Belnick WL-3958SYG-BK-GG Assembly Instructions

Thank you for your purchase !

Mid-Back Designer Back

Swivel Task Chair with

Fabric Seat

ASSEMBLY INSTRUCTIONS

Before You Begin:

Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching during assembly.

Caution:

Tighten all components securely before use. Failure to do so may result in personal injury.

DO NOT use any sharp objects to open plastic wrapped components as damage to product or componenets may result.

Warning:

CHOKING HAZARD - Small Parts. Adult Assembly Required.

Injury may result from tipping furniture. You must install the Tipping Restraint Hardware with the unit to prevent the unit from tipping and causing any accidental injury, instability, death or damage. The tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.

This tipping restraint is not an earthquake restraint. If you wish to add the extra security of earthquake restraints, they must be purchased and installed separately.

Serious or fatal crushing injuries can occur from furniture tipping over. To prevent furniture from tipping over it must be permanently fixed to the wall. Fixing devices for the wall are not included since different wall materials require different types of fixing devices. Use fixing devices suitable for the walls in your home.

Failure to detach this restraint before moving furniture may result in injury or damage.

DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE

Customer Service email: [email protected] | phone: 866-552-2810

WL-3958SYG-BK-GG

PARTS LISTING

A B C D E

7PCS

OPTIONAL a

H

4PCS

I

3PCS b

J

1PC

K

1PC

F G

1PC 5PCS

STEP 1

6PCS 2PCS

STEP 2

1PC 1PC

STEP 3 STEP 4

OPTIONAL a

1 2 b

1

E

K

J

2

ASSEMBLY NOTES:

During assembly, hand tighten screws only. When all screws are in place, you may then tighten all screws completely.

CAUTION: 1.Do not use this chair as a step ladder.

2.Check for loose screws and tighten them anytime.

Made and printed in Taiwan.

Thank you for your purchase !