DoorHan SWM Installation Manual
DoorHan SWM key-button is designed to send control commands to the operator's control unit. It features two microswitches enabling different control signals (open/close). The key-button has a mechanical interlock for secure installation and removal of the cover. It's suitable for various applications where controlled access or operation is required.
Advertisement
Advertisement
ИНСТРУКЦИЯ ПО МОНТАЖУ
И ЭКСПЛУАТАЦИИ
КЛЮЧ-КНОПКИ SWM
1. НАЗНАЧЕНИЕ
Ключ-кнопка SWM используется для подачи управляющей команды на блок управления приводом. Наличие двух микропереключателей позволяет посылать два различных управляющих сигнала
(открыть/закрыть). Для подачи команды поверните ключ, управляющий контактами микропереключателей.
Отпустите ключ - он вернется в первоначальную позицию.
2. ТЕХНИЧЕСКИЕ ХАРАКТЕРИСТИКИ
Тип контакта
Количество контактов
Питание
Степень защиты
Установка
Диапазон рабочих температур
NO/NC
2
10 A/220 В
IP 54
Накладной монтаж
-40 °С ... +50 °С
3. МОНТАЖ
Кнопки SWM имеют механическую блокировку, которая не позволяет устанавливать или вынимать крышку из корпуса без установленного и повернутого ключа. Для того чтобы открыть корпус, открутите винт крепления передней панели, поверните ключ и выньте панель из корпуса.
Установите резиновую прокладку для герметизации задней стенки корпуса. Проведите кабель и закрепите корпус кнопки, используя поставляемые шурупы и дюбели. Для надежного подсоединения кабелей используйте поставляемые клеммные обжимы. Подсоедините NO_контакты выключателя к соответствующим клеммам блока управления.
4. ПОДКЛЮЧЕНИЕ
Подсоедините необходимые провода к клеммному блоку микропереключателя.
1 – СОМ контакт,
2 – NO контакт,
3 – NC контакт.
Компания “DoorHan” благодарит Вас за приобретение нашей продукции. Мы надеемся, что Вы останетесь довольны качеством данного изделия. По вопросам приобретения, дистрибьюции и технического обслуживания обращайтесь в офисы региональных представителей или центральный офис компании по адресу:
Россия, 143002 Московская обл., Одинцовский район, с. Акулово, ул. Новая, д. 120
Тел: +7 (495) 933–2400, 981–1133
E-mail: [email protected]
www.doorhan.ru
INSTALLATION MANUAL
SWM
EC DECLARATION OF CONFORMITY
We: DoorHan Europe s.r.o.
Bozeny Nemcove 1689, 43201 Kadan, Ceska Respublika Herewith declare under sole responsibility that:
• Declares that:
The device model keyswitch SWM
• complies with the essential safety requirements of the following directives:
73/23/EEC and subsequent amendment 93/68/EEC
89/336/EEC and subsequent amendment 92/31/EEC and
Additional note:
93/68/EEC
These products have undergone tests in a typical uniform configuration
(all products manufactured by DoorHan Europe s.r.o.)
01/03/2010 Mikhail Kiselev Managing Director
Date signature
1. DESCRIPTION
The key-button SWM is used to give a control command to the control unit of the operator. Two micro-switches enable sending two different signals (open/close). To give a command you should turn the key, which controls the contacts of the microswitches.
Release the key and it will return in the original position.
2. TECHNICAL SPECIFICATIONS
Contact type
Amount of contacts
Power supply
Ingress protection rating
Installation
Working temperature range
NO/NC
2
10 A/220 В
IP 54
Накладной монтаж
-40 °С ... +50 °С
3. INSTALLATION
The key-switch SWM have a mechanical interlock, which does not allow to install or remove the cover from the casing, if the key has been not installed and turned. To open the casing, you should unscrew the front panel fastening, turn the key and take the panel out of the casing.
Install the rubber seal for closure of the casing’s back wall. Lay the cable and secure the casing of the button, using supplied screw nails and dowels. For reliable connection of the cables you should use the supplied clamps. Connect the NO contacts of the switch to the appropriate terminals of the control unit.
4. CONNECTION
Connect the necessary wires to the terminal block of the microswitch.
1 – СОМ contact,
2 – NO contact,
3 – NC contact.
open close motor

Public link updated
The public link to your chat has been updated.
Advertisement