Havis PT-A-103 2015-2022 Ford Transit Rear permanent step assembly Installation Instructions
Advertisement
Advertisement
INSTALLATION INSTRUCTIONS
PT-A-103
2015-2022 FORD TRANSIT REAR STEP INSTALL
TOOLS REQUIRED:
Standard wrench set
Metric and Standard socket set
Ratchet
Impact Gun
HARDWARE:
QTY DESCRIPTION
4
4
4
1
1
2
4
Driver side main bracket
Passenger side main bracket
Channel support
1/2" Nylock nut
4 1/2"x 3.5” Bolt
16 1/2" Washer
1/2” Nut
1/2"x 1.5” Bolt
1/2" Split lock washer
PART#
ST006595-DS
ST006595-PS
ST01012
GSM30020
GSM33055
GSM31009
GSM30011
GSM31030
GSM33050
Always
!
Read all instructions before installing any Havis, Inc. products.
Check for obstructions (Wires, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
PT-A-103_INST_2-22
PT-A-103 Step Assembly
Channel supports
(ST01012)
Passenger side main bracket
(ST006595-PS)
Driver side main bracket
(ST006595-DS)
PT-A-103_INST_2-22
On the driver side remove the two bolts located on the inside of the rear frame rail. Keep bolts for reinstall in the next step.
Remove the two bolts shown in the picture and install the Main bracket using the four (4) removed factory bolts.
On the passenger side you may need to temporarily remove the rear heat shield mounting rivet. Reattach shield after bracket is in place.
Repeat the mounting procedure for the driver side bracket
Determine the height you want to set the rear step and insert two (2) 1/2"x
1.5” bolts, (4) 1/2" washers, and (2) nylock nuts.
Repeat process for driver side and make sure channel supports are level and even.
Loosen the eight (8) 1/4" nylock nuts from the step assembly and slide the step onto the previously install channel supports using four (4) 1/2"x
3.5” bolts, (8) 1/2" washers and four
(4) 1/2" nylock nuts .
Tighten all hardware and check to make sure the step is even and level.
Installation is now complete
PT-A-103_INST_2-22

Public link updated
The public link to your chat has been updated.
Advertisement