INSTRUCTION
MANUAL
VACUUM CLEANER
Ñ
N
y
Vit,
S
S
AS
à
=
PLEASE READ THE MANUAL CAREFULLY BEFORE USING AND
ence, the product is subject to the real object.
KEEP IT PROPERLY FOR FUTURE USE
330200LNP |
All the product images in this manual are just for your refer-
SAFETY DIRECTION
1. For the first operation, it is advisable to read
the manual carefully before hand and keep it
properly for future use.
2. Before the first operation, make sure the dust
cup Is properly installed.
3. Make sure the power supply is 220-240V 50Hz.
4.Do not vacuum water and inflammable
material.
5. Do not vacuum burning material and ashes.
6. Do not use the machine without a motor
protection filter filled.
7. Please change the dust cup/HEPA immediately
when It is damaged.
8. Do not store or use the machine close to high
temperature places.
9. Do not let children use the machine in case of
any danger.
10.If abnormal noise, smell, smoke or any other
failure or breakage was found during the
operation, you should turn off the switch and
unp ug it. Then contact with your service
center for repair. Do not repair it by yourself.
11.1 the supply cord is damaged, it must be
replaced by the manufactures or its service
agent or a similarly qualified person in order to
avoid a hazard.
12.This appliance can be used by children
GB-01
aged from 8 years and above and
persons with reduced physical, sensory or
mental capabilities or lack of experience and
knowledge if they have been given supervision or
instruction concerning use of the appliance in a
safe way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be
made by children without supervision.
PRODUCT STRUCTURE DIAGRAM
y
@ N
Two in
one brush
Extending
metal tube
— Handle
- Release button
Hose Power button
Cord rewind
button
Brush tool Air Outlet
Plate
Big wheel
Hose connector Dust cup
GB-02
SPECIFICATIONS
Model No. 330200LNP
Voltage 220-240V ~
Frequency 50/60Hz
Power 700W
HOW TO USE
ASSEMBLY BEFORE USE
Fig.1 shows the connection of the hose
and the vacuum cleaner:
Put the hose connector in front of
the vacuum cleaner .Then insert it
into the inlet hole and turn right. If
you want to disassemble it, you can
turn the hose connection left and
then pull it out.
Fig.2 shows the connection of the hose (— N
and the extending metal tube: a
Hold the flexural connector of the
hose and put it into the bigger hole
of the tube.
/
Г
Fig.3 shows the connection of the tube (— à
and the brush tool:
Put the metal tube into the hole of
the brush and rotate it to fasten
them.
GB-03
Fig.4 shows how to check the winding of
the power cord.
You can pull the power cord out of
the machine and stop it when you
see the yellow mark. Make sure the
red mark is not out. When your
sweep is over, firstly turn off the
power, pull the plug out of the
socket, and then push the winding
device button until the cord is
completely in the machine.
Fig.5 shows the power button
Put the plug into the socket, push
the power button to control the
work of the machine.
CLEANING OF THE DUST CHAMBER
THE STEPS OF THE CHAMBER CLEANING:
1. As in Fig.6, hold the dust chamber 2. As in Fig.7, take the dust chamber
and handle and push the release out of the machine.
button.
GB-04
м N
Fig.9
2
y
3. As in Fig.8, put the dust chamber
onto the rubbish bin, push the
release button to open the
bottom of the dust chamber, and
the dirt and dust will fall into the
bin by themself.
ATTACHMENTS
HOW TO USE THE ATTACHMENTS:
Ne y,
4. As in Fig.9, shut up the dust
chamber for a circular use after your
cleaning.
Г Fig.10 à
NE у
1. As in 19.10, you can use the
compressed brush in the corner and
the aperture.
Ne
2. As in fig.11, open the other side
with bristles of the compressed
brush as the mark of an arrow to
clean the sofa, the curtain and the
dust on the ornaments.
GB-05
à à
Fig.12 Fig.13
N <
Ne Ne
3. As in fig.12, tread on the pedal of 4. As in fig.13 , tread on the pedal of
the brush tool to let the bristles out, the brush tool again to put the
and you can clean the floor. bristles in, and you can clean the
carpet.
MAINTENANCE
HOW TO MAINTAIN
1.The filter should be cleaned twice a year, and when there is obvious dirt on the
1.The filter should be cleaned twice a year, and when there is obvious dirt on
the filter, itis the time.
2.You must fix the filter properly before running the vacuum cleaner.
3.The filter can't be cleaned in the washing machine or baked by the blower.
4.It will reduce the suction power and damge the motor if you use the wet filter.
5.Steps for maintenance:
Г an
Mm
В И
[UOUUGUEL
10 UU)
Ne DIN y,
(1) As in fig.14, press the outlet lock (2) As in fig.15, get out the outlet
to open the outlet board. filter.
GB-06
| IO | ns
Е
NE
(3) As т fig.16, rotate the HEPA (4) Asin fig.17, get the HEPA
cover to separate it from the cover
chamber cover
a à
NE NE y,
(5 ) As in fig.18, If you have any hair (6) As in fig.19, get the HEPA and
winding removable cleaning. wash it.
(7) Wash the HEPA cover, the HEPA assembly, the outlet sponge and the dust
chamber in the water without detergent and dry them before use.
(8) Fix the HEPA assembly on the chamber cover and make sure three salient
cubes should be stuck in the grooves of the dust chamber.
(9) Rotate the HEPA assembly in the direction of the mark on the chamber
cover.
(10) Assemble the chamber cover assembly and the dust chamber according to
the mark outside.
GB-07
N
N 7 E (11) As in fig.20, hit the
AD 2 E filter rack with your
№ 7) hand slightly.
7
DINA >
“ = 7 y “7 |
O AS )
(12) Put the dust chamber assembly into the machine. And in this process, first
you should make the chamber in the right position and then press the
handle of the dust chamber, if there is a cluck it means the operation is
successful.
CORRECT DISPOSAL OF THIS PRODUCT
return and collection systems or contact the retailer where
the product was purchased. They can take this product for
environmental safe recycling.
This marking indicates that this product should not be
disposed with other household wastes throughout the EU.
To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the
fp
WARRANTY: 2 YEARS
GB-08
AIGOSTAR INTERNATIONAL LIMITED
UNIT 4 TEES VALLEY COURT GLENARM ROAD
WYNYARD TS22 5FE GB
GB311003583
HTTP://WWW.AIGOSTAR.COM
MADE IN P.R.C
">
