to file a claim with the carrier.
The shipping address of the authorized service center is:
<= Southern Telecom, Inc.
Attention: Customer Service (2nd Floor)
14-C 53rd Street
Should you have any questions or problems concerning this
product, please contact our customer service department at:
Customer Support:
@ Phone: 1-877-768-8481
Monday-Friday 8AM-10PM(EST)
E www.southerntelecom.com
Click on “Product Support”
Warranty service not provided
This warranty does not cover damage resulting from
accident, misuse, abuse, improper installation or operation,
lack of reasonable care, and unauthorized modification. This
warranty is voided in the event any unauthorized person
opens, alters or repairs this product. All products being
returned to the authorized service center for repair must be
suitably packaged.
Limitation of Warranty:
« THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY
APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE) ARE HEREBY DISCLAIMED. NO VERBAL OR
WRITTEN INFORMATION GIVEN BY AIT, INC. ITS AGENTS, OR
EMPLOYEES SHALL CREATE A GUARANTY OR IN ANY WAY
INCREASE THE SCOPE OF THIS WARRANTY.
* REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS
WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER.
AIT, INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSE-
QUENTIAL DAMAGES RESULTING FROM THE USE OF THIS
PRODUCT OR ARISING OUT OF ANY BREACH OF ANY
EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. THIS
DISCLAIMER OF WARRANTIES AND LIMITED WARRANTY ARE
GOVERNED BY THE LAWS OF THE STATE OF NEW YORK.
EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW,
ANY IMPLIED WARRANTY OF MERCHANTIBILITY OR FITNESS
FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED
TO THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE.
Some states do not allow the exclusion nor limitation of
incidental or consequential damages, or limations on how
long an implied warranty lasts so the above limitations on
exclusions may not apply to you. This warranty gives you
specific legal rights, and you also may have other rights that
vary from state to state.
Sharper Image® name and logo are registered trademarks. Manufactured
and marketed by Southern Telecom under license. © Sharper Image.
All Rights Reserved.