HDMI Converter Series
User Manual
Model : HD01
HDMI to DVI & Audio Converter
Smart Cabling & Transmission Corp.
V1.0_1612011
Panel View
User Manual
HD01
Introduction
HD01 is an HDMI to DVI with audio converter that can choose either a coaxial S/PDIF connector or a
3.5mm phone jack as an audio output. It's a cost-saving solution that can display your video and audio source on a LCD monitor and external speakers at the lowest cost.
0
Features
Converts HDMI to DVI with audio
Resolution up to 1080p for HDMI, 1920 x 1200 for DVI.
Built-in coaxial S/PDIF for digital audio, and 3.5mm phone jack for analog audio.
Supports EDID management.
Installation View
1
User Manual
HD01
Dip Switch Setting
MODE: 2-level dip switch for audio settings
1 ON: 2 channel Analog Audio output
2 ON: 2 channel / 5.1 channels SPDIF output
OFF: No audio output
LED Status Indicator
[HDMI] − lights up means the HDMI device is connected
[Power] − lights up means the DC power is connected
Remark
1.
SPDIF format is dependent upon the embedded digital audio part in the input HDMI stream. The
SPDIF receiver must be able to recognize the input SPDIF format. Our device only separates the digital audio in HDMI stream, and bypasses this decoded audio to the output.
2.
Analog audio only support 2 channels, there is no output when the source is AC3/DTS multi channel audio.
3.
EDID: Extended display identification data is a data structure provided by a computer display to describe its capabilities to a graphics card. It is what enables a modern personal computer to know what kind of monitor is connected
Trouble Shooting
1.
Only HDMI enabled TV sets with underscan/overscan* support, the full active video can be accurately displayed. Some HDMI equipped TV sets may not support this feature. If underscan/overscan* is NOT supported, the top, bottom, left and right border of the active video may be screened, and the S/PDIF audio may not sound right.
2.
S/PDIF audio input can support up to 6-channel audio input. If your TV not supports Dolby Digital or dts audio decoding, then you will add audio decoder or amplifier.
3.
S/PDIF supports only 48 KHz audio sample rate. Other than this rate, the input digital audio should be adjusted to 48 KHz in order to get audio signal correctly sent.
2
Specification
ITEM NO.
Support
Compliance
Max. Video Resolution
Video Bandwidth
Ports & Interfaces
Video Input
Video Output
Audio Interface
Power
Power Supply
Power Consumption
Ambient Temperature
Operation
Storage
Humidity
Physical Characteristics
Dimensions
Weight
HD01
HDMI 1.3, HDCP
1080p/ 1920x1200
1.65Gbps
1 x HDMI Type A
1 x HDMI Type A, 1 x DVI-I 29 pin Female
1 x Coax SPDIF, 1 x (3.5mm) Phone Jack
DC 5V 1A
440mA (Max)
0 to 55 ℃
-20 to 85 ℃
Up to 95%
88 x 95 x 30mm
190g
User Manual
HD01
3
