EWHA8,14*1C,2C
With FLEXI-GUARD
®
Installation/Care/Use Manual
USES HFC-134A REFRIGERANT
SEE FIG. 4
29
22, 23,
24, & 25
44, 45
27, 28,
42, & 43
34
46
26
7
35 (SEE FIG. 3)
SEE FIG. 5
30
17, 18,
19, & 20
15 & 16
21
47
13
33 (SEE PAGE 3)
31 & 32
14
FIG. 1
PAGE 1 97053C (Rev. B - 3/98)
EWHA8,14*1C,2C
40" (1016mm) RECOMMENDED HEIGHT FOR HAUTEUR RECOMMANDÉE POUR LE 33" (838mm) RECOMMENDED HEIGHT FOR CHILDREN NIÑOS 33" (838 mm) HAUTEUR RECOMMANDÉE POUR LES ENFANTS 33" (838mm)
CABLE ELÉCTRICO DE 4 PIE (1219mm), DE LARGO CORDON DALIMENT
97053C (Rev. B - 3/98) PAGE 2
PISO ACABADO PLANCHER FINI
LEGEND/LEYENDA/LÉGENDE A
PURGADOR DE 1¼ NO PROPORCIONADO SIPHON 1-1/4 NON FOURNI UBICACIÓN DE LA TOMA DE ELECTRICIDAD EMPLACEMENT DE LA PRISE DE COURANT
EWHA8,14*1C,2C
SERVICING THE HOT CONTROL AND FUSE ASSEMBLY
1. A temperature sensing non-resetable fuse in the wire is located approximately 3" (76mm) from the thermostat.
The fuse is located under the retaining bracket (Item 3) in the groove on the heater element jacket (Item 4).
2. The thermostat must be used with a washer-spacer (Item 7) and be centered in the heater element jacket for
proper temperature control. Locate the heater element jacket about 3/4" (19mm) above the bottom of the tank.
3. The heater element jacket must be fastened VERY TIGHTLY to the tank (45+/-10 inch/lbs. of torque on the mounting
screw Item 9). Failure to TIGHTEN heater element jacket may cause rapid failure of the fuse assembly.
5
4
12
13
7
8
2
1
11
9
10
3
6
Stream height is factory set at 35 PSI. If supply pressure varies greatly from this, remove Items 1 & 2 and adjust screw on
Item 4. Clockwise adjustment will raise stream and counterclockwise adjustment will lower stream. For best adjustment, stream should hit basin approximately 6-1/2" (165mm) from bubbler.
1
2
3
4
5
BASIN
6
ITEM NO.
9
10
11
12
13
NS
7
8
5
6
3
4
1
2
HOT TANK PARTS LIST
PART. NO.
22111C
22112C
22113C
30980C
31386C
31428C
50787C
70606C
70607C
70640C
70659C
70683C
70793C
22588C
DESCRIPTION
Heater Clamping Bracket
Heater Clamping Bracket (thrd)
Retaining Bracket
Heater Element & Jacket
Tank & Tube Assy
Hot Control Assy
Washer-Spacer
Drain Plug
Screw 1/4-20 x 3.00" HSHC
Screw #8-18 x 5/16" HHTC
Belleville Washer
1/4 Union
1/4 Elbow
Hot Tank Mounting Bracket
8
9
10
11
BASIN
12
NOTE:
WHEN INSTALLING REPLACEMENT
BUBBLER AND PEDESTAL, TIGHTEN
NUT (ITEM 12) ONLY TO HOLD
PARTS SNUG IN POSITION.
DO NOT OVER TIGHTEN.
FIG. 4
WIRING DIAGRAM
This Drawing is merely for illustrating the components of the electrical system.
FIG. 5
36 37
39
41
38
40
PAGE 3
FIG. 3
97053C (Rev. B - 3/98)
42
43
44
45
38
39
40
41
46
47
34
35
36
37
30
31
32
33
PARTS LIST 115V
ITEM NO.
PART NO.
DESCRIPTION
24
25
26
27
28
29
16
17
18
19
20
21
13
14
15
9
10
11
12
7
8
5
6
3
4
1
2
22*
23
21516C
31490C
30664C
20239C
70018C
66201C
66202C
35787C
35762C
31034C
31027C
35766C
194243901550
55996C
45694C
55909C
40089C
40048C
15005C
61313C
40169C
50986C
21541C
51349C
40322C
50934C
50168C
70012C
31513C
31494C
66431C
66417C
66255C
66229C
66421C
21591C
30010C
31397C
55832C
40583C
40597C
92712C
51543C
40596C
70921C
33659000
50368C
70750C
70767C
70772C
70682C
70683C
Cover
Button
Regulator Retaining Nut
Regulator
Hex Nut
Regulator Holder
Basin
Bubbler Assy
Orifice Assy
Housing Assy
Pedestal
Bubbler Locknut
Cold Control
Power Cord
Condenser (8 GPH)
Condenser (14 GPH)
Fan Shroud
Fan Motor
Fan Blade
Fan Bracket
Fan Blade Nut
Drier (8 GPH)
Drier (14 GPH)
Compressor Serv. Pak 8 GPH
Compressor Serv. Pak 14 GPH
Overload/Relay Assy (8 GPH)
Overload/Relay Assy (14 GPH)
Relay Cover
Electrical Shield
Strainer
Precooler
Tailpipe Helix
Heat Exchanger (8 GPH)
Heat Exchanger (14 GPH)
Evaporator
Hot Tank Switch Bracket
Hot Tank Switch
Hot Tank Assy
Flow Regulator Assy
Hot Valve Assy
Gooseneck
Hot Valve Kit
Handle
Shroud
Mounting Nut
Body Gasket
Receptor-Drain
Clamp-Hose
Evaporator Retaining Clip
Evaporator Drain Plug
Tee - 1/4 x 1/4 x 1/4
Union - 1/4
EWHA8,14*1C,2C
ITEM NO.
14
17
22*
23
24
29
33
220/240v 50/60 Hz
PART. NO.
31496C
31430C
35789C
35764C
31036C
31028C
35768C
66452C
31398C
DESCRIPTION
Power Cord (8 & 14 GPH)
Fan Motor (8 & 14 GPH)
Compressor Serv. Pak (8 GPH)
Compressor Serv. Pak (14 GPH)
Overload/Relay Assy (8 GPH)
Overload/Relay Assy (14 GPH)
Relay Cover (14 GPH)
Heat Exchanger (8 GPH)
Hot Tank Assy (8 & 14 GPH)
*INCLUDES RELAY & OVERLOAD. IF UNDER WARRANTY, REPLACE
WITH SAME COMPRESSOR USED IN ORIGINAL ASSEMBLY.
NOTE: All correspondence pertaining to any of the above water coolers or orders for repair parts MUST include Model No. and Serial No. of cooler, name and part number of replacement part.
COLOR
TABLE
Gray Beige
Almond
Stainless Steel
Sandalwood
Granite
LEFT
PANEL
20638C
21464C
20640C
21462C
27171C
RIGHT
PANEL
21526C
21530C
21527C
21528C
27192C
FRONT
PANEL
20675C
20676C
20672C
21454C
27150C
PRINTED IN U.S.A.
97053C (Rev. B - 3/98)
www.DrinkingFountainDoctor.com 800-518-5388
PAGE 4
