Geberit AquaClean 4000 Quick Manual
Advertisement
Advertisement
Geberit AquaClean 4000
Cleaning instructions for end users
Permissible cleaning agents and cleaning equipment
Non-permissible cleaning agents and cleaning equipment
965.475.00.0 (01)
Quick guide
Geberit AquaClean 4000 integrated control panel
<Shower>, start and stop
Press the button: The spray arm moves into position and the shower procedure starts. The shower automatically stops after 20 s.
You can stop the shower before this by pressing the <shower> button.
Press the button again: The shower stops.
<Spray intensity>
Press <+> or <-> during the shower procedure to change the spray intensity.
There are 5 spray intensity levels to choose from.
The memory function stores the most recently set spray intensity.
<Water heater function> ON/OFF/economy mode
Pressing the button switches the water heater function on, off or to economy mode.
Care and cleaning
Permissible cleaning agents and cleaning equipment
Cleaning agents are permitted to have a low acid content; e.g. they may contain citric acid.
Cleaning agents should ideally be diluted with water.
Cleaning agents must be fluid.
Cleaning agents must be dermatologically tested.
The use of foaming cleaning agents is permitted.
Non-permissible cleaning agents and cleaning equipment
The use of powdery cleaning agents, such as scouring powder or scouring agent, is not permitted.
The use of corrosive cleaning agents, such as concentrated drain cleaners, is not permitted.
The use of cleaning agents which may irritate the eyes or the skin is not permitted.
The use of cleaning agents with a high chlorine concentration is not permitted.
The use of abrasive cleaning agents, such as sand or scouring liquid, is not permitted.
Please refer to chapter "Care and cleaning" of these operating instructions for more information about cleaning and care of the Geberit AquaClean 4000.

Public link updated
The public link to your chat has been updated.
Advertisement