Aiphone PS-POE Install Manual
Advertisement
Advertisement
PS-POE
PoE Splitter
-INSTRUCTIONS-
The PS-POE is a PoE splitter that provides a 24V DC output to power the strobe light in Aiphone’s wall boxes and towers. The IX Series emergency stations have a secondary PoE output (pass-through) that can be used to connect to this splitter. The PoE pass-through will only be usable if the IX station is connected and powered via a PoE+ switch.
WIRING
Drawing not to scale
Wall Box
PS-POE
Mount the PS-POE to the studs on the back of the IX station using the top or bottom holes. Ensure that the RJ45 jack is facing down when mounted.
The middle holes on the PS-POE can be used to mount to a standard 1-gang provision.
Mounting hardware not included.
Strobe Trigger Wire
Brown & Red from
CN1 (Relay 1) 2
Strobe
Power Wires
PS-POE 1
PoE IN
- +
PoE+ Switch
Cat-5e / Cat-6
IX-RA (Back View)
Cat-5e / Cat-6
1 Connect the ground terminal to an Earth ground.
2 Relay 1 must be enabled during the station programming process.
SPECIFICATIONS
Power:
Power consumption:
Output power:
Operating Temperature:
PoE (803.2af)
8.4W
24V DC, 350mA
-40° ~ 140° F (-40° ~ 60°C)
Mounting: Secure to mounting studs on back of IX station or secure to a
1-gang
41 ⁄
16 box.
" H x 29 ⁄
16
" W x 1-⅛" D
Aiphone Corporation www.aiphone.com
800-692-0200
PS-POE Instr
0619JD

Public link updated
The public link to your chat has been updated.
Advertisement