INSTRUCTION 5
MAN UAL qigosear
VACUUM CLEANER
PLEASE READ THE MANUAL CAREFULLY BEFORE OPERATING THIS
M O D E L 3 3 0 2 OOYWT | PRODUCT AND RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
IMPORTANT SAFEGUARDS
1.Read the manual carefully before using this
appliance for the first time and retain it for
future use.
2.Before using this appliance for the first
time, make sure that the dust chamber is
properly installed.
3.Do not vacuum water or any inflammable
materials.
4.Do not vacuum burning materials and ash.
5.Do not use the machine unless a motor
protection filter is fitted.
6.Change the dust chamber/HEPA
immediately if damaged.
7.Do not store or use the machine close to
hot places.
8.Do not allow children to use the machine to
protect against risk.
9.1f any abnormal noise, smell, smoke or any
other failure or breakage occurs during the
operation, you should turn off the switch
and unplug the appliance, then contact
your service centre for repair. Do not repair
the appliance by yourself.
GB-01
10.1 the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in
order to protect against risk.
11.This appliance can be used by children
aged 8 and above and persons with
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
Supervision or instruction concerning its
safe use and understand the hazards
involved. Do not let children play with the
appliance. Children should not clean the
appliance or carry out user maintenance
without supervision.
GB-02
SPECIFICATION
Model No. 330200YWT
Voltage 220-240V ~
Frequency 50-60Hz
Power 700W
Dust Chamber 1.5L
PRODUCT DIAGRAM
1. Brush tool 7. Back wheel
2. Extending tube 8. Back wheel rubber rim
3. Dust chamber 9. Power button
4. Hose connector 10. Hose
5. Compressed brush 11. Cord winding button
o 6. Dust chamber release button 12. Dust chamber and handle D
GB-03
PRODUCT ASSEMBLY AND USE
1. Connecting the hose to the dust chamber:
e Insert the hose into the hose connector at the front of the dust chamber and
turn to the right. To remove the hose, turn the hose connector to the left and
pull it out.
2. Connecting the hose and the extending tube: а N
| Slide button
«Insert the hose connector into the large hole
in the tube until fastened in place. To
disassemble, pull the connector out.
Slide button: The suction and inner vacuum
power can be controlled by opening or
closing the slide. For instance, if you find the
resistance is too high when using the floor
brush, open the slide. This decreases the CT
power of the vacuum and subsequently
makes it easier to move the vacuum head Y,
over the floor.
3. Adjusting the extending tube: а
«Use the adjustment switch to lengthen or
shorten the tube.
GB-04
4. Connecting the tube and the brush м N
and operating the bristles control
pedal:
°e Push the extending tube into the
brush hole and rotate it to fasten.
«When cleaning carpeted floors, lower
the bristles by pushing gently on the
tread pedal with one foot.
«When cleaning hard floors, push on
the tread pedal again to raise the
bristles.
5.Using the compressed brush
e The accessories can be connected to
the tube and hose.
° The compressed brush is mainly used
to clean between narrow gaps. The
narrow aperture will significantly
enhance the vacuum and suction
power.
6.Operating the vacuum cleaner
«Plug the appliance into a power socket that conforms to the label’ $ power
supply guidance, then press the on/off switch and the vacuum cleaner will start
working.
7. Power cable retract
«When operating the appliance, do not pull the power cable out of the vacuum
beyond the yellow mark. If the power cable has been pulled out far enough for
the red mark can be seen, retract some of it.
«When you have completed the cleaning process, turn off the power, unplug the
appliance, and push the power cable retract button until the cord has been fully
retracted back into the machine.
GB-05
CLEANING AND MAINTENANCE
CLEANING THE DUST CHAMBER
Step 1. Hold the dust chamber and handle and press the release button. Remove
the dust chamber from the machine.
и
N
\ У
Step 2. Hold the dust chamber above the rubbish bin, press the dust release
button to open the bottom of the chamber, and the dirt and dust will fall into
the bin. Then close the dust chamber.
O — >
GENERAL MAINTENANCE
Note:
«The filter should be cleaned twice a year, whenever dirt can be clearly seen.
Failure to clean the filter will cause reduction in suction power and abnormal
sounds.
«You must fix the filter properly before using the vacuum cleaner.
«Do not clean the filter in the washing machine or baked by the blower. Doing so
will reduce the suction power, and using a wet filter will damage the motor.
GB-06
To clean the outlet filter:
e Press the outlet lock to open the outlet flap, take out the outlet filter and wash it
with water.
y
To clean the HEPA filter:
¢ Rotate the HEPA accessory to separate it from the chamber cover, then take it
out.
4 | №
FE ©: /
Ne y
¢ Wash the central HEPA, the HEPA frame and the duct chamber under running
water without detergent and dry them before use. Fix the HEPA frame on the
central HEPA.
4 à
a —
GB-07
e Rotate the central HEPA onto the chamber cover. Assemble the chamber
cover accessory to the dust chamber, lining up the marks on the outside.
N
y
e Insert the dust chamber into the appliance, ensuring it is in the right position.
Push the handle of the dust chamber until you hear a click.
STORAGE
¢ When not in use, the appliance should
be stored in a cool, dry location away
from direct sunlight.
e The floor brush can be stored at the
back of the appliance to save space.
DISPOSAL
This symbol indicates that this product should not be disposed of
with other forms of household waste. To prevent possible harm to
the environment or human health from uncontrolled waste
disposal and to promote the sustainable reuse of material
resources, recycle this appliance responsibly. To return your used
Lo device, please use the return and collection systems or contact the
retailer from which the product was purchased. The retailer can
subsequently ensure the product is recycled in an environmentally
safe manner.
WARRANTY: TWO YEARS
GB-08
AIGOSTAR INTERNATIONAL LIMITED
Unit 4 Tees Valley Court Glenarm Road
Wynyard TS22 5FE GB
GB311003583
HTTP://WWW.AIGOSTAR.COM
MADE IN P.R.C
">
