CleanStar LIL' RIPPER, VRIP Instruction Manual

Instruction Manual

LIL' RIPPER

10 LITRE

WET & DRY VACUUM CLEANER & BLOWER

Model: VRIP

●

Please read this Instruction Manual carefully before operation and follow all guidelines before using this vacuum cleaner.

●

Please keep this Manual for future reference.

1

SAFETY DIRECTIONS

IMPORTANT MESSSAGE

When using an electrical appliance, basic precaution should always be followed including the following:

READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER

WARNING

To reduce the risk of fire, electric shock, or injury:

• Do not use outdoors.

• Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing.

• Do not allow to be used as a toy. Close attention is necessary when used by or near children.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

• Use only as this manual describes. Use only manufacturer's recommended attachments.

• Do not use with damaged power cord or plug.

• Do not pull or carry by cord, use a cord as a handle, twist or pull cord around sharp edges and corners.

Do not run this vacuum over cord. Keep the cord away from heated surfaces.

• Do not use extension cords or outlets with inadequate current carrying capacity.

• Turn off all controls before unplugging.

• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

• Do not handle plug or vacuum cleaner with wet hands or operate without shoes.

• Do not put any object into openings. Do not use with the opening blocked. Keep the hose free of dust, lint, hair, and anything that may reduce airflow.

• This vacuum cleaner creates suction and contains a revolving brush roll. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.

• Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes.

• Do not use without dust cup or filter in place.

• Use extra care when cleaning on stairs.

• Do not use to pick up flammable or combustible liquids such as gasoline, or use in areas where they may be present.

• Store your cleaner indoors in a cool, dry area.

• Ensure you turn the unit off at the very minimum every 15 minutes (for 1 minute) to let the motor cool down - failure to do so may damage motor.

• Do not use this unit for more than 4 hours (including breaks) on any given day.

2

Attention!!!

• Remove all contents from carton and check each item to the carton content list below.

3

Unpacking and Setup

• Remove the head unit by pulling the lid latched in an outward motion and remove any accessories that may have been shipped in the tank (Figure 1 & 2) .

• Attach the one end of the extension rods to the hose and one end to your desired accessory. Twist slightly to get a tight connection (Figure 3) .

• Attach castor wheels by doing the following:

Turn the tank upside down so the bottom is facing up.

Install castor wheels into dolly by inserting castor stems into the holes provided, make sure the

castor snaps into place.

The castor wheels will swivel easily when the positioning is correct (Figure 4) .

Return your tank back to the upright position.

4

Dry Vacuuming Operation -

Installing the foam filter, reusable dry cloth filter and disposable vacuum bag

• Install the foam filter and reusable dry cloth filter to pick up dust and dry material only. If the foam filter has been used to pick up liquids, the foam filter must be cleaned and dried before installing for dry pick up use.

• Turn the head unit to an upside down position, slide the foam filter down over the cage pulling until the foam filter completely covers the cage (Figure 5) .

• Slide the cloth filter down over the foam filter pulling until the cloth filter completely covers the cage (Figure 6) .

WARNING: BE SURE THE REUSABLE DRY CLOTH FILTER COMPLETELY COVERS THE FOAM

FILTER. CHECK TO ENSURE THAT ALLEDGES OF THE REUSABLE DRY FILTER ARE SECURE

UNDER THE MOUNTING RING

• Slide the mounting ring down over the cloth filter until the mounting ring is positioned as close to the top of the cage as possible (Figure 7) .

WARNING: ENSURE THAT THE MOUNTING RING IS COMPLETELY SECURE AND IN POSITION BY

PRESSING AROUND THE RING IN SEVERAL PLACES

5

• The reusable cloth dry filter should always be in position over the foam filter for dry vacuumin g unless you use a disposable vacuum bag.

• To remove the filters for cleaning, remove the mounting ring and filter from cage (Figure 8 ) .

• To clean the cloth reusable dry filter, shake off excess dirt and dust or (depending on the condition of the filter) rinse with water. Allow the filter to dry completely and re-instal l.

WARNING: DO NOT MACHINE WASH OR DRY

• To install the disposable vacuum bag simply fit the hole in the template of the vacuum bag over the plastic inlet inside the drum of the vacu um.

Wet Vacuuming Operation

• Start by removing all dry filters (blue cloth filter & disposable bag). The foam filter must be positioned over the cage while vacuuming liquids. When filling the tank several times with liquid, the foam filter will become saturated and misting may appear from the exhaust. If this happens please dry the foam filter to eliminate the misting. After finishing vacuuming up liquid, raise the hose to drain the excess liquid into the tank before turning off.

• The inside of the tank should always be periodically cleaned .

• Steps to clean foam filter after wet vacuuming use :

Always disconnect the power before taking the head off the vacuum.

Remove the foam filter by sliding it off from the cage.

Shake excess dust from foam filter with a rapid up and down movement.

Rinse foam filter under running water.

Gently wring out excess water and allow to dry.

Once dried the foam filter is ready to use again

WARNING: WET VACUUM ACCESORIES SHOULD ALWAYS BE WASHED PERIODICALLY,

ESPECIALLY AFTER PICKING UP WET AND STICKY LIQUID.

6

Emptying Liquid From the Tank

• When you are ready to empty out the liquid in the tank please be sure to:

Disconnect the power by turning off the vacuum and taking the plug from the wall.

Remove the head of the vacuum by unclipping the clips on the tank.

Pick up the tank and pour out the liquid contents in a suitable drain.

Clip the head back on and start using your vacuum again.

Automatic Shut-Off

• When picking up liquids, the vacuum operates with a automatic shut-off. As the level of the liquid you are vacuuming rises, an internal float rises until it seats itself against a seal at the intake of the motor, shutting of suction. When this happens, the motor will develop a higher than normal pitch. Once this happens you must empty out the tank if you would like to continue using your vacuum.

Blower Feature

• This vacuum can be used as a powerful blower. To use your unit as a blower insert your vacuum hose into the top exhaust port (Figure 10) .

WARNING: ALWAYS WEAR EYE PROTECTION TO PREVENT ROCKS OR DEBRIS FROM BEING

BLOWN OR RICOCHETED INTO YOUR EYES OR FACE, WHICH CAN RESULT IN INJURY.

Storage

• Before storing your vacuum away, the tank should always be emptied and cleaned. The power cord should be wound around the housing of the unit to keep it in the best shape possible. The accessories can be stored in their holders on the vacuum. Always dry the inside of the tank prior to storing away.

7

Troubleshooting

Trouble

Suction weakens or cleaner runs hot

Possible Cause

Clogged filter

Air leak

Remedy

Brush dirt from filter. If condition continues, change filter.

Check all fittings for tight fit

(nozzle, hose, etc). Check the head of the vacuum is sealed properly.

Vacuum does not run

Obstruction in hose or nozzle

No electricity

Check nozzle, hose, etc for obstruction, and remove if present.

Make sure electrical outlet has voltage. (a qualified electrician may need to be contacted).

Misting in the exhaust air

Mounting ring falling off

Saturated filter Dry or replace saturated filter with a dry filter.

Foam filter incorrectly positioned Position foam filter on the outside of groove around cage on head.

WARNING: REDUCE THE RISK OF INJURY FROM MOVING PARTS AND / OR ELCTRICAL SHOCK,

TURN POWER SWITCH OFF AND DISCONNECT PLUG FROM ELECTRICAL OUTLET BEFORE

PERFORMING TROUBLESHOOTING CHECKS.

WARNING: IF ANY MOTOR HOUSING PARTS SHOULD BECOME DETACHED OR BROKEN,

EXPOSING THE MOTOR OR ANY OTHER ELECTRICAL COMPONENTS, OPERATION SHOULD BE

DISCONTINUED IMMEDIATLEY. THIS WILL HELP AVOID INJURY OR FURTHER DAMAGE TO THE

VACUUM. REPAIRS MUST BE MADE TO THE VACUUM BEFORE BEING USED AGAIN.

8

Exploded View

9

Cleanstar Pty Ltd

ABN: 51 121 002 104 ACN: 121 002 104

59 Radford Road, Reservoir VICTORIA 3073

Phone: (03) 9460 5655 Fax: (03) 9460 5666

Email: [email protected]

Web: www.cleanstar.com.au

CONDITIONS OF WARRANTY

This document outlines the terms and conditions of warranty for your Cleanstar Product. This is an important document that should be kept with your proof of purchase documents in a safe place for future reference should you require service for your product.

Thank you for purchasing your new Cleanstar 10 Litre Wet ‘n’ Dry Vacuum Cleaner and Blower. We are confident this product will give you trouble-free use and excellent service, provided the operator uses and maintains the product in accordance with the Instruction

Manual. Please read the Instruction Manual carefully before using the product for correct operation and maintenance procedures, and store it in a safe place for future reference.

1. This is a parts and labour warranty against faulty or defective parts, materials or workmanship in manufacturing, when the product is used and operated in accordance with the Instruction Manual.

2. This product carries a 12 month (1 year) warranty period that commences from the original date of purchase by the first user/purchaser, and is not transferable.

3. This warranty only applies to products purchased and used in Australia.

4. At all times during the warranty period, Cleanstar shall, at its sole discretion, determine whether repair, replacement or refund will apply if the product has a valid warranty claim applicable to it.

5. The repair or replacement of the product under this warranty does not extend the original period of warranty.

6. Please note that this warranty will be voided in the following cases (which are not exhaustive) and the warranty does not apply to the cost of replacing any parts of the product resulting from:

• Accidental damage;

• Normal wear and tear;

• Neglect, misuse or physical abuse by the operator, including failure to properly maintain or service;

• Any alterations, modifications or tampering with the product without the prior written consent of Cleanstar;

• Incomplete or improper installation;

• Incorrect, improper or inappropriate operation;

• Insect or vermin infestation;

• Power surges, electrical storm damage or incorrect power supply/voltage;

• Excessive use or use for which this product has not been designed;

• Vacuuming up toner, powders, glass, hazardous, flammable or corrosive materials, plaster dust, concrete dust and other similar building or construction materials;

• Failure to comply with the operating instructions contained in the Manual supplied with the product;

• If the product is rented;

• If the product is used outside of Australia;

10

• If the product was serviced or repaired by anyone other than Cleanstar, or one of Cleanstar’s Authorised Service Agents

(ASA). Cleanstar is unable to accept any responsibility under this warranty for any repair work not carried out by an ASA or from the use of non-genuine parts.

7. This warranty does not cover service calls, travelling time or consumable parts such as belts, dust bags, filters, hose or hose parts, rods and wands, floor tools and accessories, motor brushes and other like consumable items, unless defective in manufacture. In order to prolong the life of accessories and consumables, regular care and maintenance is recommended.

8. Please retain your original proof of purchase which will be required before you can make a claim under this warranty. If proof of purchase cannot be provided at the time of a warranty claim or service, any work carried out on the cleaner is chargeable.

9. Any transportation and delivery costs involved in the repair of defective parts shall be borne by the claimant. In all instances, unless the product is transported by Cleanstar or a Cleanstar authorised representative, the product is transported at the owner’s cost and risk while in transit to and from Cleanstar or its ASA.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benefits conferred by this warranty are in addition to other rights and remedies under law in respect of the product to which this warranty relates.

TO INQUIRE ABOUT MAKING A CLAIM UNDER THIS WARRANTY, PLEASE FOLLOW THESE STEPS: a) carefully check the Instruction Manual and the terms of this warranty; b) have the name and model number of the appliance available; c) have the proof of purchase available (ie. invoice, receipt, etc) showing where the appliance was purchased from and date of purchase; d) call Cleanstar on (03) 9460 5655 to speak to one of our customer service staff.

11