Advertisement
Advertisement
ZN-PTZW36VN
Quick Installation Guide
This manual provides instructions for quick installation and basic configuration of your IP device.
Step1. Connect cables to IP device
Connect the power cable and LAN cable to the device. To see the correct positions of all connectors, refer to the following image below.
Network/
POE Port
Reset
Button
Power Input
(AC24V or
DC12V)
( i
Note
The power input is not polarity sensitive.
EC75 Ver1.2
1
* Models herein and their appearance are subject to change without any prior notice.
Step 2. Install IP device
1) Place the installation template that is provided in the package on the desired position of installation.
2) Attach the waterproof protection pad on the bottom plate of the device.
3) Drill four holes on the template and insert anchor blocks into the holes.
Fasten the camera housing with screws.
4) Make sure the cables are properly connected to the camera.
5) Adjust the lens position by referring to the Step 3 .
6) Put the dome cover on the main body of the camera. Make sure the main body and the cover fit each other into place.
7) Fasten the cover with screws.
!
Caution
EC75 Ver1.2
When assembling the main body of the camera and its dome cover, make sure they fit each other into place.
The camera may fall off the ceiling even after the proper installation and mounting.
To prevent any accident, make sure the ceiling is firm and stable enough to support the camera . If any reinforcement is needed, consult with your safety personnel and proceed with the installation.
2
Step3. Adjust the lens focus
1) Remove the dome cover.
2) Manually rotate, pan, and tilt the camera module to the desired position.
2) Uncover the upper shield of the lens and make a rough adjustment of the lens focus by using its focus puller.
Step4. Set up network environment
The default IP address of your IP device is 192.168.XXX.XXX. You can find the available IP address from the
MAC address of your device. Please make sure the device and your PC are on the same network segment before running the installation. If the network segment was different between your PC and the device, change your PC’s settings as below.
IP address : 192.168.xxx.xxx
Subnet mask: 255.255.0.0
EC75 Ver1.2
3
Step5. View video on web page
View the live video on a web page using your IP device and its IP address. To have the correct IP address ready and use it on a web page:
1.
Convert a MAC address to an IP address. Refer to the Hexadecimal-Decimal Conversion Chart at the end of this manual.
(The MAC address is attached on the side or bottom of the device.)
MAC address = 00-13-23-01-14-B1 → IP address = 192.168.20.177
Convert the Hexadecimal number to Decimal number.
2.
Open a web browser and enter the IP address of the device.
3.
Click pop-up blocked and install the ActiveX setup.exe by clicking the Run or Save button. You need to install the ActiveX for displaying the images.
4.
Follow the instructions of the dialog boxes and complete the installation. Then the live video is displayed on the main page of the web browser.
5.
If the live video is not displayed with the message said, “This software requires the Microsoft XML Parser
V6 or higher. Please download MSXML6 from the Microsoft website to continue. Error code: Can not create
XMLDOMDocument.” , please download and install the relevant MSXML.
* The explanation and captured images on this manual are mainly on the basis of Internet Explorer 7.0.
EC75 Ver1.2
4
Step6. Set up IP Address
To set up the Network configuration:
1.
Click Setup on the upper right of the web page. The login page is displayed as below.
2.
Enter the default user name (root) and password (pass), and then select OK .
The default username and password are: root and pass .
3.
Click System Options on the left of the Setup page, and then select TCP/IP from the drop-down menu.
4.
Input the data for the IP address configuration, and click the Apply button on the bottom of the page.
To change the IP address, please make sure to check and have the correct Subnet mask and Gateway ready. To use DHCP, select Obtain an IP address via DHCP .
To learn how to set up the web page for advanced configuration, refer to the Web Page User's Manual, which is available on the SDK at the following path.
{SDK root}\DOC\
EC75 Ver1.2
5
Advanced setup (IPAdminTool)
IPAdminTool is a utility program for IP products. The following lists a part of features that IPAdminTool provides.
Configure IP address, subnet mask, and gateway
Show network related information such as MAC address
Update firmware
Reboot the device
IPAdminTool is provided with SDK at the following SDK path.
{SDK root}\BIN\TOOLS\AdminTool\
Rebooting
Perform the following procedures to reset your device:
1.
While the device is in use, press and hold the Reset.
2.
Release the Reset button after 3 seconds.
3.
Wait for the system to reboot.
Resetting to the Factory Default Settings
If you reset your device to the factory default setting, all parameters including the IP address will be initialized.
For the Factory Default reset:
1.
Disconnect the power supply from the device.
2.
Connect the power to the device with the Reset button pressed and held.
3.
Release the Reset button after 5 seconds.
4.
Wait for the system to reboot.
More Information
To learn more about using other features of your devices, refer to the manual, which is available on the SDK at the following path.
{SDK root}\DOC\
EC75 Ver1.2
6
Hexadecimal-Decimal Conversion Table
Refer to the following table when you convert the MAC address of your device to IP address.
Hex Dec Hex Dec Hex Dec Hex Dec
00
01
02
03
04
05
06
07
08
09
8
9
0A 10
0B 11
0C 12
0D 13
0E 14
0F 15
10 16
11 17
12 18
13 19
14 20
15 21
0
1
2
3
4
5
6
7
16 22
17 23
18 24
19 25
1A 26
1B 27
1C 28
1D 29
1E 30
1F 31
20
21
22
23
24
25
26
27
28
29
2A
2B
3B
32
33
34
35
36
37
38
39
40
41
42
43
2C 44
2D 45
2E 46
2F 47
30 48
31
32
33
34
35
36
37
38
39 57
3A 58
3C
3D
3E
3F
49
50
51
52
53
54
55
56
59
60
61
62
63
40
41
42
43
44
45
46
47
48
49
4A
4B
4C 76
4D 77
4E
4F 79
50 80
51
52
53
54
55
56
57
58
5C
5D
5E
5F
64
65
66
67
68
69
70
71
72
73
74
75
78
81
82
83
84
85
86
87
88
59 89
5A 90
5B 91
92
93
94
95
60 96
61 97
62 98
63 99
64 100
65 101
66 102
67 103
68 104
69 105
6A 106
6B 107
6C 108
6D 109
6E 110
6F 111
70 112
71 113
72 114
73 115
74 116
75 117
76 118
77 119
78 120
79 121
7A 122
7B 123
7C 124
7D 125
7E 126
7F 127
EC75 Ver1.2
7
Hex Dec
80 128
81 129
82 130
83 131
84 132
85 133
86 134
87 135
88 136
89 137
8A 138
8B 139
8C 140
8D 141
8E 142
8F 143
90 144
91 145
92 146
93 147
94 148
95 149
96 150
97 151
98 152
99 153
9A 154
9B 155
9C 156
9D 157
9E 158
9F 159
Hex Dec
AD 173
AE 174
AF 175
B0 176
B1 177
B2 178
B3 179
B4 180
B5 181
B6 182
B7 183
B8 184
B9 185
BA 186
BB 187
BC 188
BD 189
BE 190
BF 191
A0 160
A1 161
A2 162
A3 163
A4 164
A5 165
A6 166
A7 167
A8 168
A9 169
AA 170
AB 171
AC 172
Hex Dec
C0 192
C1 193
C2 194
C3 195
C4 196
C5 197
C6 198
C7 199
C8 200
C9 201
CA 202
CB 203
CC 204
CD 205
CE 206
CF 207
D0 208
D1 209
D2 210
D3 211
D4 212
D5 213
D6 214
D7 215
D8 216
D9 217
DA 218
DB 219
DC 220
DD 221
DE 222
DF 223
Hex Dec
E0 224
E1 225
E2 226
E3 227
E4 228
E5 229
E6 230
E7 231
E8 232
E9 233
EA 234
EB 235
EC 236
ED 237
EE 238
EF 239
F0 240
F1 241
F2 242
F3 243
F4 244
F5 245
F6 246
F7 247
F8 248
F9 249
FA 250
FB 251
FC 252
FD 253
FE 254
FF 255
EC75 Ver1.2
8

Public link updated
The public link to your chat has been updated.
Advertisement