User Manual Microphone Headset Model: SY-CM2PC Welcome Congratulations on the purchase of your new Microphone Headset SY-CM2PC. We hope you enjoy your new product thoroughly. Please read the instructions below carefully and always store in a safe place for future reference. Warning Headset Speaker diameter: 40mm Frequency Response: 20Hz - 20 KHz Rating Power: 30mW Power Capability: 40mW Impedance: 32ohm ±15% (1 KHz) Cable length: ~ 2.2m Jack: 3.5mm Microphone Sensitivity: -52dB ± 3dB Impedance: 2.2kΩ Frequency response range: 50Hz to 16,000 Hz Jack: 3.5mm Warning The prolonged use of earphones or headphones at loud volume levels may cause permanent hearing damage. Do not use the headphones while driving or cycling for safety. Do not apply weight or pressure on the headphones. How to Use the SY-CM2PC Adjust the head band into a suitable size to fit the users head. Place the headphones over your head according to the markings on the sides - R on your right ear and L on your left ear. Connect the headphone to the computer by inserting the microphone jack (orange) into the microphone slot on your computer/laptop, and the Headphone jack (green) into the headphone slot on your computer/laptop. To adjust the volume to a comfortable level use the volume control button located on the cable. Precaution Clean the headphones with a soft dry cloth Always keep the jacks clean and free from dust. Don’t expose the headphones to direct sunlight, heat, and moisture. If for any reasons you feel uneasy, drowsy or experience a headache, immediately stop using the headphones.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project