Graco 309541D, Hour Meter Kit 246013 Owner's Manual

Add to my manuals
2 Pages

advertisement

Graco 309541D, Hour Meter Kit 246013 Owner's Manual | Manualzz

Operation

Hour Meter Kit 246013

3000 psi (22.7 MPa, 227 bar) Maximum Working Pressure

Important Safety Instructions

Read all warnings and instructions in the

Operation manual. Save these instructions.

309541D

EN

WARNING

ELECTRIC SHOCK HAZARD

This equipment must be grounded. Improper grounding, setup, or usage of the system can cause electric shock.

• Turn off and disconnect power at main switch before disconnecting any cables and before servicing or installing equipment.

• Connect only to grounded power source.

• All electrical wiring must be done by a qualified electrician and comply with all local codes and regulations.

Resetting the Hour Meter

The Hour Meter display flashes after 40 hours of motor run time (the average pump life). The flashing display signals the user that the pump should be repaired (see Pump Repair manual). After the pump has been repaired, reset the

Hour Meter.

Original Version

Touch and hold tip of reset tool (supplied) to indicated meter reset area until display stops flashing and “SVC” indicator disappears.

Original Version

New Version

Insert small wire (or paper clip) into hole in front of meter and hold until motor resets (approximately 3 seconds).

NOTE: The number of hours displayed is cumulative and will not reset to 0 (zero).

New Version

After 40 hours of use the Hour Meter will flash again to remind the user to replace the pump packings.

Graco Information

For the latest information about Graco products, visit www.graco.com

.

For patent information, see www.graco.com/patents .

TO PLACE AN ORDER, contact your Graco distributor or call 1-800-690-2894 to identify the nearest distributor.

All written and visual data contained in this document reflects the latest product information available at the time of publication.

Graco reserves the right to make changes at any time without notice.

For patent information, see www.graco.com/patents.

Original instructions. This manual contains English. MM 309541

Graco Headquarters: Minneapolis

International Offices: Belgium, China, Japan, Korea

GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA

Copyright 2008, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.

www.graco.com

Revision D, January 2015

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement