Advertisement
Advertisement
HEADLINER
Removal and Installation
HEADLINER
To ESM
1.
Headliner
4.
Sunvisor holder
2.
Sunvisor (LH)
5.
Room lamp (with map lamp function)
3.
Sunvisor (RH)
6.
Assist grip (passenger seat)
MIIB9100E
REMOVAL
1.
Remove front pillar garnish. Refer to EI-19, “BODY SIDE TRIM” in EI section on ESM.
2.
Remove back door weatherstrip.
3.
Remove luggage side upper finishers (LH/RH). Refer to EI-26, “LUGGAGE FLOOR TRIM” in EI section on ESM.
4.
Remove center pillar upper garnish (5-door vehicles) and lock pillar upper garnish (3-door vehicles). Refer to EI-19, “BODY SIDE TRIM” in EI section on ESM.
5.
Remove assist grip.
NOTE:
When removing assist grip, insert a thin screwdriver, etc., into the clip and move the clip outside.
MIIB0078E
6.
Remove sunvisors (LH/RH).
7.
Remove room lamp (with map lamp function). Refer to LT-229, “Removal and Installation” in LT section on
ESM.
EI-1
HEADLINER
8.
Remove sunvisor holder.
NOTE:
Insert a screwdriver into the cutout and rotate 90
° to remove.
9.
Remove vehicle rear clips.
10. Peel off headliner adhesive and remove headliner from back door opening.
CAUTION:
The roof panel could be deformed, so do not strongly pull the headliner.
INSTALLATION
1.
Remove any adhesive left on the vehicle side.
2.
Apply adhesive to headliner.
Adhesive:
Yokohama Rubber Hammer Tight
YM-21
SIIA0224J
MIIB0079E
3.
Move front seats (LH/RH) toward front of vehicle, and fix headrests (LH/RH) in top position.
4.
Place the headliner front section on the headrest and fasten the headliner rear section with the clips.
5.
After installing sunvisor holder, install in the reverse order of removal.
EI-2
MIIB0080E
MIIB0081E

Public link updated
The public link to your chat has been updated.
Advertisement