Onn 12 Series Glass Screen Protector User Guide
Advertisement
Advertisement
Cleaning
Remove the case from your device to avoid interference with application.
Clean the Screen
01
Clean the device screen with the wet wipe.
Application Tray
Apply the Tray
04
Snap the orange application tray over the front of your device.
Tip: Be sure the edge labeled “Top” is at the top of your device.
Glass Screen Protector with Built-in
Microbial Protection
Quick Start Guide
Dry the Screen
Dry with the microfiber cloth. Ensure the screen is completely dry before proceeding.
Remove Dust
Use the dust removal sticker to remove any fine particles from the device screen.
02
03
Screen Protector
Application
Remove Safety Film
Using the tab labeled “1-Back”, peel away to expose the adhesive, removing completely.
Note: Do not touch adhesive on the glass.
05
1 BACK continued on the back
Place the Screen Protector
06
With the adhesive facing your device place the screen protector down into the tray. Align the top edge of the glass and allow the glass to position itself into the tray.
Final Steps
Remove the Tray
Carefully remove the application tray.
08
Attach the Screen Protector
07
Press firmly down along the center to adhere the screen protector.
Remove Air Bubbles
09
If there are any air bubbles, remove them by starting from the center and pushing firmly outward toward the edges.
Note: Small bubbles may dissipate over the next 48 hours.

Public link updated
The public link to your chat has been updated.
Advertisement