PixController Raptor Wireless Camera System User’s Manual

The Raptor Wireless Camera System is designed to capture images and send them to you via the cellular network or Wi-Fi. With its built-in motion sensor, it captures color photos during the day and IR stealth photos at night. The system can be set up for 24-hour activity, day only, or night only, and you can also schedule blocks of time when the system will not take trigger events. Images can be attached to an email or saved to the USB Flash Drive, and the system also includes a rechargeable 12V battery and charger.

PDF Download
Document
PixController Raptor Wireless Camera System User's Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Cellular or Wi-Fi connectivity
  • Built-in motion sensor
  • Color photos during the day and IR stealth photos at night
  • USB Flash Drive for image storage
  • Rechargeable 12V battery and charger
  • Scheduling options for activity periods
  • Optional wireless motion sensor for covert setup
  • Time-lapse mode
  • Daily text status email of battery life

Frequently asked questions

The system captures images when motion is detected by the built-in sensor or wireless sensor. Photos are then sent to you via the cellular network or Wi-Fi. You can also configure the system to capture photos at specific intervals using the time-lapse mode.

The system captures color photos during the day and IR stealth photos at night. The IR stealth photos are black and white and are taken using infrared light, which is invisible to the human eye.

The battery life depends on the number of photos taken, but typically lasts several months on a single charge. There is an external charging port for solar panels or external batteries to extend field battery life.

Yes, you can use the system without cellular coverage. If you select the “None” option in the Trigger E-Mail Format, the Raptor System will not attempt to send any data via the cellular radio. Photos will be stored to the USB Flash Drive only.

Yes, you can use the “Use Schedule Grid” setting in the Schedule Tab to setup blocks of time where the Raptor System will not take trigger events. This is very useful when setting the Raptor System up in a work place setting where you want the Raptor System to be inactive during work hours.
Preparing document for printing…
0%