COMMERCIAL GRADE, ULTRA EFFICIENT VACUUMING SYSTEM

USER GUIDE

Congratulations on purchasing a Bennett Read

Stealth vacuum cleaner.

This product is packed with the power and technology to provide fast, quiet and efficient cleaning. It is manufactured to the highest quality and is backed by a one year guarantee by Tevo.

Should you need any support from us, please visit: www.tevo.co.za or call 0861 77 88 88.

2

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS

BEFORE USING YOUR VACUUM.

When using your Stealth, basic safety precautions should be observed, including the following:

!

WARNING

TO REDUCE THE RISK OF FIRE,

ELECTRIC SHOCK, OR INJURY:

» Use the system only for its intended use

» To protect against a risk of electric shock, do not immerse any part of the system in water or other liquids

» Do not allow cord to touch hot surfaces

» Do not run appliance over cord

» Do not operate the system with a damaged cord or plug, or if the appliance or any other part of the system has been dropped or damaged. To avoid the risk of electric shock, do not disassemble or attempt to repair the Stealth. Return the unit for examination and repair. Incorrect reassembly or repair can cause a risk of electrical shock or injury and will not be covered by the guarantee

» Keep hair, loose clothing, fingers and all parts of body away from openings and moving parts

» Do not use to pick up any liquids including but not limited to flammable or combustible liquids such as gasoline or use in areas where they may be present

» Do not pick up anything that is burning or smoking such as cigarettes, matches or hot ashes

» Use extra care when cleaning on stairs

» Do not use the Stealth without the filters in place (Refer to page x for operating instructions)

» Follow all user instructions in this manual

» Do not leave the Stealth plugged in when unattended

» Unplug the electrical cord when not in use and before servicing

» Not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge

» Do not allow to be used as a toy

» Close attention is necessary when used near children, pets or plants

» Children should be supervised to ensure that they do not play with the appliance

» Use only as described in this manual. Use only manufacturer’s recommended accessories

» Do not pull cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners.

» Turn off all controls as applicable before unplugging from electrical outlet

» Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord

» Do not handle plug or vacuum with wet hands or operate without shoes

» Do not put any objects into openings.

» Do not use with any opening blocked

» Keep free of dust, lint, hair and anything else that may reduce airflow

» Store your Stealth indoors in a cool, dry area

» Keep your work area well lit

» Keep end of hose, wands and other openings away from your face and body

» Using improper voltage may result in damage to the motor and possible injury to the user.

Correct voltage is listed on rating label. For operation on a 220-240V, 50/60Hz power supply only

» Use only identical replacement parts

» See instructions for Servicing of

Double-Insulated Appliances

WARNING:

» To reduce the risk of injury from moving

parts – Unplug before servicing

» To reduce the risk of electric shock –

Unplug before cleaning or servicing

» Do not use outdoors

SAVE THESE INSTRUCTIONS

FOR FUTURE USE.

The Stealth is NOT a Wet & Dry vacuum cleaner. It is NOT designed for WET Vacuuming

3

PRODUCT VIEW

1. On/off Switch

2. Vacuum Function Hose Port

3. Flex Hose

4. Securing Clips

5. Motor Unit

6. Dirt Tank

7. Automatic Cord Rewind Button

8. Large Rear Wheels

9. Front Castor Wheels

10. Microparticle Filter

11. Crevice Tool

12. Dusting Brush

13. Rear Storage Caddy

14. High Efficiency Multi Surface

Vacuum Nozzle

(Dry Vacuuming Only)

15. Metal Telescopic Extension Wand

16. Carry Handle

14

1

15

7

5

2

6

4

3

8

9

16

10

12

11

13

ASSEMBLY INSTRUCTIONS:

Your Bennett Read Stealth will need some assembly, please read and follow the below instructions carefully:

Note: you will need a Phillips screwdriver to complete the assembly

1. Remove unit from packaging

2. Remove attachments from their packaging

3. Some of the packaging poses a choking risk to small children. Dispose of the packaging responsibly. Recycle if possible

4. Before using for the first time check that all attachments listed are included.

If the unit is incomplete, return to the retailer immediately. Take entire unit, packaging and proof of purchase to the store where your purchase was made

5. Remove the Motor unit (5) from the Dirt tank (6) by loosening the Securing

Clips (4). Pull Securing Clips (4) outwards to release

6. Turn the Dirt Tank (6) upside down

4

7. Insert the front caster wheels (9) at the bottom of the Dirt Tank (4) into the holes provided, ensuring wheel is fully inserted

[see picture below]

[Repeat for both front wheels]

8. Install Rear wheel assembly by screwing in as shown below:

Front Caster Wheels Rear Wheels

Note: The Wheels are marked 1 and 2

1 being left side and 2 being right side

9. Turn the Dirt Tank [4] onto its wheels

10.Your Stealth is now ready to be set up for your desired application.

OPERATIONS

Only operate your Bennett Read Stealth in accordance with the instruction manual. Failure to follow these instructions will result in decreased cleaning performance and may invalidate your guarantee.

Important: The Bennett Read Stealth is only suitable for DRY Vacuuming and must NOT be used to vacuum any liquids

5

DRY VACUUMING:

Your Bennett Read Stealth Vacuum is perfect for vacuuming a variety of surfaces including carpets, tiles, mattresses, upholstery, curtains, car upholstery etc.

Setting up your Bennett Read Stealth for vacuuming:

1. Remove the Motor Unit (5) from the Dirt Tank (6) by pulling the Securing Clips (4) outwards

2. Ensure that the Microparticle dust bag and Dome Filter are securely installed in place as shown below:

3. Ensure that the Premotor Foam Filter is installed as shown below:

4. Replace Motor Unit (5) and close Securing Clips (4) by pushing inwards as shown on the right:

5. Insert large end (opposite end to handle) of the Flex Hose (3) into Vacuum Function Hose

Port (2) until you hear a “click”

6. Attach the Metal Extension Wand (15) to the free end of Flex Hose Handle

7. Attach your choice of cleaning head (14)/ (11)/ (12), to the free end of the Extension Wand

8. Plug the Power Cable into the wall socket. Take care not to pull the Power Cable beyond the yellow and red markers at the end of the cord as shown below

9. To retract the Power Cord, press down on the Automatic Cord Rewind Button (7) until the cord has completly retracted

10. Switch on the unit by pressing down on the Power Switch (1). An LED light above the

Power Switch will indicate when the machine is plugged in and ready for use

TIP: Vacuum in different directions across your surfaces to give you best results

6

Important: After each Vacuuming session it is advisable that:

• The dust bag be emptied before storing

• All filters to be checked and cleaned if needed

This will ensure that the unit continues to deliver outstanding performance time & again

MAINTENANCE AND CARE

Note: Your Stealth is equipped with a Thermal cut-off switch that is designed to protect the motor from overheating. Should the machine switch off while working, unplug and check the filters and dust bag. Clean as explained below. Your machine will be ready for use again as soon as it has cooled down. See Troubleshooting Guide for more information.

CLEANING THE FILTERS:

1. Disconnect the Flex Hose (3) from the

Dirt Tank (6) by pressing down on the securing tab and then pulling the hose outward

2. Take the unit to the disposal area

3. Unclip and lift the Motor Unit (5) from the

Dirt Tank (6) and place on the ground

4. Remove the Dome Filter and Filter Bag

5. Unzip and empty the Filter Bag as shown

6. Close the Zip when you are done emptying the bag

7. Check and clean the Dome Filter by gently brushing or tapping

8. Wipe the inside of the Dirt Tank (6) with a damp cloth

9. Return the Filter Bag and Dome Filter to the Dirt Tank

10. To remove the Premotor Foam Filter, turn the cage clockwise and pull outward. Remove and clean the Foam Filter. Return the Foam Filter to the machine and re-install the cage by turning it anticlockwise

11. Replace Motor Unit (6) as explained in the previous section

12. Open and remove the Microparticle Filter (10) as shown below:

13. Tap the Microparticle Filter on the side of a dustbin to remove any dirt or dust.

A soft brush can also be used

TIP: You can also use compressed air to remove dust and dirt from the filters

It is necessary to clean the filter after every use / daily

Washing the Filters:

• All filters in your Stealth are also fully washable in warm water. You may use a mild detergent

• Ensure to rinse the filters thoroughly to remove any detergent residue

• Allow the filters to dry completely before re-installing into the machine (5)

• Replacement filters and bags are available from most major retail outlets or directly from Tevo

• Reassemble and store, ready to use!

Important: Never use or store the machine with wet filters!

7

TROUBLESHOOTING

PROBLEM

Machine not switching on

POSSIBLE CAUSES

1. Power cord not firmly plugged in

or not switched on at wall socket

REMEDIES

1. Check electrical plug

1. Filter/Bag dirty or full Remove and clean all filters as explained on page 7. It is important to check and clean filters regularly

Weak suction power

2. Obstruction in Flex Hose,

Vacuum Nozzle or Extension

Pipes

2. Remove Flex Hose,

Nozzle and Extension

Pipes as explained on page 5.

Clean and check for any obstructions

Visible dust escaping from the machine while vacuuming

1. Filters/Dust Bag not installed

2. Filter/Dust bag dirty or Full

1. Check that all Filters and Bag are installed as explained in this

User Guide

1. Clean all filters and bag as explained on page 7

1. Filters Dirty or Dust Bag full 1. Clean or replace the filters as explained in previous section

Machine switches off during operation

– Thermal Cut-off switch

2. Obstruction in Flex

Hose/extension tubes

2. Check and clean Flex

Hose/Extension Tubes

The machine will only switch on again after it has cooled down sufficiently. Permanent damage will be caused to your machine if you continue to use the machine without addressing the root cause of the overheating as explained above.

Other maintenance or service not included in the manual should be performed by an authorized Tevo service representative.

For any questions or concerns, contact customer care listed on page 9.

8

CONSUMER GUARANTEE

The Bennett Read Stealth has a one year product guarantee from Tevo (Pty)

Ltd. In the event of the unit malfunctioning, Tevo will replace or repair, at

Tevo’s option, any faulty component, free of charge from the date of purchase by the original purchaser for one year. This guarantee does not apply to routine maintenance components such as filters and brushes. Damage or malfunction caused by negligence, abuse, unauthorized repair, or use not in accordance with the User Guide is not covered. Tevo is not liable for incidental or consequential damages of any nature associated with the use of this product. Tevo’s liability will not exceed the purchase price of this product.

Guarantee and Service enquiries can be made by contacting:

Tevo (Pty) Ltd

Gauteng 086 111 8386

Durban (031) 570 5900

Cape Town (021) 380 0038/9

Customer Service Help Line 0861 77 88 88 www.tevo.co.za

TECHNICAL SPECIFICATIONS:

Nominal voltage: 220-240 V AC Nominal frequency:

50/60 Hz Rated Power Output : 800 W

Dirt Tank Capacity : 15 Liters

9

COMMERCIAL GRADE, ULTRA EFFICIENT VACUUMING SYSTEM

Brought to you by:

0861 77 88 88 www.tevo.co.za | [email protected]